Systems Engineering and Multidisciplinary Design Optimization Commons^™

A Systematic Study Into The Design And Utilization Of Burn Wire As A Means Of Tensioning And Releasing Spacecraft Mechanisms Through Applied Joule Heating, Chandler Dye

Mechanical Engineering Undergraduate Honors Theses

The joule heating characteristics of Nichrome burn wires, often used as a thermal cutting device in mechanisms designed to fasten and release CubeSat deployables, are examined in the following thesis. Wires ranging from 0.125 inches to 2 inches long, and diameters of 30 Ga and 40 Ga, are investigated through analytical calculations and thermal simulations based on heat transfer due to joule heating, and through physical circuitry-based experiments. The temperature data is used to generate heating curves to predict the time it takes for Nichrome wires to fail under varying testing parameters. This research aims to catalog a series of …

Project Management And Systems Engineering Framework For Educational Cubesat Missions, Bailey Garrett

Master's Theses

The rising complexity of CubeSat missions and the unique challenges faced by educational CubeSat programs lead to high rates of mission failure. Implementing project management and systems engineering practices can alleviate these challenges and improve mission success rates for educational CubeSat developers. However, existing project management and systems engineering resources are too cumbersome and often assume the student has a base-level understanding of project management and systems engineering fundamentals. A new universal project management and systems engineering framework was created and tailored specifically to the needs of an educational CubeSat mission. The framework was designed to accommodate first-time CubeSat developers, …

Satellite Tt&C For Cubesats With Applications For Grissom-1, Michael J. Bittle

Theses and Dissertations

This thesis describes the assessment and analysis performed to characterize the communication subsystem used for command and telemetry transmission in support of the Grissom-1 Mission (GM1). The GM1 is unique in that it represents the pathfinder for a standardized 6U bus that serves as the basis for future CubeSat missions to host a variety of technical and scientific payloads, as prioritized by the Department of Defense, requiring flight demonstration or access to the orbital environment. Lab-based testing within an anechoic chamber provided link margin data required to characterize the command and telemetry links of the GM1. Experimental data describing the …

Development Of A Cubesat Conceptual Design Tool And Implementation Of The Eps Design Module, Sean K. Nogrady

Master's Theses

This thesis is the product of an effort to develop a CubeSat Conceptual Design Tool for the California Polytechnic State University CubeSat Laboratory. Such a tool is necessary due to inefficiencies with the current conceptual design process. It is being developed to increase accessibility, reduce design time, and promote good systems engineering within CubeSat development.

The development of the architecture of a conceptual design tool, the core user-interface element, and the completion of a module for the electrical power subsystem is the focus of this thesis. The architecture is built around different modules to design different subsystems that work in …

Cubesat Development Framework, William D. Sousa

Theses and Dissertations

AFITs Center for Space Research and Assurance (CSRA) has developed several small satellites without a detailed developmental framework in place but future work will focus on CubeSat development with the intent of managing multiple builds concurrently. With the goal of each satellite being completed in three years, a comprehensive process needs to be established. Research revealed that the Department of Defense (DoD), U.S. Air Force (USAF), and National Aeronautics and Space Administration (NASA) guidance on the acquisition and systems engineering processes require more reviews and deliverables than appropriate for CSRAs projects. The development processes from other universities divulge some aspects …

A Reference Architecture For Rapid Cubesat Development, Sean R. Kelly

Theses and Dissertations

The CubeSat class of nanosatellites has lowered the barrier of entry to space and has rapidly gained popularity in recent years. To successfully design a CubeSat system in a rapid cycle conducive to academic timelines, a Reference Architecture geared towards University CubeSat development would be helpful. A Reference Architecture would speed up the development process by providing a template, capturing previous work and lessons learned from subject matter experts, providing a framework to focus on the CubeSats design rather than the fine details of modeling software. A Reference Architecture can also add functionality that student teams could use and improve …

Comparison Of Decision Analysis Methods For A Cubesat Propulsion System, Jared L. Pilcher

Theses and Dissertations

Low Earth Orbit (LEO) is becoming an increasingly congested orbital regime. As a result, propulsion systems on CubeSats are becoming a more desirable feature to provide them with collision avoidance capabilities. To date, there have been very few CubeSat launches with a propulsion system on them. Due to the relatively high cost of a propulsion system compared to the budget of small educational organizations, a decision analysis model is needed so that these organizations can make the best decision between whether to purchase a Commercial-Off-The-Shelf (COTS) product or to develop one within the organization. This research applies three decision analysis …

Design Of A Martian Communication Constellation Of Cubesats, Scott J. Pirkle

Master's Theses

Spacecraft operating on the Martian surface have used relay satellites as a means of improving communication capabilities, mainly in terms of bandwidth and availability. However, the spacecraft used to achieve this have been large spacecraft (1000s of kilograms) and were not designed with relay capability as the design priority. This thesis explores the possibility of using a CubeSat-based constellation as a communications network for spacecraft operating on the Martian surface. Brute-force techniques are employed to explore the design space of possible constellations. An analysis of constellation configurations that provide complete, continuous coverage of the Martian surface is presented. The stability …

A Reference Architecture For Cubesat Development, Luke J. Farrell

Theses and Dissertations

Developing a space vehicle is a complex and detailed process, and while CubeSats are smaller and more accessible than traditional satellites the design process is relatively unchanged. Creating a viable space vehicle design requires detailed analysis of a set of mission needs in order to define the mission, with this need set used to then create the specific mission requirements. These requirements are used to formulate a concept of operations, and then move into developing a physical system for executing the mission. The successful production of CubeSats within an organization is contingent upon the accurate execution of the general CubeSat …

Exploring The Concept Of A Deep Space Solar-Powered Small Spacecraft, Kian Guillaume Crowley

Master's Theses

New Horizons, Voyager 1 & 2, and Pioneer 10 & 11 are the only spacecraft to ever venture past Pluto and provide information about space at those large distances. These spacecraft were very expensive and primarily designed to study planets during gravitational assist maneuvers. They were not designed to explore space past Pluto and their study of this environment is at best a secondary mission. These spacecraft rely on radioisotope thermoelectric generators (RTGs) to provide power, an expensive yet necessary approach to generating sufficient power. With Cubesats graduating to interplanetary capabilities, such as the Mars-bound MarCO spacecraft, matching the modest …

Alternative Mission Concepts For The Exploration Of Outer Planets Using Small Satellite Swarms, Andrew Gene Blocher

Master's Theses

Interplanetary space exploration has thus far consisted of single, expensive spacecraft missions. Mission costs are particularly high on missions to the outer planets and while invaluable, finite budgets limit our ability to perform extensive and frequent investigations of the planets. Planetary systems such as Jupiter and Saturn provide extremely complex exploration environments with numerous targets of interest. Exploring these targets in addition to the main planet requires multiple fly-bys and long mission timelines. In LEO, CubeSats have changed the exploration paradigm, offering a fast and low cost alternative to traditional space vehicles. This new mission development philosophy has the potential …

Integration And Qualification Of The P-Pods On The Vega Maiden Flight, Ryan Nugent

Master's Theses

On February 13, 2012, California Polytechnic State University, San Luis Obispo flew three Poly-Picosatellite Orbital Deployers (P-PODs), carrying seven European University CubeSats sponsored by the European Space Agency (ESA), on the Vega Maiden Flight. This was the first time CubeSats shared a ride to space with other payloads on an ESA-owned launch opportunity. In order to meet launch requirements, it must be proven through proper documentation that the P-POD would operate properly and not interfere with the launch vehicle or other payloads on the mission. This thesis outlines the program flow, required documentation, and issues encountered during the launch campaign …

Sysml Based Cubesat Model Design And Integration With The Horizon Simulation Framework, Shaun Luther

Master's Theses

This thesis examines the feasibility of substituting the system input script of Cal Poly’s Horizon Simulation Framework (HSF) with a Model Based Systems Engineering (MBSE) model designed with the Systems Modeling Language (SysML). A concurrent student project, SysML Output Interface Creation for the Horizon Simulation Framework, focused on design of the HSF Translator Plugin which converts SysML models to an HSF specific XML format. A SysML model of the HSF test case, Aeolus, was designed. The original Aeolus HSF input script and the translated SysML input script retained the format and dependency structure required by HSF. Both input scripts …

Tesseract, Edgar Uribe, Vanessa Faune

Mechanical Engineering

PolySat is a student-run, Cal Poly research program in which students develop small satellites, known as CubeSats, to be sent into space. Since the start of the program in 2000, PolySat has developed eight 10cm x 10cm x10cm CubeSats. Recently, the team has developed two satellites of double, and triple, that size for NASA-KSC & AI-Solutions and the National Science Foundation. The recent volumetric expansion has been driven by high demand for further satellite functionality, which necessitates large power generation capabilities. To remain competitive in the growing CubeSat industry, PolySat must develop a platform that can provide enough power to …

Development Of Safety Standards For Cubesat Propulsion Systems, Liam Jon Cheney

Master's Theses

The CubeSat community has begun to develop and implement propulsion systems. This movement represents a new capability which may satisfy mission needs such as orbital and constellation maintenance, formation flight, de-orbit, and even interplanetary travel. With the freedom and capability granted by propulsion systems, CubeSat providers must accept new responsibilities in proportion to the potential hazards that propulsion systems may present.

The Cal Poly CubeSat program publishes and maintains the CubeSat Design Specification (CDS). They wish to help the CubeSat community to safety and responsibly expand its capabilities to include propulsive designs. For this reason, the author embarked on the …

Day/Night Band Imager For A Cubesat, Eric Stanton

Electrical Engineering

Day/Night Band (DNB) earth sensing and meteorological systems like the Defense Meteorological Satellite Program (DMSP) Operational Linescan System (OLS) provide visible wavelength imagery 24 hours a day that is used primarily for cloud imaging in support of weather forecasting. This paper describes a compact push-broom imager that meets low light imaging requirements for DMSP OLS and the NOAA/NASA Joint Polar Satellite System (JPSS) as documented in the Integrated Operational Requirements Document [1] (IORD) including the imager design, system level concepts of operation for data collection, radiometric and spatial calibration, and data transmission to Earth. This small, lightweight imager complies with …

Cubesat Mission Planning Toolbox, Brian Castello

Master's Theses

We are in an era of massive spending cuts in educational institutions, aerospace companies and governmental entities. Educational institutions are pursuing more training for less money, aerospace companies are reducing the cost of gaining ight heritage and the government is cutting budgets and their response times. Organizations are accomplishing this improved efficiency by moving away from large-scale satellite projects and developing pico and nanosatellites following the CubeSat specifications. One of the major challenges of developing satellites to the standard CubeSat mission requirements is meeting the exceedingly tight power, data and communication constraints.

A MATLAB toolbox was created to assist the …

Pico-Satellite Integrated System Level Test Program, Marcus A. Ruddy

Master's Theses

Testing is an integral part of a satellite’s development, requirements verification and risk mitigation efforts. A robust test program serves to verify construction, integration and assembly workmanship, ensures component, subsystem and system level functionality and reduces risk of mission or capability loss on orbit.

The objective of this thesis was to develop a detailed test program for pico-satellites with a focus on the Cal Poly CubeSat architecture. The test program established a testing baseline from which other programs or users could tailor to meet their needs. Inclusive of the test program was a detailed decomposition of discrete and derived test …

Development Of Cubesat Vibration Testing Capabilities For The Naval Postgraduate School And Cal Poly San Luis Obispo, Marissa Brummitt

Master's Theses

The Naval Postgraduate School is currently developing their first CubeSat, the Solar Cell Array Tester CubeSat, or NPS-SCAT. Launching a CubeSat, such as NPS-SCAT, requires environmental testing to ensure not only the success of the mission, but also the safety of other CubeSats housed in the same deployer. This thesis will address the development of CubeSat vibration testing methodology at NPS, including subsystem testing, engineering unit qualification, and flight unit testing. In addition, the new Cal Poly CubeSat Test POD Mk III will be introduced and evaluated based upon comparison with the Poly Picosatellite Orbital Deployer (P-POD). Using examples from …