Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Keyword
-
- Autoignition (2)
- Flame Stabilization (2)
- Small Satellites (2)
- Axial flux PM machines (1)
- Binary Thrusters (1)
-
- Co-simulation (1)
- Cube Sat (1)
- Decentralized Control (1)
- Distributed power generation (1)
- Edge Flames (1)
- Electric aircraft (1)
- Electro Magnetic Formation Flying (1)
- Extinction (1)
- Laminar Flames (1)
- Laser Diagnostics (1)
- Mathematical model (1)
- Mixed-Integer Optimization (1)
- Model Predictive Control (1)
- Modular architectures (1)
- Multi-period models (1)
- PCB stator (1)
- Power system optimization (1)
- Premixed Combustion (1)
- Satellite power systems (1)
- Vitiated Flows (1)
Articles 1 - 6 of 6
Full-Text Articles in Propulsion and Power
Simulation-To-Hardware Validation Of Mpc For Binary Thruster 2d Cubesat Control, Aevar Amundinusarson Oefjoerd
Simulation-To-Hardware Validation Of Mpc For Binary Thruster 2d Cubesat Control, Aevar Amundinusarson Oefjoerd
Theses and Dissertations--Mechanical and Aerospace Engineering
Small satellites must execute precise, fuel-limited maneuvers under strict actuation and operational constraints. Model Predictive Control (MPC) is a suitable approach because it optimizes future actions while explicitly enforcing these limits. This work evaluates (1) whether MPC can operate in real time using binary (on/off), asymmetric thrusters, and (2) whether a high-fidelity digital twin can be used to tune and validate the controller prior to hardware testing.
An MPC framework was implemented on a planar satellite prototype that floats on air bearings, operates at 16.7 Hz (60 ms period), and uses eight binary thrusters exhibiting up to 13.2% variation in …
Electric Power Systems And Components For Electric Aircraft, Damien Lawhorn
Electric Power Systems And Components For Electric Aircraft, Damien Lawhorn
Theses and Dissertations--Electrical and Computer Engineering
Electric aircraft have gained increasing attention in recent years due to their potential for environmental and economic benefits over conventional airplanes. In order to offer competitive flight times and payload capabilities, electric aircraft power systems (EAPS) must exhibit extremely high efficiencies and power densities. While advancements in enabling technologies have progressed the development of high performance EAPS, further research is required.
One challenge in the design of EAPS is determining the best topology to be employed. This work proposes a new graph theory based method for the optimal design of EAPS. This method takes into account data surveyed from a …
Flame Stabilization Of A Premixed Jet In Vitiated Coflow, Tyler Owens
Flame Stabilization Of A Premixed Jet In Vitiated Coflow, Tyler Owens
Theses and Dissertations--Mechanical and Aerospace Engineering
Premixed staged combustion in gas turbine engines can reduce emissions by lowering peak flame temperatures but can also lead to different stability characteristics when compared to traditional combustors. High pressure ratio and subsequently high temperatures can lead to conditions suitable for both autoignition and premixed flame propagation in an environment where spatial fuel/air variations are present.
An experimental facility which issues a premixed jet into a coflowing vitiated mixture was studied to examine the stability behavior, resulting in a lifted flame. The effective ignition delay observed flame was much greater than homogeneous ignition delay calculations for the same conditions. It …
Single-Degree-Of-Freedom Experiments Demonstrating Electromagnetic Formation Flying For Small Satellite Swarms Using Piecewise-Sinusoidal Controls, Ajin Sunny
Theses and Dissertations--Mechanical and Aerospace Engineering
This thesis presents a decentralized electromagnetic formation flying (EMFF) control method using frequency-multiplexed sinusoidal control signals. We demonstrate the EMFF control approach in open-loop and closed-loop control experiments using a single-degree-of-freedom testbed with an electromagnetic actuation system (EAS). The EAS sense the relative position and velocity between satellites and implement a frequency-multiplexed sinusoidal control signal. We use a laser-rangefinder device to capture the relative position and an ARM-based microcontroller to implement the closed-loop control algorithm. We custom-design and build the EAS that implements the formation control in one dimension. The experimental results in this thesis demonstrate the feasibility of the …
Mathematical Programming Approach For The Design Of Satellite Power Systems, Allen Flath Iii
Mathematical Programming Approach For The Design Of Satellite Power Systems, Allen Flath Iii
Theses and Dissertations--Electrical and Computer Engineering
Satellite power systems can be understood as islanded dc microgrids supplied by specialized and coordinated solar cell arrays augmented by electrochemical battery systems to handle high-power loads and periods of eclipse. The periodic availability of power, the limited capacity of batteries, and the dependence of all mission service on power consumption create a unique situation in which temporal power and energy scarcity exist. A multi-period model of an orbital satellite power system’s performance over a mission’s duration can be constructed. A modular power system architecture is used to characterize the system’s constraints. Using mathematical programming, an optimization problem can be …
Laminar And Turbulent Study Of Combustion In Stratified Environments Using Laser Based Measurements, Stephen William Grib
Laminar And Turbulent Study Of Combustion In Stratified Environments Using Laser Based Measurements, Stephen William Grib
Theses and Dissertations--Mechanical and Aerospace Engineering
Practical gas turbine engine combustors create extremely non-uniform flowfields, which are highly stratified making it imperative that similar environments are well understood. Laser diagnostics were utilized in a variety of stratified environments, which led to temperature or chemical composition gradients, to better understand autoignition, extinction, and flame stability behavior. This work ranged from laminar and steady flames to turbulent flame studies in which time resolved measurements were used.
Edge flames, formed in the presence of species stratification, were studied by first developing a simple measurement technique which is capable of estimating an important quantity for edge flames, the advective heat …