Polymer Science Commons^™

Enhanced Methane Hydrate Formation Using Promoters For Natural Gas Storage And Transportation Application, Katipot Inkong

Chulalongkorn University Theses and Dissertations (Chula ETD)

Solidified natural gas (SNG) is an alternative technology for natural gas storage and transportation in the clathrate hydrate formed. It has higher volumetric energy storage with the ease to handle not to mention its safety. Effects of different hydrate promoters, including methyl ester sulfonate (MES), tetrahydrofuran (THF), hollow silica (HS), and sodium dodecyl sulfate (SDS), on the methane hydrate formation was investigated. All experiments were performed in an unstirred tank reactor at desired experimental conditions. The results indicated that all promoters significant enhanced the hydrate formation both kinetics and methane uptake compared with pure water. The increase in the MES …

Time-Dependent Reliability Framework For Durability Design Of Frp Composites, Rajneesh Kumar Bharil

Graduate Theses, Dissertations, and Problem Reports (ETD)

The life-cycle performance, durability, and aging characteristics of Fiber Reinforced Polymer (FRP or Structural Composites) have been of keen interest to the engineers engaged in the FRP design, construction, and manufacturing. Unlike conventional construction materials such as steel and concrete, the design guidelines to account for the aging of FRP are somewhat scattered or not available in an approved or consistent format. Loss of strength over time or aging of any structural material should be of concern to engineers as the in-service lifespan of many engineering structures is expected to exceed 100 years. Use of durability strength-reduction factors or factors …

Elucidating The Properties And Mechanism For Cellulose Dissolution In Tetrabutylphosphonium-Based Ionic Liquids Using High Concentrations Of Water, Brad Crawford

Graduate Theses, Dissertations, and Problem Reports (ETD)

The structural, transport, and thermodynamic properties related to cellulose dissolution by tetrabutylphosphonium chloride (TBPCl) and tetrabutylphosphonium hydroxide (TBPH)-water mixtures have been calculated via molecular dynamics simulations. For both ionic liquid (IL)-water solutions, water veins begin to form between the TBPs interlocking arms at 80 mol % water, opening a pathway for the diffusion of the anions, cations, and water. The water veins allow for a diffusion regime shift in the concentration region from 80 to 92.5 mol % water, providing a higher probability of solvent interaction with the dissolving cellulose strand. The hydrogen bonding was compared between small and large …

Innovative Sustainable Wood Preservatives From Pulp And Paper Industry Byproduct, Raisa Carmen Andeme Ela

Dissertations, Master's Theses and Master's Reports

In the modern forest industry, the need for bio-based, renewable, and environmentally-benign wood preservatives is increasing. Preservatives are used to prevent or limit decay and there has been an increasing interest in developing wood preservatives from renewable materials. To support the need for bio-based, environmentally-friendly preservatives, this work employed kraft lignin as a raw material to produce a novel bio-based wood preservative.

For the first project, a statistical design of experiments approach in Minitab® was used to study how fractionation process variables during acid precipitation of lignin influence the lignin mass yield and characteristics. After precipitating lignin from black liquor, …

Bimetallic Nanoparticles Integrated Membranes For Groundwater Remediation: Synthesis, Characterization And Applications, Hongyi Wan

Theses and Dissertations--Chemical and Materials Engineering

The detoxification of chlorinated organics from groundwater, such as trichloroethylene (TCE), tetrachloroethylene (PCE), polychlorinated biphenyl (PCB) and carbon tetrachloride (CTC), is a challenging area. Reductive dechlorination has been investigated using iron and iron-based nanoparticles, such as bare Fe, sulfidized Fe (S-Fe) and palladized Fe (Pd-Fe). However, issues including particle agglomeration, difficulties in recycling and particle leaching have been reported to hinder the application and wide usage of these techniques. The integration of nanoparticles and membranes can address these issues because of the large surface area, stability, and the potential for versatile functionalities. In this study, commercial polyvinylidene difluoride (PVDF) microfiltration …

A Thermodynamic And Feasibility Study Of Green Solvents For The Fabrication Of Water Treatment Membranes, Xiaobo Dong

Theses and Dissertations--Chemical and Materials Engineering

Nonsolvent induced phase separation (NIPS) has been widely used to fabricate polymeric membranes. In NIPS, a polymer is dissolved in a solvent to form a dope solution, which is then cast on a substrate and immersed in a nonsolvent bath, where phase inversion occurs. Petroleum-derived organic solvents, such as N-Methyl-2-Pyrrolidone (NMP) and Dimethylacetamide (DMAc), have been traditionally used to fabricate polymeric membranes via NIPS. However, these solvents may have negative impacts on environmental and human health; therefore, using greener and less toxic solvents, preferably derived from biomass, is of great interest to make membrane fabrication sustainable. In this dissertation, two …

Polymeric Nanocomposite Membranes With Phosphorene Based Pore Fillers For Fouling Control, Joyner Eke

Theses and Dissertations--Chemical and Materials Engineering

Phosphorene is a two-dimensional material exfoliated from bulk phosphorus. Specifically, relevant to the field of membrane science, the band gap of phosphorene provides it with potential photocatalytic properties, which could be explored in making reactive membranes able to control the accumulation of compounds on the surface during filtration, or fouling. Another reason phosphorene is a promising candidate as a membrane material additive is due to its catalytic properties which can potentially destroy foulants on the membrane surface.

The first goal of this study was to develop an innovative and robust membrane able to control and reverse fouling with minimal changes …

Formulation And Validation Of Nanoparticle Controlled Delivery For Chemotherapeutic Drug Products, Shani L. Levit

Theses and Dissertations

Taxol, a formulation of paclitaxel (PTX), is one of the most widely used anticancer drugs, particularly for treating recurring ovarian carcinomas following surgery. Clinically, PTX is used in combination with other drugs such as lapatinib (LAP) to increase treatment efficacy. Delivering drug combinations with nanoparticles has the potential to improve chemotherapy outcomes. In this study, we use Flash NanoPrecipitation, a rapid, scalable process to encapsulate weakly hydrophobic drugs (logP in vitro. Encapsulating either PTX or LAP into nanoparticles increases drug potency. When PTX and LAP are co-loaded in the same nanoparticle, they have a synergistic effect that is greater than …

Dendrimer-Based Therapeutic Delivery Vehicle For The Treatment Of Ocular Diseases, Remy C. Cooper

Theses and Dissertations

The treatment of ocular diseases poses a significant challenge to drug delivery design, due to the eye’s complex anatomy, with a semi-permeable blood-ocular barrier and associated immune privilege. To address some of the delivery challenges, polycationic dendrimers are explored as vehicle for the treatment of posterior chamber disease. Dendrimers are a class of polymeric nanoparticles that are highly branched, multivalent and monodisperse, whose three-dimensional globular architecture has given them the nickname of “synthetic proteins”. Dendrimers are synthesized by reacting monomers in a step-wise fashion to produce generationally and radially increasing structures, with core, interior and surface chains that are highly …

Self-Assembled Metal Nanoparticle/Polymer Nanocomposites As Nanoreactors For One-Pot Reactions, Andrew Harrison

Theses and Dissertations

Polymer nanoreactors incorporating gold nanoparticle catalysts were self-assembled via Flash Nanoprecipitation. The incorporated gold nanoparticles maintained catalytic activity, which was evaluated using reduction of 4-nitrophenol with sodium borohydride as a model reaction. The diffusion coefficient for 4-nitrophenol was determined by NMR and used to calculate the second Damköhler number, which indicated that the systems were not diffusion limited. Despite similar diffusion coefficients, catalytic performance was strongly affected by the co-precipitant. For example, the apparent reaction rate per surface area using castor oil was over 8-fold greater than polystyrene. Thus, we measured the partition coefficient of 4-nitrophenol between water and castor …