Civil and Environmental Engineering Commons^™

Purlin Failures In The Vicinity Of Lap Joints And Internal Supports, K. T. Kavanagh

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Flexural Buckling In Cold-Formed Steel Structural Members, Peter Lorincz

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Interactive Buckling In Thinwalled Columns, Srinivasan Sridharan, Rafael Benito

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

The Strength Of Cold-Formed Portal Frames, A. H. Baigent, Gregory J. Hancock

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Behavior Of C- And Z-Purlins Under Wind Uplift, Parviz Soroushian, Teoman Peköz

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Combined Compression And Lateral Loads On Load Bearing Steel Stud Walls, Paul G. Schurter, R. M. Schuster, Andrew S. Zakrzewski

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Composite Steel Deck Diaphragm Slabs -- Design Modes, Max L. Porter, Lowell F. Greimann

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Composite Cold-Formed Steel-Concrete Structural System, George Abdel-Sayed

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Cold-Formed Steel: Research To Design, Albert L. Johnson

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Teaching Cold-Formed Steel Design To Technologists, Richard K. Keplar, Edward R. Estes Jr.

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Cold Formed Steel Applications Abroad, Rolf Baehre, Bao-Kang He, Gerard Moreau, Kazumi Sakae, E. R. Bryan, Teoman Peköz

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Buckling Of Eccentrically Loaded Curved Panels, Ted T. Sokol Jr.

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Buckling Strength Of Cold-Formed Steel Curved Panels, James L. Jorgenson, Asadul H. Chowdhury

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

The Post Buckling Behaviour Of Bending Elements, J. Rhodes

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Ultimate Moment Capacity Of Thin-Walled Cold-Formed Members Of Vehicular Structures, Frank Monasa, Timothy Chipman

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Sidor's Design Aids For Cold-Formed Steel Beams And Columns, Arnaldo R. Gutierrez, O. Jorge Espinoze

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Dynamic Behavior Of Locally Buckled Frames, George E. Blandford, Shien T. Wang, Neng T. Wang

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Comparison Of Methods Predicting Diaphram Behavior, Paul E. Liedtke, Donald R. Sherman

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Analysis Of Local Plate Buckling Experimental Data, J. Roorda, K. R. Venkataramaiah

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

Shear Resistance Of Steel-Stud Wall Panels, Joseph D. Girard, Thomas S. Tarpy Jr.

CCFSS Proceedings of International Specialty Conference on Cold-Formed Steel Structures (1971 - 2018)

No abstract provided.

An Exploratory Study On The Behavior Of Cold-Formed Steel Wall Studs, Yaochun Zhang, Teoman Peköz

CCFSS Library (1939 - present)

No abstract provided.

An Exploratory Study On The Behavior Of Cold-Formed Steel Wall Studs, Yaochun Zhang, Teoman Peköz

CCFSS Library (1939 - present)

GENERAL Cold-formed steel wall studs are widely used in the U. S. and Canada. The 1980 A.I.S.I Specification (Ref. 1) contains provisions for the design of such wall studs based primarily on the research conducted at Cornell University (Refs. 2 and 3). This research involved theoretical and experimental studies on wall studs subjected axial loads only. The Specification provisions on the case of combined axial and lateral loading were derived intuitively and were made intentionally conservative. The excessive conservatism in the provisions for the combined loading case prevents using wall studs as economically as possible. The primary objective of the …

Performance Evaluation Of Brick Veneer With Steel Stud Backup, Joseph O. Arumala, Russell H. Brown

CCFSS Library (1939 - present)

No abstract provided.

Seismic Design For Buildings, Department Of The Army, The Navy, And The Air Force

American Iron and Steel Institute (AISI) Specifications, Standards, Manuals and Research Reports (1946 - present)

This updated manual with revised seismic design provisions governs the design and construction of Army, Navy, and Air Force facilities and supersedes the April 1973 issue. Basic criteria are stated herein with augmentations and clarifications of the criteria. Also, commentary and design examples are included to provide comprehensive applications and guidelines for the seismic-resistant design of facilities. The organization of the manual has been revised to present the topics in a more orderly manner. The dynamic analysis approach for seismic design is not covered but its use is not precluded in this manual.

The basic criteria cited are the "Recommended …

Structural Stability Research Council: Proceedings 1982, Structural Stability Research Council

CCFSS Library (1939 - present)

One of the purposes of the the of Council is to maintain a forum where the the of Council is to maintain a forum where the structural stability aspects of metal andcomposite metal and concrete structures and and their components can be presented for evaluation, and pertinent structural research problems proposed for investigation. The Annual Technical Session provides an opportunity to carry out this function.

Experimental Determination Of Post-Buckling Performance Of Steel Angles, Rupasiri Purasinghe

Dissertations and Theses

An experimental testing program was conducted to determine the compression member performance in post-buckling region. These results are compared with an analytical computer program developed by Portland State University under Bonneville Power Administration Contract 79-80BP 24005. The paper presents the sensitivity of the performance of single angle compression members to various parameters such as length to radius of gyration ratio, eccentricity, end conditions and yield stress. The effect of local buckling on long member performance is also documented.

Web Crippling And Combined Web Crippling And Bending Of Steel Decks, Wei-Wen Yu

CCFSS Library (1939 - present)

INTRODUCTION A. General During the period of October 1968 through September 1980, the 1968 Edition of the AISI Specification was used for the design of steel deck webs that could withstand web crippling and combined web crippling and bending. (1) The design formulas used to prevent web crippling were developed primarily on the basis of tests conducted in the 1940's and 1950's at Cornell University. (2-4) Recently, new types of cold-formed steel sections have been developed and used in building construction. The use of unusual geometric configurations has complicated the design of such members. In order to develop new design …

Behavior Of C- And Z-Purlins Under Wind Uplift, Parviz Soroushian, Teoman Peköz

CCFSS Library (1939 - present)

INTRODUCTION Cold-formed steel lipped channel (C-) and Z-purlins are used widely in the roofs of metal buildings. They are easy and economical to fabricate and erect. However these sections are weak in the lateral direction and in torsion. In order to use their full bending capacity in the strong direction, they must be braced in the lateral direction and against twisting. Roof panels which are connected to the purlins do provide to some extent such bracing effect by virtue of their shear rigidity and resistance to local bending at the connections. Wind uplift is an important design condition for roof …

Fire Protection Through Modern Building Codes, 5th Edition, James C. Spence, Walter G. Wells, D. F. Boring

American Iron and Steel Institute (AISI) Specifications, Standards, Manuals and Research Reports (1946 - present)

No abstract provided.

Designing Fire Protection For Steel Trusses, Subcommittee On Fire Technology Of The Committee On Construction Codes And Standards, American Iron And Steel Institute

American Iron and Steel Institute (AISI) Specifications, Standards, Manuals and Research Reports (1946 - present)

No abstract provided.