Thermodynamics Commons^™

Neural Network Technologies In The Automatical Control Systems Of Absorption Process For Pureficating Natural Gas, Abdishukurov Maqsudovich Shavkat Mr, Xuecheng Li Li Xuecheng Mr

Technical science and innovation

Analysis of methods and algorithms for synthesizing adaptive control systems for technological processes based on the neural network approach is carried out in this search. The stages of mathematical modeling of complex technological processes using neural network technology were considered. Additionally, an algorithm for solving the interpolation and extrapolation problem that arises in the training process a neural network to control system was proposed. At the final stage of this article, algorithms based on neural network technology are synthesized for the control system for the parameters of the technological process of natural gas purification by absorption

On The Use Of Lorawan For Smart Fishing Applications In The Blue Economy Sector, Eva Shayo

Tanzania Journal of Engineering and Technology (TJET)

The growth of digital technology is expected to transform small-scale fishery sectors, where a need for robust, low-cost, long-range communication networks becomes critical. There exist several technologies that are used in the fishery sector but they are never affordable to small scale fisheries. This study evaluates the feasibility of using low cost Long Range Wide Area Network (LoRaWAN) technology specifically tailored for smart fishing environments to small scale fishery sector. Using simulation, we assess the performance of the key performance metrics including probability of success and energy efficiency under varying device densities and time. During evaluation, we considered end devices …

Advancing Sustainable Co2 Mitigation: Experimental And Computational Analysis Of Thermal Carbon Chitosan Sorbent For Automotive Exhaust Capture, Dalia A. Ali Dr., Amir Ahmed Elgamal Eng., Rania Rushdy Moussa Dr.

Chemical Engineering

This study investigated the efficiency of thermal carbon chitosan (TCCS) sorbent for CO2 capture from vehicle exhaust emissions within a designed adsorption system. TCCS was synthesized and meticulously characterized using a series of analytical techniques, including Brunauer-Emmett-Teller (BET) surface area analysis, Scanning Electron Microscopy (SEM), Fourier Transform Infrared Spectroscopy (FTIR), X-ray Diffraction (XRD), Ther- mogravimetric Analysis (TGA), Energy Dispersive X-ray Spectroscopy (EDX), and Differential Scanning Calo- rimetry (DSC). The TCCS adsorbent showed high thermal stability and a heating value (HHV) of 23.5 MJ/kg. Adsorption isotherm study demonstrated that the maximum capacity of CO2 adsorption is 0.084 kg.CO2/kg. TCCS, as well …

Statistical Investigation Of Gypsum Crystallization Kinetics, Azmain A. Akash

LSU Master's Theses

Gypsum, a naturally occurring mineral salt, is frequently encountered in industrial processes such as seawater desalination and power plant cooling. Over the years, significant effort has been devoted to controlling the crystallization of gypsum through various chemical approaches, including acidification, chelating agents, and antiscalant polymers. Nevertheless, the cost associated with chemical treatments may be reduced by incorporating physical operational strategies to complement chemical methods in regulating gypsum crystallization.

This study systematically examines the comparative roles of chemical and physical entropy in the gypsum crystallization process to elucidate their respective influences on gypsum growth kinetics. Chemical entropy is manipulated by adjusting …

Efficient Phosphate Removal From Water Using Ductile Cast Iron Waste: A Response Surface Methodology Approach, Mai Hassan Dr., Nada Alkhashab Eng., Ahmed Osman Dr., Dalia A. Ali Eng

Chemical Engineering

Water scarcity is a critical issue worldwide. This study explores a novel method for addressing this issue by using ductile cast iron (DCI) solid waste as an adsorbent for phosphate ions, supporting the circular economy in water remediation. The solid waste was characterized using XRD, XRF, FTIR, and particle size distribution. Wastewater samples of different phosphate ion concentrations are prepared, and the solid waste is used as an adsorbent to adsorb phosphate ions using different adsorbent doses and process time. The removal percentage is attained through spectrophotometer analysis and experimental results are optimized to get the optimum conditions using Design …

Smart Manufacturing Of Cement: From Lab-Scale Simulation And Testing To Industry-Scale Deployment., Juan David Tabares Tamayo

Electronic Theses and Dissertations

Cement kilns are controlled by experienced process operators who follow experience-based industry guidelines using data collected and fundamental knowledge. The manufacturing process, which is equipped with sensors and equipment, transfers data/information to the operators to aid standardized decision-making operations. In contrast, companies have used such data to develop and implement digital solutions for predictive control systems; in effect, FLSmidth and Rockwell Automation. However, despite the availability of automated control systems and investigation in automation for process monitoring and optimization, opportunities to radically optimize cement manufacturing are still abundant and in need of implementation. Therefore, this research developed simulation models and …

Thermo-Elasto-Plastic Stability Of Biaxially Loaded Hollow Rectangular Section Steel Beam-Columns With Applied Torsion, George Adomako Kumi

Civil & Environmental Engineering Theses & Dissertations

Presented herein is an experimental and theoretical study of biaxially loaded hollow rectangular section steel beam-columns with applied torsion at elevated temperatures. The theoretical analysis is based on a system of simultaneous materially nonlinear differential equations of equilibrium for which an iterative semi-analytic solution approach is formulated. Although the primary goal of this research is to study the influence of elevated temperatures on the steel member with the complex loading, rigorous analysis is also conducted of the member at ambient temperature for comparison. The experimental part of the study involves conducting tests on the members at both ambient and high …

Electrification Of Domestic Hot Water To Aid The Integration Of Renewable Energy In The California Grid, Alejandro Cervantes

Cal Poly Humboldt theses and projects

Water heating in residential buildings, also known as domestic hot water (DHW), is the third largest use of energy after appliances and space conditioning. About 90% of the residential buildings in the state use natural gas fueled water heaters, 6% use electricity, and a small percent use liquefied petroleum gas (LPG) or solar water heaters. The current energy use associated with residential water heating is small relative to the total amount of energy consumption in the residential building sector, but it is still a contributor of greenhouse gas (GHG) emissions. Improving hot water systems can be beneficial for bill customer …

The Potentials Of Faecal Sludge Treatment Using Local Conditioners In Tanzania: A Review, Doglas Benjamin1

Tanzania Journal of Engineering and Technology (TJET)

Worldwide, every day human beings generate millions of tons of Faecal Sludge (FS), which is rich in water, nutrients, energy, and organic compounds. Yet FS is not being managed in a way that permits us to derive value from its reuse, while at the same time, millions of farmers struggle with depleted soils and lack of water. In most of the developing countries, energy for cooking is mainly derived from cutting of trees, either as wood or charcoal. Resource recovery and reuse from FS can create livelihoods, enhance food security, support green economies, reduce waste and contribute to cost recovery …

Influence Of Tempering And Cryogenic Treatment On Retained Austenite And Residual Stresses In Carbonitrided 18crnimo7-6 Low Alloy Steel, Richard Katemi

Tanzania Journal of Engineering and Technology (TJET)

This work investigated the influence of tempering conditions coupled with cryogenic treatment on thermal stabilization of retained austenite and residual stress distributions in carbonitrided 18CrNiMo76 low alloy steel samples. The carbonitriding conditions were set to enable attaining surface carbon and nitrogen content of 0.87 and 0.34 mass.-percent respectively. After carbonitriding, some of the samples were subjected to varying tempering conditions followed by cryogenic treatment at-120 °C using nitrogen gas. Analysis of both retained austenite and residual stresses was conducted using X-ray diffraction. In the as-quenched state, carbonitrided samples contained 52 mass.-percent. Samples that were directly subjected to the cryogenic treatment …

Radical Social Ecology As Deep Pragmatism: A Call To The Abolition Of Systemic Dissonance And The Minimization Of Entropic Chaos, Arielle Brender

Student Theses 2015-Present

This paper aims to shed light on the dissonance caused by the superimposition of Dominant Human Systems on Natural Systems. I highlight the synthetic nature of Dominant Human Systems as egoic and linguistic phenomenon manufactured by a mere portion of the human population, which renders them inherently oppressive unto peoples and landscapes whose wisdom were barred from the design process. In pursuing a radical pragmatic approach to mending the simultaneous oppression and destruction of the human being and the earth, I highlight the necessity of minimizing entropic chaos caused by excess energy expenditure, an essential feature of systems that aim …

Passive Solar Distillation Of Acid Rock Drainage, Stephanie Shreve, Luke Galuska, Anna Stoller, Alex Raney, Agustin Caceres, Caitlyn Chambers, Chris Graham, Devin Hazlett

Chemical Engineering Undergraduate Honors Theses

Arkansas Razorback Distillers (A.R.D.) has developed a passive solar distillation system for treating acid rock drainage (ARD) from legacy (i.e., abandoned) mines. The solar still addresses the need to reduce both the metal sulfate contaminants as well as the acidity of acid rock drainage. During the design phase, A.R.D. addressed the need for the system to be low cost, simple, and effective for general use as well as a specified location. To demonstrate the applicability of the solar still, A.R.D. used the Freeport McMoRan Inc. Copper Queen legacy mine in Bisbee, Arizona, as a base case scenario. The mine was …

Development Of Cementitious Materials For Adhesion Type Applications Comprising Calcium Sulfoaluminate (Csa) Cement And Latex Polymer, Joshua V. Brien

Theses and Dissertations--Civil Engineering

The objective of this research was to develop high performing polymer modified calcium sulfoaluminate (CSA) cement materials for use in applications requiring superior adhesion characteristics. Little information is available describing interactions of CSA cement containing minor phase tri-calcium aluminate (C₃A) with commonly used admixtures. Given the scarcity of information, a basic approach for developing cementitious materials was followed. The basic approach consisted of four tasks: cement design, admixture design, polymer design and testing developed materials. The iterative, time consuming process is necessary for understanding the influence of specific constituent components on overall system behavior. Results from the cement …

Thermal Effectiveness Characteristics Of Low Approach Indirect Evaporative Cooling Systems In Buildings, Ben Costelloe, Donal Finn

Articles

Meteorological enthalpy analysis of temperate and maritime climates above latitude 45°N suggests that the water-side evaporative cooling technique has considerable unrealised potential with contemporary “high temperature” building cooling systems—such as chilled ceilings and displacement ventilation. As low approach conditions are the key to exploiting the cooling potential of the ambient air, thermal performance at such conditions needs to be investigated. To address the research issues, an industrial scale test rig, based on a low approach open cooling tower and plate heat exchanger and designed to maximise evaporative cooling potential, has been constructed. The thermal effectiveness of such systems (as a …

Socio-Economic Impacts Of Computer Viruses In Tanzania, M Victor

Tanzania Journal of Engineering and Technology (TJET)

This paper reports on a research project conducted with an objective of identifying and assessing various approaches used by different computer users (Management, System Administrators and end users) in Tanzania to combat computer viruses (CVs), and to assess users' awareness level on CVs. Specifically, the study aimed at assessing the awareness level on CVs to the Tanzanian business community; analyze the socio -economic impact caused by CVs in Tanzania and; assess existing methods, capacity and limitations on controlling CVs in Tanzania. Data was collected using both questionnaires and interview from financial institutions such as NBC and BOT, and telecommunications sector …

Review Of The Product Development Process And Information Flow In The Manufacturing Industry: Problems And A Possible Wav Forward, E Opiyo

Tanzania Journal of Engineering and Technology (TJET)

No abstract provided.

Indirect Evaporative Cooling Potential In Air-Water Systems In Temperate Climates, Ben Costelloe, Donal Finn

Articles

Recent developments have prompted a review of evaporative cooling technology as an effective means of cooling modern deep plan buildings. Prominent among these developments is the success of high temperature sensible cooling systems, particularly, chilled ceilings, which require a supply of cooling water at 14–18 °C. Crucial to the success of evaporative cooling technology, as a significant means of cooling in modern applications, is the ability to generate cooling water, in an indirect circuit, at a temperature which closely approaches the ambient adiabatic saturation temperature (AST) or wet bulb temperature (WBT). Recent experimental research has demonstrated that it is technically …

Application Of Vibrational Techniques In Determination Of Dynamic Properties Of Agricultural Products-State Of The Arton Of Vibrational Techniques In Determination Of Dynamic Properties Of Agricultural Products-State Of The Art, Silas Kajuna

Tanzania Journal of Engineering and Technology (TJET)

Vibration is one of the techniques employed in the determination of dynamic properties of fruits and vegetables. It entails generation of a mechanical or acoustic vibrational signal which is propagated through the flesh of the agricultural material. A transducer is either attached or held close to the specimen to monitor the propagation of the signal through the specimen. The manner in which the signal is transmitted through the material is analyzed, and the dynamic properties of the specimen which relate to its firmness or its internal being are derived. The technique has been around for the past 30 years or …