Systems Engineering and Multidisciplinary Design Optimization Commons^™

A Top-Down Performance Analysis Of A Pegasus-Based Space Strike System, Douglas E. Collins

Theses and Dissertations

The feasibility of using Pegasus launch vehicle as a conventional weapons platform is examined. Using a top-down approach, the analysis addresses the fundamental question of whether such a system should be considered for development. The measures of effectiveness considered are delivery range, probability of destroying the target, and responsiveness. Each of the measures is assessed at its top-level and analyzed only to the level of detail needed to address the fundamental question. The study indicates that attaining a high probability of destroying the target requires extremely precise control over the burnout conditions and that the system must be on constant …

Maximum Likelihood Estimation For Distributed Parameter Models Of Large Beam-Like Structures, Ji Yao Shen

Mechanical & Aerospace Engineering Theses & Dissertations

Proposed large space structures have many characteristics that give an advantage to modeling their structural dynamics by a set of partial differential equations (PDE's). By far, the most effort put forth in studying system identification and control to date has been based on finite element models. Despite its acceptability, such lumped parameter models have inevitable deficiencies primarily because of their complexity. Both approaches are complementary and each should be used where it is most effective. But the fact is that the distributed parameter approach has not been developed to the level of maturity as for the lumped parameter approach.

Motivated …

High Heat Flux Cooling For Spacecraft Electronics, Louis C. Chow, John E. Leland

Office for Research Publications and Presentations

An experimental investigation of flow boiling in a curved channel has been performed to ascertain its value in electronics cooling applications. Results have been obtained for flow velocities of 1 to 5 m/s and subcooling of 0.5 to 40 K. These results were compared to those of straight channel under identical velocity and subcooling conditions. The critical heat flux of the curved channel was found to be greater than that of the straight channel. In some cases the increase was found to be marginal, however. An unexplained temperature shift in the nucleate boiling regime was experienced during some experiments. Because …