Complex Fluids Commons^™

Scaling Nonreactive Cross Flow Over A Heated Plate To Simulate Forest Fires, Nikolay Gustenyov, Nelson Akafuah, Ahmad Salaimeh, Mark A. Finney, Sara Mcallister, Kozo Saito

Institute of Research for Technology Development Faculty Publications

The paper reports visualization of the flow of smoke over a flat surface inside of a low-speed wind tunnel. A heating plate flush mounted on the wind tunnel floor simulated a spreading line fire that produces uniform heat flux under constant wind speed condition. A paper-thin cloth was soaked with commercially available Vaseline and placed on top of the heating plate; when it is heated, it produced thick white smoke, ideal for flow visualization. Two sides and top of the wind tunnel were made of a trans- parent acrylic sheet that enabled LED and laser sheet light illumination of the …

Development Of Microdialysis Probes In Series Approach Toward Eliminating Microdialysis Sampling Calibration: Miniaturization Into A Pdms Microfluidic Device, Randy Espinal Cabrera

Graduate Theses and Dissertations

A new microdialysis sampling method and microfluidic device were developed in vitro. The method consisted of using up to four microdialysis sampling probes connected in series to evaluate the relative recovery (RR) of different model solutes methyl orange, fluorescein isothiocyanate (FITC)-dextran average mol. wt. 4,000 (FITC-4), FITC-10, FITC-20, and FITC-40. Different flow rates (0.8, 1.0, and 1.5 µL/min) were used to compare experimentally observed relative recoveries with theoretical estimations. With increasing the number of probes in series, the relative recovery increases and ~100% (99.7% ± 0.9%) relative recovery for methyl orange was obtained. For larger molecules such as fluorescein isothiocyanate …

Mobility Of Nano-Particles In Rock Based Micro-Models, Jagannath Upadhyay

LSU Doctoral Dissertations

A confocal micro-particle image velocimetry (C-μPIV) technique along with associated post-processing algorithms is detailed for obtaining three dimensional distributions of nano-particle velocity and concentrations at select locations of the 2.5D (pseudo 3D) Poly(methyl methacrylate) (PMMA) and ceramic micro-model. The designed and fabricated 2.5D micro-model incorporates microchannel networks with 3D wall structures with one at observation wall which resembles fourteen morphological and flow parameters to those of fully 3D actual reservoir rock (Boise Sandstone) at resolutions of 5 and 10 μm in depth and 5 and 25 μm on plane. In addition, an in-situ, non-destructive method for measuring the geometry of …

Intermittency Effects On The Universality Of Local Dissipation Scales In Turbulent Boundary Layer Flows With And Without Free-Stream Turbulence, Sabah Falih Habeeb Alhamdi

Theses and Dissertations--Mechanical and Aerospace Engineering

Measurements of the small-scale dissipation statistics of turbulent boundary layer flows with and without free-stream turbulence are reported for Re_τ ≈ 1000 (Re_θ ≈ 2000). The scaling of the dissipation scale distribution is examined in these two boundary conditions of external wall-bounded flow.

Results demonstrated that the local large-scale Reynolds number based on the measured longitudinal integral length-scale fails to properly normalize the dissipation scale distribution near the wall in these two free-stream conditions, due to the imperfect characterization of the upper bound of the inertial cascade by the integral length-scale. When a length-scale based on Townsend's …

Effects Of Hofmeister Ions On Gelation Of Gelatin And Pluronic Hydrogels, Eric Britton

Williams Honors College, Honors Research Projects

The purpose of the project was to observe the effects of the Hofmeister series of ions on the gelation of gelatin and Pluronic-127 hydrogels. Hydrogels are semi-solid materials that contain a network of joined molecules through intermolecular interactions which are capable of holding water. Gelatin and Pluronic-127 (PF-127) are thermoreversible, physical crosslinked gels. Gelation occurs when temperature, or other driving forces, reduce the polymer chain solubility until a distinct 2-phase system forms. When aqueous ions are present in solution, they exhibit specific ion effects that have either a stabilizing or destabilizing effect on the solubility of proteins and other polymers. …

Modeling The Effect Thickener Structure Has On The Oil Release Of Grease, Dana Cressman

Williams Honors College, Honors Research Projects

Our hypothesis was that the thickener type and micelle concentration of grease affected its viscoelastic properties. Measurements were made using a TA AR G2 rheometer and calculations were made using TA rheometer analysis software to characterize the viscoelastic response of grease under oscillatory shear and frequency tests. The oscillatory frequency tests determined the critical micelle concentration. The oscillatory stress tests were taken at temperatures from 5 to 65 degrees Celsius to create a master curve based on time temperature superposition of the measurements. The crossover points of G’ and G” on the oscillatory stress tests demonstrated where the grease transitions …

Developing A 3d In Vitro Model By Microfluidics, Hung-Ta Chien

Dissertations and Theses

In vitro tissue models play an important role in providing a platform that mimics the realistic tissue microenvironment for stimulating and characterizing the cellular behavior. In particular, the hydrogel-based 3D in vitro models allow the cells to grow and interact with their surroundings in all directions, thus better mimicking in vivo than their 2D counterparts. The objective of this thesis is to establish a 3D in vitro model that mimics the anatomical and functional complexity of the realistic cancer microenvironment for conveniently studying the transport coupling in porous tissue structures. We pack uniform-sized PEGDA-GelMA microgels in a microfluidic chip to …