Civil Engineering Commons^™

An Investigation Of Waste Glass-Based Geopolymers Supplemented With Alumina, Mary U. Christiansen

Dissertations, Master's Theses and Master's Reports - Open

An increased consideration of sustainability throughout society has resulted in a surge of research investigating sustainable alternatives to existing construction materials. A new binder system, called a geopolymer, is being investigated to supplement ordinary portland cement (OPC) concrete, which has come under scrutiny because of the CO2 emissions inherent in its production.

Geopolymers are produced from the alkali activation of a powdered aluminosilicate source by an alkaline solution, which results in a dense three-dimensional matrix of tetrahedrally linked aluminosilicates. Geopolymers have shown great potential as a building construction material, offering similar mechanical and durability properties to OPC. Additionally, geopolymers have …

The Laboratory Evaluation Of Bio Oil Derived From Waste Resources As Extender For Asphalt Binder, Xu Yang

Dissertations, Master's Theses and Master's Reports - Open

A shortage of petroleum asphalt is creating opportunities for engineers to utilize alternative pavement materials. Three types of bio oils, original bio oil (OB), dewatered bio oil (DWB) and polymer-modified bio oil (PMB) were used to modify and partially replace petroleum asphalt in this research. The research investigated the procedure of producing bio oil, the rheological properties of asphalt binders modified and partially replaced by bio oil, and the mechanical performances of asphalt mixtures modified by bio oil. The analysis of variance (ANOVA) is conducted on the test results for the significance analysis. The main finding of the study includes: …

Stilling Basin Scour Remediation Using Air Injection And Flat Plate Extension, Rachael Barlock

Dissertations, Master's Theses and Master's Reports - Open

The South Florida Water Management District (SFWMD) is responsible for managing over 2500 miles of waterways and hundreds of water control structures. Many of these control structures are experiencing erosion, known as scour, of the sediment downstream of the structure. Laboratory experiments were conducted in order to investigate the effectiveness of two-dimensional air diffusers and plate extensions (without air injection) on a 1/30 scale model of one of SFWMD gated spillway structures, the S65E gated spillway. A literature review examining the results of similar studies was conducted. The experimental design for this research was based off of previous work done …

Structural Control Of A Small-Scale Test-Bed Shaker Structure Using A Sponge-Type Magneto-Rheological Fluid Damper, Benjamin D. Winter

Dissertations, Master's Theses and Master's Reports - Open

Semi-active damping devices have been shown to be effective in mitigating unwanted vibrations in civil structures. These devices impart force indirectly through real-time alterations to structural properties. Simulating the complex behavior of these devices for laboratory-scale experiments is a major challenge. Commercial devices for seismic applications typically operate in the 2-10 kN range; this force is too high for small-scale testing applications where requirements typically range from 0-10 N. Several challenges must be overcome to produce damping forces at this level. In this study, a small-scale magneto-rheological (MR) damper utilizing a fluid absorbent metal foam matrix is developed and tested …

Evaluation Of Intelligent Compaction Control In The M-189 Reconstruction Project At Iron River, Michigan, Junhong Li

Dissertations, Master's Theses and Master's Reports - Open

This research evaluated an Intelligent Compaction (IC) unit on the M-189 highway reconstruction project at Iron River, Michigan. The results from the IC unit were compared to several traditional compaction measurement devices including Nuclear Density Gauge (NDG), Geogauge, Light Weight Deflectometer (LWD), Dynamic Cone Penetrometer (DCP), and Modified Clegg Hammer (MCH). The research collected point measurements data on a test section in which 30 test locations on the final Class II sand base layer and the 22A gravel layer. These point measurements were compared with the IC measurements (ICMVs) on a point-to-point basis through a linear regression analysis. Poor correlations …

Determing The Effect Of Thermal Treatment Timing On Ultra-High Performance Concrete Beams, Christopher H. Mullen

Dissertations, Master's Theses and Master's Reports - Open

The loss of prestressing force over time influences the long-term deflection of the prestressed concrete element. Prestress losses are inherently complex due to the interaction of concrete creep, concrete shrinkage, and steel relaxation. Implementing advanced materials such as ultra-high performance concrete (UHPC) further complicates the estimation of prestress losses because of the changes in material models dependent on curing regime.

Past research shows compressive creep is "locked in" when UHPC cylinders are subjected to thermal treatment before being loaded in compression. However, the current precasting manufacturing process would typically load the element (through prestressing strand release from the prestressing bed) …

Preliminary Investigation Of Ultra-High Performance Concrete Behavior At High Strain Rates Using The Split-Hopkinson Pressure Bar, Jacob Clark

Dissertations, Master's Theses and Master's Reports - Open

Ultra-high performance concrete (UHPC) displays several enhanced material properties compared to normal strength concrete (NSC). In past research, Split-Hopkinson pressure bar (SHPB) tests have been used for normal strength concrete to determine material behavior at high strain rates. The behavior of advanced concrete materials, such as UHPC, under high strain rates has not been thoroughly investigated. While it is generally accepted that concrete materials experience increases in compressive strength under increasing strain rates, a preliminary investigation was conducted to gain insight into the compressive behavior of UHPC under high strain rate SHPB testing.

In this research, 50 specimens were tested …

Sampling Bias In Evaluating The Probability Of Seismically Induced Soil Liquefaction With Spt & Cpt Case Histories, Abhishek Jain

Dissertations, Master's Theses and Master's Reports - Open

Several deterministic and probabilistic methods are used to evaluate the probability of seismically induced liquefaction of a soil. The probabilistic models usually possess some uncertainty in that model and uncertainties in the parameters used to develop that model. These model uncertainties vary from one statistical model to another. Most of the model uncertainties are epistemic, and can be addressed through appropriate knowledge of the statistical model. One such epistemic model uncertainty in evaluating liquefaction potential using a probabilistic model such as logistic regression is sampling bias. Sampling bias is the difference between the class distribution in the sample used for …

The Performance And Modification Of Recycled Electronic Waste Plastics For The Improvement Of Asphalt Pavement Materials, Baron W. Colbert

Dissertations, Master's Theses and Master's Reports - Open

Bulk electric waste plastics were recycled and reduced in size into plastic chips before pulverization or cryogenic grinding into powders. Two major types of electronic waste plastics were used in this investigation: acrylonitrile butadiene styrene (ABS) and high impact polystyrene (HIPS). This research investigation utilized two approaches for incorporating electronic waste plastics into asphalt pavement materials. The first approach was blending and integrating recycled and processed electronic waste powders directly into asphalt mixtures and binders; and the second approach was to chemically treat recycled and processed electronic waste powders with hydro-peroxide before blending into asphalt mixtures and binders. The chemical …

The Quantification Of The Fly Ash Adsorption Capacity For The Purpose Of Characterization And Use In Concrete, Zeyad Tareq Ahmed

Dissertations, Master's Theses and Master's Reports - Open

Fly ash has been shown to be an effective replacement for portland cement in concrete mixtures. However, many fly ash materials contain unburned carbon from the combustion process. Unburned carbon in fly ash adsorbs air entraining admixtures (AEAs) reducing their effectiveness in providing a specified air void system in concrete materials. Measurement tools and methods for characterization of the adsorption properties of fly ash materials are necessary for beneficial use of fly ash materials in concrete. In this research, two methods were developed to measure and quantify the adsorption capacity AEAs on fly ash materials. The first method is the …

Regulation Issues And Prediction Of Natural Estrogen Loads For Wastewater Treatment Plants, Michelle E. Jarvie

Dissertations, Master's Theses and Master's Reports - Open

No abstract provided.

Countermeasures Against Scour At Bridge Abutments, Hua Li

Dissertations, Master's Theses and Master's Reports - Open

Scour at bridge abutments can cause damage or failure of bridges and result in excessive repairs, loss of accessibility, or even death. To mitigate abutment scour, both clear-water and live-bed laboratory experiments in a compound channel were performed using parallel walls and spur dikes as countermeasures, respectively. In addition, collars were tested under clear-water conditions only. It was found that both parallel walls and spur dikes can efficiently protect the abutment from scour provided that they are properly designed. Design guidelines were discussed for both countermeasures. Preliminary clear-water tests of collars as countermeasures against scour showed some promising results although …

Optimal Design Of Pump And Treat Remediation Systems : Treatment Modeling, Source Modeling And Time As A Decision Variable, Karen L. Endres

Dissertations, Master's Theses and Master's Reports - Open

Groundwater optimization and simulation is a maturing science. Research work contained in this thesis extends into areas that have not been fully explored. The incorporation of source and treatment systems selection and design produces information to help decision makers. Further insight is gained by evaluating some of the requirements and standards enforced by regulations such as, remediation time.

The technical aspects of a remediation system are set by the physical properties and the regulatory constraints enforced. As an example, the addition of a realistic treatment system gives more accurate cost estimates, but the pump and treat (PAT) systems parameters do …

Selected Chemoautotrophic Processes In Wastewater Treatment: Low Temperature Nitrification Inhibition By An Azo Dye And Biofiltration For Odor Control Of Hydrogen Sulfide, Ronald W. Martin Jr.

Dissertations, Master's Theses and Master's Reports - Open

Biochemical processes by chemoautotrophs such as nitrifiers and sulfide and iron oxidizers are used extensively in wastewater treatment. The research described in this dissertation involved the study of two selected biological processes utilized in wastewater treatment mediated by chemoautotrophic bacteria: nitrification (biological removal of ammonia and nitrogen) and hydrogen sulfide (H2S) removal from odorous air using biofiltration.

A municipal wastewater treatment plant (WWTP) receiving industrial dyeing discharge containing the azo dye, acid black 1 (AB1) failed to meet discharge limits, especially during the winter. Dyeing discharge mixed with domestic sewage was fed to sequencing batch reactors at 22oC and 7oC. …