Other Civil and Environmental Engineering Commons^™

Life-Cycle Cost Analysis For Radioactive Waste Remediation Alternatives, Thomas P. White, Ronald J. Toland, Dorian Y. Buitrago

Theses and Dissertations

This research has two primary objectives. The first is to develop a generic, interactive, spreadsheet-based life-cycle cost model that uses net present value and risk analysis techniques for cost comparison. The second is to apply the model specifically to the vitrification and cementation methods of waste remediation. By using spreadsheet analysis and graphics capabilities, the model will provide direct and objective comparisons of remediation alternatives. Since vitrification is a new technology, the plant design and operations are conceptual. Therefore, computer simulation and engineering judgement are integral to the vitrification LCC estimate.

Impact Of Erosion, Mass Wasting, And Sedimentation On Human Activities In The Río Grande Basin, Jujuy Province, Argentina, Waldo Chayle, William J. Wayne

Department of Earth and Atmospheric Sciences: Faculty Publications

Nearly all dry mountainous regions are affected by severe erosion, floods, and debris flows during times of intense precipitation. The lithology, geologic structure, and climate in Jujuy Province, Argentina combine to place at serious risk the people who live along the Río Grande, the major river that drains the east side of the Cordillera Oriental and the west side of the Sierras Subandinas. Nearly all precipitation falls during summer (January–March) with little during the remainder of the year; most of the basin is semiarid to arid, although the southern end has a humid subtropical climate. Relief is great, as much …

Solid Waste Disposal Site Characterization Using Non-Intrusive Electromagnetic Survey Techniques And Geostatistics, Gary N. Kuhn, Wayne E. Woldt, David D. Jones, Dennis D. Schulte

Biological Systems Engineering: Papers and Publications

Prior to the research reported in this paper, a site-specific hydrogeologic investigation was developed for a closed solid waste facility in Eastern Nebraska using phased subsurface characterizations. Based on the findings of this prior investigation, a surface based geoelectric survey using electromagnetic induction to measure subsurface conductivity was implemented to delineate the vertical and horizontal extent of buffed waste and subsurface contamination. This technique proved to be a key non-intrusive, cost-effective element in the refinement of the second phase of the hydrogeologic investigation.

Three-dimensional ordinary kriging was used to estimate conductivity values at unsampled locations. These estimates were utilized to …