Propulsion and Power Commons^™

Design, Optimization, And Initial Results Of An Automatic Impedance Matching Network For Nitrogen Inductively Coupled Plasma, Logan Anthony Alvesteffer

Masters Theses

The electric propulsion industry is witnessing a strategic interest toward the utilization of molecular propellants as alternatives to noble gases due to increasing cost constraints and logistical requirements. This transition is hindered by a fundamental deficiency in the understanding of molecular plasma and radio frequency physics, including the excitation, dissociation, and ionization cross-sections, which mandates a reliance on computationally inefficient, empirically modified atomic thruster designs. Furthermore, current state-of-the-art electric propulsion devices, such as gridded ion thrusters and Hall effect thrusters, utilize an electrode (cathode) for ionization and are thus susceptible to chemical poisoning and material erosion, which is prevalent while …

Analysis Of The Effects Of Extractor Orientation On The Performance Of An Electrospray System, Hannah Grace Sargent

Masters Theses

In this thesis, a single-emitter porous electrospray thruster was tested at nine different extractor electrode positions. The nine positions were: center, four slightly offset in each cardinal direction, and four significantly offset in each cardinal direction. Slightly offset was defined as ~25% of the distance from the center to the edge of the extractor orifice (~125 ± 2 μm) and significantly offset was defined as ~60% of the distance from the center to the edge of the extractor orifice (~302 ± 2 μm). Three diagnostic measurements were recorded to determine the effect of the extractor electrode position on thruster operation: …

The Design And Development Of A Miniature Gridded Ecr Ion Thruster, Nicholas Nuzzo

Masters Theses

Plasma propulsion, a specific subset of electric propulsion (EP), is a class of space propulsion that produces plasma by excitation of a propellant at or above its ionization energy. This ionized propellant is then accelerated by an externally applied field (magnetic and/or electric) and produces thrust. There is an increasing need for miniaturization in spacecraft technology and the use of plasma EP devices in space propulsion. These systems provide an advantage over traditional chemical propulsion solutions which are less efficient and have more mass. Miniaturization of EP devices allows missions to have more space and mass available for their payloads …

Development Of A Single Emitter Ionic Liquid Ion Source Research Platform, Thomas V. Kerber

Masters Theses

A single emitter ionic liquid ion source using porous borosilicate glass was developed. Two emitters with different radii of curvatures were tested using 1-ethyl-3-methylimidazolium tetrafluoroborate (EMI-BF₄). I-V curves of the currents on the extractor electrode and a collector plate were obtained for potential differences between the emitter and the extractor ranging from 0 V to 3500 V. For the first emitter chip, extraction began near 2400 V. The highest emission current measured on the first chip was 80 µA at 3500 V with an interception current on the extractor of 4.86 µA. An new collector plate was used …

Localization And System Identification Of A Quadcopter Uav, Kenneth Befus

Masters Theses

The research conducted explores the comparison of several trilateration algorithms as they apply to the localization of a quadcopter micro air vehicle (MAV). A localization system is developed employing a network of combined ultrasonic/radio frequency sensors used to wirelessly provide range (distance) measurements defining the location of the quadcopter in 3-dimensional space. A Monte Carlo simulation is conducted using the extrinsic parameters of the localization system to evaluate the adequacy of each trilateration method as it applies to this specific quadcopter application. The optimal position calculation method is determined.

Furthermore, flight testing is performed in which real range measurement data …

The Numerical Solution Of Two-Dimensional Fluid Flow Problems, E. David Spong

Masters Theses

"A numerical solution method is developed for the solution of two-dimensional, irrotational and compressible fluid flow problems. The partial differential equation, in terms of the velocity potential, describing the flow is replaced by finite difference equations and the resulting matrix is solved by Gaussian elimination. The method is successfully applied to two subsonic flow problems: a 7.5⁰ wedge and a 6⁰ wedge inlet. The method becomes invalid, as expected, with the appearance of sonic velocity in the flow field. An investigation of the definition of the singularities is made. This indicates that the best agreement with the experimental results for …