Biomaterials Commons^™

Magnetic Heating Efficiency Of Magnetite Nanoparticles: Dependence On Size And Alternating Magnetic Field, Sarah E. Kubican

Theses and Dissertations--Biomedical Engineering

Magnetic heating mediated by magnetic iron oxide nanoparticles (MION) has several clinical applications including cancer thermal therapy, tissue thawing for organ preservation, and magnetogenetics. However, current models of magnetic heating, including the widely used linear response theory, inadequately predict MION heating efficiency. An experimental study covering alternating magnetic field (AMF) strengths and frequencies ranging from 3.98 – 27.85 kA/m and 103.6 – 984.1 kHz, respectively, with a range of MION core diameters 9.5- 30.3 nm was conducted to elucidate the relationships between these AMF parameters and MION sizes and the resulting heating efficiencies. Heating efficiency was found to increase approximately …

Development Of Iron Oxide Nanozyme For Cancer Therapy, Zhongchao Yi

Theses and Dissertations--Biomedical Engineering

Cancer therapies that leverage reactive oxygen species (ROS) have shown potential for cancer inhibition due to their ability to induce oxidative stress in tumor cells. Iron oxide nanoparticles (IONPs) have garnered significant attention as a promising platform for ROS-dependent disease treatment, owing to their remarkable biocompatibility and Fenton catalytic activity. However, the low catalytic activity of IONPs has been a major hurdle in their clinical translation. To overcome this challenge, IONPs of different compositions are examined for their Fenton reaction under pharmacologically relevant conditions in this work. The results show that wüstite (Fe_1-xO) nanoparticles exhibit higher catalytic activity …

3-Dimensional Muscle Constructs: Using Hydrogels In Order To Model The Effects Of Exercise In Disease Conditions, Mark Mchargue

Theses and Dissertations--Biomedical Engineering

Currently, there is no standard in vitro model for studying the effects of mechanical stimulation on muscle in type II diabetes. Existing models primarily utilize electrical stimulation, which does not fully recapitulate the effects of exercise. In this thesis, we create a standardized in vitro model of murine muscle that can recapitulate the benefits seen in exercise when mechanically stimulated. Moreover, we show that a type II diabetes environment has similar effects on the muscle in vitro as well as in vivo.

An Electrochemical, Fluidic, Chip-Based Biosensor For Biomarker Detection, Lauren Bell

Theses and Dissertations--Biomedical Engineering

Biosensors and their use in both the research and clinical field for the detection and monitoring of critical biomarkers are prevalent and constantly improving. However, continued research needs to be done to address shortcomings, such as low sensitivity, poor specificity, and poor readiness for integration into research use and patient care. The objective of this research was to create a combined fluidic, chip-based biosensor that could detect different biomarkers with high sensitivity and ease of use. For assessing the developed sensor, three separate biomarkers were tested: glucose, cholesterol, and oxygen. Both the glucose biosensor and cholesterol biosensor were combined with …

Synthesis And Characterization Of Blue Light Poly(Β-Amino Ester)S, Nicholas John Kohrs

Theses and Dissertations--Biomedical Engineering

Volumetric muscle loss (VML) is a debilitating injury which results in full or partial loss of function. Current clinical options utilize tissue grafts and bracing to restore function. Tissue graft implantation oftentimes leads to serious complications, some of which end in graft rejection and thereby necessitate further surgeries and procedures. Polymeric scaffolds show promise as scaffolding systems due to their mechanical properties and overall degradation profiles. Scaffolds need appropriate mechanical properties, 10-60 kPa modulus, and overall degradation times, five days to two weeks, to initiate tissue regeneration. Poly(β-amino ester)s (PBAE), a class of synthetic polymers, act as a safe biocompatible …

Synthesis And Characterization Of Poly(Simvastatin) - Incorporated Copolymers And Blends For Bone Regeneration, Theodora Asafo-Adjei

Theses and Dissertations--Biomedical Engineering

Common biodegradable polyesters such as poly(lactic acid) (PLA), poly(lactic-co-glycolic acid) (PLGA) and poly(ε-caprolactone) (PCL) are used as drug delivery vehicles for tissue regenerative applications. However, they are typically bioinert, with drug loading limitations. Polymerizing the active agent or precursor into its respective biodegradable polymer would control drug loading via molar ratios of drug to initiator used for synthesis. Simvastatin was chosen due to its favorable anti-inflammatory, angiogenic, and osteogenic properties. In addition, its lactone ring lends itself to ring-opening polymerization and, consequently, the synthesis of poly(simvastatin) with controlled simvastatin release.

Simvastatin was first polymerized with a 5kDa methyl-terminated poly(ethylene glycol) …

Layered, Flexible Drug Delivery Films For The Prevention Of Fibrotic Scar Tissue Formation, Cheryl L. Rabek

Theses and Dissertations--Biomedical Engineering

Open wounds account for about 50% of military injuries and 10% of non‐fatal traffic injuries. Scar tissue formation in these wounds may be reduced or prevented if treated with a combination of molecules whose release is tuned to the healing phases. The goal of this research was to develop flexible, layered drug delivery films for sequential, localized release of anti‐inflammatory, anti‐oxidant, and anti‐fibrotic molecules to soft tissue.

Films were composed of cellulose acetate phthalate (CAP) and Pluronic F‐127 (Pluronic). To impart flexibility, plasticizers, triethyl citrate (TEC) or tributyl citrate (TBC), were added. Mechanical analysis was performed on films as prepared …

A Local, Sustained Delivery System For Zoledronic Acid And Rankl-Inhibitory Antibody As A Potential Treatment For Metastatic Bone Disease, Rohith Jayaram

Theses and Dissertations--Biomedical Engineering

Cancerous solid tumors can migrate and lead to metastatic bone disease. Drugs prescribed to reduce bone resorption from metastasis, such as zoledronic acid and the RANKL-inhibitory antibody Denosumab, cause side effects such as osteonecrosis of the jaw when delivered systemically. This project used two biocompatible materials, acrylic bone cement (PMMA) and poly(lactic-co-glycolic acid) (PLGA), to incorporate and sustain release of anti-resorptive agents. Results showed similar mechanical properties for acrylic bone cements loaded up to 6.6% drug by weight. Results showed sustained zoledronic acid release for 8 weeks from both systems, with PMMA releasing up to 22% of loaded drug and …

Long Term Blood Oxygenation Membranes, Joseph V. Alexander

Theses and Dissertations--Biomedical Engineering

Hollow fiber membranes are widely used in blood oxygenators to remove carbon dioxide and add oxygen during cardiopulmonary bypass operations. These devices are now widely used off-label by physicians to perform extracorporeal blood oxygenation for patients with lung failure. Unfortunately, the hollow fiber membranes used in these devices fail prematurely due to blood plasma leakage and gas emboli formation.

This project formed ultrathin (~100nm) polymer coatings on polymer hollow fiber membranes. The coatings were intended to “block” existing pores on the exterior surfaces while permitting high gas fluxes. This coating is synthesized using surface imitated control radical polymerization.

The coating …

Microsphere Spray System For Wound Coverage, Nicholas J. Andersen

Theses and Dissertations--Biomedical Engineering

Spinal fusion is used to treat diseases or disorders of the spine by fusing together two or more vertebrae. Two associated risks with spinal fusion are infection and blood loss. Administration of tranexamic acid is used to prevent blood loss, and transfusions are given following blood loss. Surgical site infections are prevented with vancomycin powder spread into the surgical wound, while established infections are treated by debridement and delivery of antibiotics for 4 to 6 weeks. The present research explored an alternate method to prevent and treat blood loss or infection in spinal fusion. Poly(lactic-co-glycolic acid) (PLGA) microspheres was used …

Development Of A Moldable Composite Bone Graft Substitute Releasing Antibacterial And Osteogenic Drugs, Matthew E. Brown

Theses and Dissertations--Biomedical Engineering

Large infected bone defects (IBD) are very complicated to treat due to their high variability; they often require multiple procedures. Bone autografts are the gold standard for treatment but have several drawbacks, such as a need for a second surgery site, limited grafting material, and donor site morbidity. The objective of this research was to develop a moldable synthetic bone grafting material capable of releasing both antimicrobial and osteogenic drugs over a clinically relevant time course for the treatment of IBDs. Current treatment methods for large IBDs require two separate procedures to treat the bone defect and the infection.

This …

Bioerodible Calcium Sulfate Bone Grafting Substitutes With Tailored Drug Delivery Capabilities, Bryan R. Orellana

Theses and Dissertations--Biomedical Engineering

Bone regeneration or augmentation is often required prior to or concomitant with implant placement. With the limitations of many existing technologies, a biologically compatible synthetic bone grafting substitute that is osteogenic, bioerodible, and provides spacing-making functionality while acting as a drug delivery vehicle for bioactive molecules could provide an alternative to ‘gold standard’ techniques.

In the first part of this work, calcium sulfate (CS) space-making synthetic bone grafts with uniformly embedded poly(β-amino ester) (PBAE) biodegradable hydrogel particles was developed to allow controlled release of bioactive agents. The embedded gel particles’ influence on the physical and chemical characteristics of CS was …

Mucoadhesive Films For Treatment Of Local Oral Disorders: Development, Characterization And In Vivo Testing, Sandeep K. Ramineni

Theses and Dissertations--Biomedical Engineering

Mucoadhesive drug delivery systems which are being used from 1980’s to avoid first pass metabolism of drugs, commercially exist for only systemic drug delivery with fast erosion times (15-60 min), that may not be appropriate for local oral disorders. The goal of this research was to develop and characterize mucoadhesive films with flexibility of carrying different drugs and proteins and provide sustained release for local treatment of oral disorders.

Mucoadhesive films composed of polyvinylpyrrolidone (PVP) and carboxymethlycellulose (CMC) were formulated with imiquimod, an immune response modifier. Problems such as solubilization of imiquimod to increase drug loading, uniformity in films and …

Additives To Control Mechanical Properties And Drug Delivery Of Injectable Polymeric Scaffolds, Paul Fisher

Theses and Dissertations--Biomedical Engineering

In situ forming implants (ISIs) are popular due to their ease of use and local drug delivery potential, but they suffer from high initial drug burst, and release behavior is tied closely to solvent exchange and polymer properties. Additionally, such systems are traditionally viewed purely as drug delivery devices rather than potential scaffold materials due to their poor mechanical properties and minimal porosity. The aim of this research was to develop an injectable ISI with drug release, mechanical, and microstructural properties controlled by micro- and nanoparticle additives.

First, an injectable ISI was developed with appropriate drug release kinetics for orthopedic …

Development Of A Multilayered Association Polymer System For Sequential Drug Delivery, Sharath Kumar Chinnakavanam Sundararaj

Theses and Dissertations--Biomedical Engineering

As all the physiological processes in our body are controlled by multiple biomolecules, comprehensive treatment of certain disease conditions may be more effectively achieved by administration of more than one type of drug. Thus, the primary objective of this research was to develop a multilayered, polymer-based system for sequential delivery of multiple drugs. This particular device was designed aimed at the treatment of periodontitis, a highly prevalent oral inflammatory disease that affects 90% of the world population. This condition is caused by bacterial biofilm on the teeth, resulting in a chronic inflammatory response that leads to loss of alveolar bone …

Growth Plate Regeneration Using Polymer-Based Scaffolds Releasing Growth Factor, Amanda Clark

Theses and Dissertations--Biomedical Engineering

Currently growth plate fractures account for nearly 18.5% of fractures in children and can lead to stunted bone growth or angular deformation. If the body is unable to heal itself a bony bar forms, preventing normal bone growth. Clinical treatment involves removing the bony bar and replacing it with a filler substance, which causes poor results 60% of the time.

Using primarily poly(lactic-co-glycolic acid) (PLGA) as the scaffold material, the goal was to develop an implant that would support to the implant site, allow for cell ingrowth, and degrade away over time. Porous scaffolds were fabricated from PLGA microspheres using …