Other Chemical Engineering Commons^™

Chlorpyrifos Removal For Wastewater Reuse, Indran Kamalanathan

Chemical Engineering Undergraduate Honors Theses

Approximately 1.2 billion people around the world live in areas of physical water scarcity. This could increase to half of the world’s population by 2030 and could displace 24 to 700 million people unless steps are taken to ensure adequate water supply.¹ Water scarcity is an escalating issue within the United States, specifically in Western inland states with arid climates. This scarcity is encouraging communities to investigate tertiary level municipal wastewater treatment, allowing for reuse of wastewater. Unfortunately, wastewater contains numerous contaminants that are not regulated by the Environmental Protection Agency (EPA) under the Safe Drinking Water Act (SDWA). …

Electrodeionization Versus Electrodialysis: A Clean-Up Of Produced Water In Hydraulic Fracturing, Brigitte Marie Rodgers

Graduate Theses and Dissertations

Electrodeionization (EDI) is a widely studied process ranging from applications in wastewater clean-up in the food and beverage industry to purifying organic compounds. To date, there are no apparent studies on applying this technology to produced wastewater recovered from hydraulic fracking sites. Water consumption within hydraulic fracturing sites can reach in the upwards of millions of gallons per site, so a need for a water recycling process becomes necessary within areas where water requirements are scarce. Implementation of an EDI module that is capable of handling high salt solutions from produced wastewater in subsequent fracturing practices will decrease overall water …

Nanofiltration Rejection Of Contaminants Of Emerging Concern From Municipal Water Resource Recovery Facility Secondary Effluents For Potable Reuse Applications, Steven Michael Jones

Graduate Theses and Dissertations

As reuse of municipal water resource recovery facility (WRRF) effluent becomes vital to augment diminishing fresh drinking water resources, concern exists that conventional barriers may prove deficient and the upcycling of contaminants of emerging concern (CECs) could prove harmful to human health and aquatic species if more effective and robust treatment barriers are not in place.

There are no federal Safe Drinking Water Act (SDWA) regulations in place specifically for direct potable reuse (DPR) of WRRF effluent. Out of necessity, some states are developing their own DPR reuse regulations. Currently, reverse osmosis (RO) is the default full advanced treatment (FAT) …

Removal Of Endocrine Disrupting Compounds From Secondary Municipal Wastewater, Dustin R. Resz

Chemical Engineering Undergraduate Honors Theses

Approximately 1.2 billion people around the world live in areas of physical water scarcity. This could increase to half of the world’s population by 2030 and could displace 24 to 700 million people unless steps are taken to ensure adequate water supply.1 Water scarcity is an escalating issue within the United States, specifically in Western inland states with arid climates. This scarcity is encouraging communities to investigate tertiary level municipal wastewater treatment, allowing for reuse of wastewater. Unfortunately, wastewater contains numerous contaminants that are not regulated by the Environmental Protection Agency (EPA) under the Safe Drinking Water Act (SDWA). Many …

Werc Task #1 - Efficiency And Particulate Matter Emissions Testing Of Wood Burning Heating Units, Jonathan A. Shumaker

Chemical Engineering Undergraduate Honors Theses

A design of a method for calculating the efficiency and particulate matter emission rates was developed for use on wood stoves. The project was completed for the WERC competition which is an international design contest. The prevalence of wood burning as a form of heating, current EPA regulations, and current market conditions were major factors in forming the necessity of this testing method. Design was not limited to outlining the design specifications, the apparatus was built and run. Optimization of the method continued until completion of the project. If the method would continue to be improved then it would be …

Optimizing Chemical & Rheological Properties Of Rejuvenated Bitumen, Dominic Nguyen, Hamzeh Haghshenas Fatmehsari, Santosh Kommidi, Yong-Rak Kim

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

Bitumen has long been a material used in the construction of roadways, yet new pavement only consists of low fractions of recycled materials due to poor compatibility of aged bitumen and new materials. Thus, rejuvenators, chemical additives, have been used in an attempt to re-balance the chemical composition and restore the physical properties of aged bitumen back to its virgin state. A fundamental understanding of how one particular rejuvenator, soybean oil, revitalizes bitumen was investigated using a multi-scale approach.

Fourier-transform infrared spectroscopy (FTIR) was used to determine the changes in chemical properties of pure and rejuvenated virgin and aged samples. …

Methane Emissions As Energy Reservoir: Context, Scope, Causes And Mitigation Strategies, Xiaoli Chai, David J. Tonjes, Devinder Mahajan

Technology & Society Faculty Publications

Methane (CH4) is now considered a bridge fuel between present fossil (carbon) economy and desired renewables and this energy molecule is projected to play an important role in the global energy mix well beyond 2035. The atmospheric warming potential of CH4 is 28-36 times, when averaged over a 100-year period, that of carbon dioxide (CO2) and this necessitates a close scrutiny of global CH4 emissions inventory. As the second most abundant greenhouse gas (GHG), the annual global CH4 emissions were 645 million metric tons (MMT), accounting for 14.3% of the global anthropogenic GHG emissions. Of this, five key anthropogenic sources: …

State-Of-The-Art Review Of Cathodic Protection For Reinforced Concrete Structures, Aimee Byrne, Niall Holmes, Brian Norton

Articles

Cathodic protection (CP) limits the corrosion of a metal surface by making it the cathode of an electrochemical cell. This can be achieved either by using a more active sacrificial anode to create a driving current, or by using inert anodes and impressing a current onto the cathode surface using an external direct current (DC) source. Impressed current cathodic protection (ICCP) is preferred where widespread protection is required, particularly in reinforced concrete structures. ICCP needs a constant DC power supply that is usually provided through a grid connection or independent generators. This paper presents the currently available CP systems for …

An Overview Of The Development Of Cement-Based Batteries For The Cathodic Protection Of Embedded Steel In Concrete, Aimee Byrne, Niall Holmes, Brian Norton

Conference papers

This paper presents an overview of the cement-based batteries developed in DIT for use in the cathodic protection of embedded steel in reinforced concrete undergoing chloride-induced corrosion. Cathodic protection delivers an external current (approximately 20mA per m2 of embedded steel) which effectively polarises the internal current generated during corrosion. The batteries developed in DIT comprise of a cement-based electrolyte containing different additives including sand, aggregate, salts, carbon black and plasticiser with protruding anode and cathode metal plates. These batteries produced an initial electrical output of 1.5V and 23mA through a 10 resistor as measured using data acquisition units and a …

Production And Harvest Of Microalgae In Wastewater Raceways With Resource Recycling, Alexander Colin Roberts

Master's Theses

Microalgae can be grown on municipal wastewater media to both treat the wastewater and produce feedstock for algae biofuel production. However the reliability of treatment must be demonstrated, as well as high areal algae productivity on recycled wastewater media and efficient sedimentation harvesting. This processes was studied at pilot scale in the present research.

A pilot facility was operated with nine CO₂-supplemented raceway ponds, each with a 33-m² surface area and a 0.3-m depth, continuously from March 6, 2013 through September 24, 2014. The ponds were operated as three sets of triplicates with two sets continuously fed …

Sustainable Disposal Of Coal Processing Waste Streams, Mohammad Rezaee

Theses and Dissertations--Mining Engineering

Modern coal preparation facilities incorporate a wide array of solid-solid and solid-liquid separation processes for rejecting mineral matter to meet market specifications. The coarse mineral matter is typically placed into engineered refuse piles whereas the fine refuse is either stored in impoundments or co-disposed with the coarse refuse. The discharge water from the refuse material represents an environmental concern due to the potential release of trace elements, and the subsequent elevation of total dissolved solids and conductivity. The research findings reported in this dissertation addresses sustainable coal processing waste disposal through using strategies aimed at minimizing the environmental impacts. To …

Development Of Cementitious Materials For Adhesion Type Applications Comprising Calcium Sulfoaluminate (Csa) Cement And Latex Polymer, Joshua V. Brien

Theses and Dissertations--Civil Engineering

The objective of this research was to develop high performing polymer modified calcium sulfoaluminate (CSA) cement materials for use in applications requiring superior adhesion characteristics. Little information is available describing interactions of CSA cement containing minor phase tri-calcium aluminate (C₃A) with commonly used admixtures. Given the scarcity of information, a basic approach for developing cementitious materials was followed. The basic approach consisted of four tasks: cement design, admixture design, polymer design and testing developed materials. The iterative, time consuming process is necessary for understanding the influence of specific constituent components on overall system behavior. Results from the cement …

Development Of Strategies To Minimize The Release Of Trace Elements From Coal Waste Sources, Mohammad Rezaee

Theses and Dissertations--Mining Engineering

To assess strategies aimed at minimizing the release of trace elements and the impact of disposal of coal waste materials on the environment, two long-term leaching experiments of up to five months duration were performed using waste materials from two plants cleaning high and low sulfur bituminous coal. The tests evaluated the mobility of major trace elements under different disposal scenarios: (i) a static leaching test designed to simulate the quiescent conditions encountered by coal waste material stored under water in a stable impoundment, and (ii) a dynamic test to simulate waste materials exposed to the atmosphere, either in variable …

The Impact Of Driving Conditions On Phev Battery Performance, Nathan Christensen, John Patten, Steven Srivastava, Gary P. Nola

Green Manufacturing Research Journal

The battery performance of a modified Prius with a 5 kWh plug-in battery was documented for a year to determine the impact of environmental conditions and user attributes on vehicle performance.  Both fuel economy and pure electrical efficiency were compared to ambient temperature.  The fuel economy has a positive relationship with ambient temperature until approximately 70˚F where the efficiency begins to drop.  Electrical performance has a positive linear relationship with ambient temperature.  With the emergence of electric vehicles (EVs) and PHEVs from a variety of automotive manufacturers, information on EV and PHEV performance for consumers will become more important.

The Effects Of Electricity Pring On Phev Competitiveness, Shisheng Huang, Bri-Mathias S. Hodge, Farzad Taheripour, Joseph F. Pekny, Gintaras V. Reklaitis, Wallace E. Tyner

PPRI Digital Library

Plug-in Hybrid Electric Vehicles (PHEVs) will soon start to be introduced into the transportation sector, thereby raising a host of issues related to their use, adoption and effects on the electricity sector. Their introduction has the potential to significantly reduce carbon emissions from the transportation sector, which has led to government policies aimed at easing their introduction. If their wide-spread adoption is set as a target it is imperative to consider the effects of existing policies that may increase or decrease their adoption rate. In this study, we present a micro level electricity demand model that can gauge the effects …