Civil Engineering Commons^™

Evaluation Of Rapid Setting Cement-Based Materials For Patching And Repair, Amit D. Barde, Swathi Parameswaran, Todd Chariton, W. Jason Weiss, Menashi D. Cohen, Scott Andrew Newbolds

JTRP Technical Reports

The efficient repair and replacement of concrete pavements and bridge decks often requires a rapid setting material that can be placed, cured, and opened to traffic in a relatively short period of time. Frequently, temporary repairs are made using materials that are later found to be incompatible with the existing pavement, structures, and environment. This practice causes these materials to fail prematurely, frequently requiring re-repair. Research is needed to determine which rapid setting repair materials demonstrate the best behavior with rapid strength gain, low potential for cracking, and excellent durability. The objective of this research is to evaluate the performance …

Implementation Of A Non-Metallic Reinforced Bridge Deck, Volume 2: Thayer Road Bridge, Robert J. Frosch, Ali Cihan Pay

JTRP Technical Reports

The primary maintenance problem with bridges in Indiana has been deterioration of the concrete deck which is often related to corrosion of the reinforcing steel. While a corrosion protection system consisting of epoxy-coated reinforcement in combination with 2-1/2 in. of Class C concrete cover has been used in Indiana, research and experience have demonstrated that this system can be compromised. As an alternative solution to the corrosion problem in reinforced concrete, fiber reinforced polymer (FRP) bars which are corrosion resistant can be provided as reinforcement. This research was divided into two phases directed towards the implementation of a nonmetallic reinforced …

Design Methods For The Control Of Restrained Shrinkage Cracking, Robert J. Frosch, Jacob Kenyon Bice, Jared Bruce Erickson

JTRP Technical Reports

Cracking in concrete bridge decks can result in increased susceptibility to deterioration. As cracks provide direct routes for the ingress of deleterious elements to the reinforcement and superstructure, cracking can lead to reduced service lives for bridge structures. Several factors affect the extent of cracks which develop in bridge decks; however, relatively few are within the control of the designer. The objective of this research was to evaluate the influence of design parameters on the performance of bridge decks with respect to cracking and to develop simple design tools that are appropriate for both steel and nonmetallic reinforcement. This research …

Behavior Of Structural Concrete Members Strengthened By Composite Fabrics, Jian Chen

Dissertations

The new technique of using Fiber Reinforced Polymer (FRP) materials to repair and strengthen various concrete members is becoming more and more popular in structural retrofitting field. Among all the confining materials, Carbon Fiber Reinforced Polymer (CFRP) fabric jackets are identified as an effective way to enhance the strength and ductility of concrete members due to its superior mechanical properties. This study investigates the detailed structural behavior of confined concrete members using CFRP fabric jackets by both analytical and experimental approaches.

A series of CFRP wrapped concrete cylinder tests were conducted to study the compressive stress-strain behavior for CFRP confined …

Structural Condition Assessment Of Prestressed Concrete Transit Guideways, Robert Zachary Shmerling

Electronic Theses and Dissertations

Objective condition assessment is essential to make better decisions for safety and serviceability of existing civil infrastructure systems. This study explores the condition of an existing transit guideway system that has been in service for thirty-five years. The structural system is composed of six-span continuous prestressed concrete bridge segments. The overall transit system incorporates a number of continuous bridges which share common design details, geometries, and loading conditions. The original analysis is based on certain simplifying assumptions such as rigid behavior over supports and simplified tendon/concrete/steel plate interaction. The current objective is to conduct a representative study for a more …

Continuity Of Bridges Composed Of Simple-Span Precast Prestressed Concrete Girders Made Continuous, Libin Yin

Dissertations

Bridges composed of simple-span, precast, prestressed concrete girders made continuous via cast-in-place decks and diaphragms are continuous only for live loads and superimposed dead loads. The continuity diaphragms often crack due to time dependent effects in the girders. These cracks not only impair bridge ascetics and durability, but also reduce "degree of continuity". A related issue is that joint construction is time consuming and expensive due to reinforcement congestion. This dissertation presents a series of field tests, analytical studies, and laboratory experiments concerning the design and performance of this type of bridge.

Based on a survey of the state departments …

Interaction Between Micro-Cracking, Cracking, And Reduced Durability Of Concrete: Developing Methods For Considering Cumulative Damage In Life-Cycle Modeling, Zhifu Yang, W. Jason Weiss, J. Olek

JTRP Technical Reports

It is becoming increasingly popular to utilize numerical simulation models to predict the long-term performance of concrete pavements and structures. The majority of these models have been developed using laboratory test data that considers concrete in an uncracked state. While uncracked concrete exists as the best case scenario, frequent cracking occurs in real structures that could have a profound impact on life cycle performance. Cracks from several sources may accumulate and interact thereby accelerating the deterioration of concrete. For example, the distributed cracking caused by freeze/thaw damage can substantially increases the rate of water absorption and reduces the load carrying …

Initial Study For Cost-Effectiveness Of Joint/Crack Sealing, Chuanxin Fang, Khaled A. Galal, David R. Ward, John E. Haddock

JTRP Technical Reports

The sealing and resealing of joints and cracks in PCC, HMA, and composite pavements is assumed to be an important component of pavement maintenance. Recently this practice has been challenged by research indicating that sealing may not be cost-effective. The Indiana Department of Transportation currently spends approximately four million dollars annually to perform joint/crack sealing. The primary objective of the research presented in this report is to investigate the costeffectiveness of joint/crack sealing in relation to pavement performance. The results of a mail survey showed that most states, including Indiana, do not have quantitative justification for sealing policies, nor do …

Design Of Durable Concrete Railroad Crossings, Anthony J. Lamanna, Charles F. Scholer

JTRP Technical Reports

Existing precast concrete railroad crossings in the state of Indiana are experiencing too short a life expectancy. This study proposes methods that can be used to produce durable concrete railroad crossings with satisfactory rideability, durability, and longevity. Thirty-two precast concrete railroad crossings were visited in central and northern Indiana. Failures were determined to belong to three major categories: structural capacity causes, environmental causes, and material property causes. A concrete mix was evaluated at three different polyolefin fiber contents and without fibers. Beams were tested in flexure, and modulus of rupture and first crack deflection were recorded for each beam. Cylinders …

Mid-Panel Cracking Of Portland Cement Concrete Pavements In Indiana, Hung-Ming Chen, Yunus Dere, Elisa D. Sotelino, Graham C. Archer

JTRP Technical Reports

Portland cement concrete slabs are a common form of highway pavements in Indiana. As a result of their widespread use, the economic impact of their maintenance and life span is therefore tremendous. In Indiana, these types of pavements have been experiencing premature random transverse mid-panel cracking. This phenomenon has been observed under a variety of environmental and traffic conditions. Also, it has been found that the cracking occurs in conjunction with the opening of the lanes to traffic, within months of construction. In this project, a research synthesis was carried out to determine exactly what the current state of knowledge …

Influence Of Curing Conditions On Strength Properties And Maturity Development Of Concrete, Scott Andrew Newbolds, Jan Olek

JTRP Technical Reports

In this study, the results of both laboratory studies and a field study, conducted to evaluate the effects of different curing conditions on the strength properties and maturity development of pavement concrete, are presented. Further, a laboratory study was performed to evaluate the maturity concept in relation to the degree of hydration of cement. Concrete specimens, beams and cylinders, were prepared in the field study. The specimens in the field were cured in one of four curing conditions: lime bath, sandpit, air, or by temperature match curing. Specimens were tested for flexural strength and compressive strength, respectively. The temperature of …

Development And Evaluation Of Cement-Based Materials For Repair Of Corrosion-Damaged Reinforced Concrete Slabs, Rongtang Liu, J. Olek

JTRP Technical Reports

In this study, the results of an extensive laboratory investigation conducted to evaluate the properties of concrete mixes used as patching materials to repair reinforced concrete slabs damaged by corrosion are reported. Seven special concrete mixes containing various combinations of chemical or mineral admixtures were developed and used as a patching material to improve the durability of the repaired slabs. Physical and mechanical properties of these mixes, such as compressive strength, static modulus of elasticity, dynamic modulus of elasticity, and shrinkage were evaluated. Durability-related parameters investigated included resistance of concrete to penetration of chloride ions and freeze-thaw resistance. The results …

Performance Of Bridge Decks And Girders With Lightweight Aggregate Concrete, V. 2 Of 2, J. A. Ramirez, J. Olek, Eric Joseph Rolle, Brian Joseph Malone

JTRP Technical Reports

Structural lightweight concrete is a very versatile material and Haydite and Minergy lightweight aggregates can be utilized in the mixture development of concrete for use in girders and decks in bridges. More widespread use of lightweight aggregates (LWA) would result in savings in construction cost due to considerable dead load reduction.

The materials phase of this research study evaluated the fresh concrete properties (slump, unit weight, and air content), the mechanical properties of hardened concrete (compressive strength, tensile strength, flexural strength, static and dynamic modulus of elasticity, Poisson’s Ratio, and temperature development), and durability related parameters (air void distribution, freeze-that …

Performance Of Bridge Decks And Girders With Lightweight Aggregate Concrete, J. A. Ramirez, J. Olek, Eric Joseph Rolle, Brian J. Manlone

JTRP Technical Reports

Structural lightweight concrete is a very versatile material and Haydite and Minergy lightweight aggregates can be utilized in the mixture development of concrete for use in girders and decks in bridges. More widespread use of lightweight aggregates (LWA) would result in savings in construction cost due to considerable dead load reduction. The materials phase of this research study evaluated the fresh concrete properties (slump, unit weight, and air content), the mechanical properties of hardened concrete (compressive strength, tensile strength, flexural strength, static and dynamic modulus of elasticity, Poisson’s Ratio, and temperature development), and durability related parameters (air void distribution, freeze-thaw …

Testing Of Multi-Span Bridges With Full Span Precast Prestressed Concrete Panels (Phase 1), Robert J. Peterman, J. A. Ramirez

JTRP Technical Reports

The purpose of this study was to assess the behavior and durability of multi-span bridges constructed with full-span prestressed concrete form panels. The use of full-span prestressed concrete form panels for bridges with spans of 40 ft. or less is an economical method of construction due to the reduction of on-site formwork and labor required by alternate cast-in-place systems. In this research, a pair of two-span bridges utilizing full-span prestressed concrete form panels were fabricated and tested in the Karl H. Kettelhut Structural Engineering Laboratory at Purdue University. Time-dependent effects were monitored during the cast-in-place (CIP) concrete cure period of …

Knowledge‐Based Expert System For Concrete Mix Design, Yong Bai, Serji N. Amirkhanian

Civil and Environmental Engineering Faculty Research and Publications

In the United States, the American Concrete Institute method (ACI 211) is the most widely used concrete mix design. However, ACI 211 does not consider all factors regarding concrete mix design. The acceptance of a freshly mixed concrete depends on concrete quality control test results. If the results indicate that the concrete does not meet the specification, mix design adjustment must be made. Concrete mix design and adjustment are somewhat complicated and time‐consuming tasks that are performed best by experienced persons. In this project, a rule‐based expert system was developed to assist the user in concrete mix design, including the …

Behavior Of Biaxially Loaded Concrete-Encased Composite Columns, Pedro Ricardo Munoz

Dissertations

The theory of nonlinear behavior of biaxially loaded short and slender composite columns is used to study the load-deformation and moment-curvature of four pin-ended composite column specimens tested under axial compressive load and biaxial bending moments in a single curvature. The accuracy of the test results is verified by comparison with analytical results obtained by a method of analysis that includes the nonlinear material properties of concrete and steel and covers the ascending and descending branches of the linear segmented column specimen. A computational method is presented to model the analytical behavior of the biaxially loaded composite column. Its validity …

Softening Response Of Concrete In Direct Tension, Teresa Cintora

Theses

Due to the increased attention in nonlinear fracture mechanics and numerical methods of cementitious material, it has become necessary to have a reliable investigation of the post-peak softening response of concrete under direct uniaxial loading. But due to the brittleness of the material previous researchers have encountered great difficulty in obtaining complete data regarding the load-deformation behavior. This study uses a strain-controlled testing method and therefore the post-peak curve can be more easily obtained. Based on these results a unique formula for the normalized load vs. deformation curve has been proposed to be applied in fracture analysis applications.

Study Of The Effects Of Pumping Pressure On The Properties Of Fresh Concrete, Dinesh Vithal Kenkre

Theses

This thesis has a two-fold objective. One, to develop a suitable testing apparatus in the labaratory to simulate the effect of field pumping of concrete and two, to conduct some preliminary tests to investigate the feasibility of the testing apparatus.

Pumping of concrete has been practiced in the U.S.A. since 1930. The behaviour of concrete in a pipeline has not been studied in much detail while development in the pumping technology raced ahead of the research in this field. Previous studies done in this field have clearly indicated the need for a laboratory simulation of pumping process in order that …

Design Of Plain Concrete Runways And Taxiways Of A Class 4 Airport, Erkmen Erkmen

Masters Theses

"This thesis is a study for determining the most economical design for the pavements of Adana Airport. It is a study of redesigning efficient and safe runways and necessary taxiways for a future service life of thirty years.

Adana is Turkey’s 6th largest city. It is a growing city. An airport in Adana also serves tor industrial purposes, serves for transcontinental airway systems. In Adana there is an important Nato Base and in a future war such an airport can be used for military purposes. For these reasons, it was decided to construct a class 4 airport* for the city. …