Structures and Materials Commons^™

Finite Element Investigation Into The Dynamic Instability Characteristics Of Laminated Composite Panels, Walter W. Taylor Jr.

Theses and Dissertations

Dynamic instability of a laminated composite panel subjected to a transverse load is studied. Up to cubic variations in the thickness coordinate are included in the inplane displacement field, and only the constant component is kept in the transverse displacement. The transverse shear strains retain only linear displacement terms and vary parabolically through the thickness. The complete quadratic displacement functions are included in the inplane strains. A 36 degree of freedom shell element is used to obtain numerical results. The static snap through load vs displacement curve, as well as the critical collapse load, is examined by invoking the Riks …

Material Properties Of Silicon Carbide Fibers With Continuously Applied Sol-Gel Alumina Coatings, Christian C. Daehnick

Theses and Dissertations

An investigation was conducted to determine the effect of non-alpha- alumina coatings applied under varying conditions on some of the properties of silicon carbide fibers. Limited characterization of the coating by optical, scanning electron, and transmitted electron microscopy as well as energy- dispersive x-ray analysis was performed. Tensile tests were used to determine changes in elastic modulus, ultimate strength, and strain to failure of the coated fibers relative to uncoated fibers. The coatings were found to lower the mean value of the measured properties as their thickness increased, but the measurements were not accurate enough to determine if this corresponded …

Investigation Of Direct And Indirect Optimization Algorithms For Aerospace Structures, Harry Hopkins Iii

Theses and Dissertations

This thesis investigated the performance of two direct and two indirect methods of structural optimization. A gradient calculator and overall design system was created with the finite element code FRAME. Three of the methods were employed using this system with the fourth being a commercial available code. The algorithms were applied to two different sized trusses using static constraints and were measured for accuracy, reliability, and efficiency. Results for the problems tested showed the Direct methods were sensitive to starting designs and their performance depended on the proper selection of internal parameters. They were also shown to have a high …

Dynamics And Control Of Two Suspension Mechanisms For Ground-Based Testing Of Space Structures, Joseph E. Wilson

Mechanical & Aerospace Engineering Theses & Dissertations

Two suspension systems which effectively simulate a gravity-free environment are presented. A single degree-of-freedom suspension system utilizing a specially profiled band mechanism in conjunction with a torsional spring is presented to show its feasibility and applicability for use as a ground-based testing device for flexible space structures. The second device, a two degree-of-freedom suspension system consisting of two springs and a folding linkage is presented to show the feasibility as a testing device for suspending space structures on earth.

Problems resulting in unwanted dynamic behavior due to deviations from the design parameters for both systems are addressed. A nonlinear controller …

Integrated Control Of Thermally Distorted Large Space Antennas, Robert H. Tolson

Mechanical & Aerospace Engineering Theses & Dissertations

Studies on controlling the thermal distortion of large space antennae have generally investigated a single orbital position and have optimized actuator locations based on minimizing the RMS surface deviation from the original parabolic shape. One study showed the benefits of directly using far zone electric field characteristics as the performance measure; but, this approach resulted in a nonlinear programming problem. The objective of the current study is to develop an approach to designing a control system that (1) recognizes the time dependence of the distortion and (2) controls variables that are directly related to far field performance in a quadratic …

Extension Of A Noninteractive Reliability Model For Ceramic Matrix Composites, Stephen F. Duffy, Robert C. Wetherhold, Lalit K. Jain

Civil and Environmental Engineering Faculty Publications

In the next decade ceramic composites will increasingly be used as high-temperature components in advanced gas turbines. Ceramic components will allow an increase in the operating temperature of the gas stream (measured by the turbine entry temperature), thereby resulting in greater fuel economy in aerospace and automotive turbine applications. Since these materials will be produced from abundant nonstrategic materials, computational structural mechanics methods are evolving to keep pace with this technology. As a result, establishing protocols for sound design methodology, which is the subject of this technical note, is the focus of much current analytical research.

Our objective was to …

Navier-Stokes Simulations Of Flows About Complex Configurations Using Domain Decomposition Techniques, Kamran Fouladi-Semnani

Mechanical & Aerospace Engineering Theses & Dissertations

An algorithm is developed to obtain numerical simulations of flows about complex configurations composed of multiple and nonsimilar components with arbitrary geometries. The algorithm uses a hybridization of the domain decomposition techniques for grid generation and to reduce the computer memory requirement. Three dimensional, Reynolds-averaged, unsteady, compressible, and complete Navier-Stokes equations are solved on each of the subdomains by a fully-vectorized, finite-volume, upwind-biased, approximately-factored, and multigrid method. The effect of Reynolds stresses is incorporated through an algebraic turbulence model with several modifications for interference flows. The present algorithm combines the advantages of an efficient, geometrically conservative, minimally and automatically dissipative …

An Experimental Study Of An Axisymmetric Turbulent Boundary Layer Disturbed By A Periodic Freestream, Chithrabhanu Koodalattupuram

Mechanical & Aerospace Engineering Theses & Dissertations

Behavior of an axisymmetric equilibrium turbulent boundary layer disturbed by a propeller wake in the freestream was investigated experimentally. Tests were conducted in a low speed wind tunnel and measurements of turbulence quantities were made using an X wire probe and a constant temperature anemometer. The boundary layer flow on a cylindrical body was characterized by measuring its gross parameters and comparing them with classical values. Propeller speed was measured using an electronic circuit whose output signal was also used to trigger hot wire probe. Gross boundary later characteristics of the disturbed boundary layer did not deviate appreciably from the …

Control And Mechanism Interaction For Ground-Based Testing Of Space Structures, Li-Farn Yang

Mechanical & Aerospace Engineering Theses & Dissertations

In the ground-based validation testing, the adverse effect of terrestrial conditions such as a gravitational force interferes with the dynamic behavior of space structures. A suspension system is developed to assess the structural characteristics in a simulated zero-gravity environment. Using a mechanisms approach, the synthesis of a noncircular disk with a torsional spring at its rotational axis is designed to counteract the gravitational force of test structures during the testing.

The multibody dynamics of a flexible steel beam carried on a rigid trolley has been investigated. The system is constructed in such a way that the rapid and large-angle slewing …

An Extension Of Essentially Non-Oscillatory Shock-Capturing Schemes To Multi-Dimensional Systems Of Conservation Laws, Jay Casper

Mathematics & Statistics Theses & Dissertations

In recent years, a class of numerical schemes for solving hyperbolic partial differential equations has been developed which generalizes the first-order method of Godunov to arbitrary order of accuracy. High-order accuracy is obtained, wherever the solution is smooth, by an essentially non-oscillatory (ENO) piecewise polynomial reconstruction procedure, which yields high-order pointwise information from the cell averages of the solution at a given point in time. When applied to piecewise smooth initial data, this reconstruction enables a flux computation that provides a time update of the solution which is of high-order accuracy, wherever the function is smooth, and avoids a Gibbs …