Structural Engineering Commons^™

3d Printing Reinforced Concrete Structures, Bryce Tyler Tafolla

Masters Theses

"This study aims to investigate a 3D printing method to directly incorporate continuous reinforcement into concrete structures. The ability to design and produce complex structures with optimized topographical configuration can be used to reduce potential material waste while maintaining the required structural strength. Furthermore, the ability to actively incorporate reinforcement into printed members substantially reduces potential labor requirements and eliminates the need to set up formwork.

The study began its initial approach with a manual extrusion process containing reinforcement to observe the necessary constraints required to achieve a printing system with this functionality. The second stage of development was designing …

Bridge Resilience Assessment With Inspire Data, Iris Tien, Yijian Zhang

Project RR-1

This project proposed a methodology to assess the impact of corrosion on the performance of bridges. The combined analytical and numerical modeling of shear-critical and lap-spliced columns is detailed, and outcomes are verified with previous experimental test data. The impact of corrosion on risk is assessed through conducting fragility analyses. Results quantify the increase in failure probabilities of these structures, measured by increasing probabilities of exceeding defined damage states, with increasing levels of corrosion. Corrosion is found to have a larger impact on increasing probabilities of exceeding more severe damage states. Twenty percent mass loss of reinforcement increases the probability …

Final Report - Battery-Free Antenna Sensors For Strain And Crack Monitoring Of Bridge Structures, Yang Wang, Dan Li

Project SN-2

This project studies a wireless patch antenna as a novel strain/crack sensing technique for structural health monitoring (SHM). The strain/crack induced resonance frequency shift of the antenna can be wirelessly detected and utilized to estimate the surface strain and crack propagation. However, temperature fluctuation can generate some unwanted changes in resonance frequency and introduce significant noises in measurement. This project studies a thermally stable patch antenna sensor through both numerical simulations and laboratory experiments. Using a substrate material with a steady dielectric constant, a patch antenna sensor is designed to perform reliably under temperature fluctuations. In addition, a dual-mode patch …