Propulsion and Power Commons^™

Navier Stokes Pressure Drop Derivation, Brayden Benedetti, Gedaliah Dimbert, Jaden Turobiner

Discovery Day - Daytona Beach

Accurate prediction of pressure losses in propellant and fluid feed systems is essential for reliable design and operation of aerospace and industrial flow networks. This project presents a systematic derivation of a practical pressure drop calculator for a feed system using isopropyl alcohol, beginning from the fundamental conservation laws and culminating in an engineering-level computational model. Starting with the differential form of the Navier–Stokes equations for incompressible flow, the governing equations are simplified through a series of physically justified assumptions, including steady-state flow, negligible body forces, and fully developed internal flow within circular piping. The resulting momentum balance is reduced …

Computational Study Of Rotating Detonation Combustors, Aditya Balasubramaniam

Mechanical and Aerospace Engineering Theses

Rotating detonation combustors (RDCs) are pressure-gain combustion devices that sustain one or more continuously rotating detonation waves, offering potential thermodynamic and performance advantages over conventional deflagration-based systems. Their behavior depends strongly on combustor geometry and operating conditions. Understanding these effects is therefore essential for the design and optimization of practical RDCs. Accordingly, this thesis numerically investigates annular RDCs with two primary objectives: (1) to evaluate the effects of propellant mass flux and (2) to assess the influence of annular width on detonation-wave dynamics and combustor performance.

A finite-volume framework is used to solve the compressible reactive Euler equations with hydrogen–air …

Development Of On-The-Fly Quasi-Steady State Approximation For Chemical Kinetics In Cfd, Abhinav Balamurugan

Doctoral Dissertations and Master's Theses

This study analyzes the feasibility of On-The-Fly Quasi-Steady-State Approximation (OTF-QSSA) application for solving chemical kinetics within Computational Fluid Dynamics (CFD) simulations, aiming to reduce the computational demand of detailed mechanisms. An algorithm that dynamically identifies and designates Quasi-Steady-State (QSS) species at specific grid locations and instances during the simulation was developed. With this information, our method pseudo-delays the advancement of concentrations for these QSS species—effectively setting their rate of concentration change to zero for a set number iteration before updating using the detailed mechanism and thereby omitting the computationally intensive processes typically required for their calculation during those skipped iteration. …

Direct Simulation And Reduced-Order Modeling Of Premixed Flame Response To Acoustic Modulation, Zheng Qiao

Theses and Dissertations

This dissertation introduces a general, predictive and cost-efficient reduced-order modeling (ROM) technique for characterization of flame response under acoustic modulation. The model is built upon the kinematic flame model–G-equation to describe the flame topology and dynamics, and the novelties of the ROM lie in i) a procedure to create the compatible base flow that can reproduce the correct flame geometry and ii) the use of a physically-consistent acoustic modulation field for the characterization of flame response. This ROM addresses the significant limitations of the classical kinematic model, which is only applicable to simple flame configurations and relies on ad-hoc models …

Investigation Of Endwall Vortex Manipulation In High Lift Turbines Caused By Active Endwall Forcing, Horatio J. Babcock

Theses and Dissertations

With the increased demand for lighter, more fuel efficient and smaller gas turbine engines, the impetus to reduce the weight and size of the turbine has become apparent. One approach to reduce this weight is to reduce the number of blades in the turbine. However, to maintain power output, each blade must be capable of supporting a greater amount of lift. While several high-lift turbine profiles have been detailed in literature, most of these profiles have increased endwall losses, despite their desirable mid-span characteristics. To mitigate this endwall loss, a number of active and passive flow approaches have been studied …

Floating Active Baffles, System And Method Of Slosh Damping Comprising The Same, Dae Won Kim, Rudy L. Baum, Vijay Santhanam, Balaji Sivasubramanian, Sathya Gangadharan

Publications

This disclosure provides a system for damping slosh of a liquid within a tank, a baffle for use in the system, and a method of damping slosh using the system. The system includes a plurality of baffles. Each baffle has a body configured to substantially float upon the liquid. Each baffle also has an activation material received along at least a portion of the body. The activation material is magnetically reactive provided in a quantity sufficient to enable the body to be manipulated in the presence of a magnetic field (M). The system further includes an actuator configured to pro­vide …

Fuel Flow Reduction Impact Analysis Of Drag Reducing Film Applied To Aircraft Wings, Damon Resnick, Chris Donlan, Nimish Sakalle, Cody Pinkerman

SMU Data Science Review

In this paper, we present an analysis of flight data in order to determine whether the application of the Edge Aerodynamix Conformal Vortex Generator (CVG), applied to the wings of aircraft, reduces fuel flow during cruising conditions of flight. The CVG is a special treatment and film applied to the wings of an aircraft to protect the wings and reduce the non-laminar flow of air around the wings during flight. It is thought that by reducing the non-laminar flow or vortices around and directly behind the wings that an aircraft will move more smoothly through the air and provide a …

Computational Fluid Dynamics Is Key To Better Flying Aircraft, Nihad E. Daidzic

Aviation Department Publications

No abstract provided.

Thrust Prediction For A Rotor Operating In A Ship Airwake, Mathew Thomas

Mechanical & Aerospace Engineering Theses & Dissertations

This report details work performed at Old Dominion University focused on developing a thrust prediction capability for a rotor operating in a ship airwake. The study has built upon previous experimental work utilizing particle image velocimetry-based velocity field measurements to quantify the degree of coupling in a simplified rotor/ship airwake experiment. Using the velocity field data of the previous study, a database was built representing the volume over the landing deck. Rotor thrust was computed using blade element methods and compared to direct load cell measurements and to a superposed velocity field. Results show that the blade element method has …

Performance Characteristics Of Fluidic-Based Thrust Augmentation Using A Slot Jet For Unmanned Aerial Vehicle Propulsion, Brendan A. Wiedow

Mechanical & Aerospace Engineering Theses & Dissertations

Currently most small vertical takeoff and landing Unmanned Aerial Vehicles (UA V's) use a quadcopter design by utilizing four exposed blades rotating at high RPMs around a central array of components. The research performed in this thesis is focused on understanding the underlying fluid dynamics of a slot jet through the use of flow entrainment for thrust augmentation with the application to be integrated into a novel UAV system with no external moving parts. Current publicly available quadcopter rotor design type aircraft were used as a basis for the design target weight and power to estimate the amount of thrust …

A Contribution Toward Better Understanding Of Overbanking Tendency In Fixed-Wing Aircraft, Nihad E. Daidzic

Journal of Aviation Technology and Engineering

The phenomenon of overbanking tendency for a rigid-body, fixed-wing aircraft is investigated. Overbanking tendency is defined as a spontaneous, unbalanced rolling moment that keeps increasing an airplane’s bank angle in steep turns and must be arrested by opposite aileron action. As stated by the Federal Aviation Administration, the overbanking tendency may lead to a loss of control, especially in instrument meteorological conditions. It was found in this study that the speed differential over wing halves in horizontal turns indeed creates a rolling moment that achieves maximum values for bank angles between 45 and 55 degrees. However, this induced rolling moment …

Ramjet Combustion Chamber, Paul Cameron Stone

Aerospace Engineering

A ramjet combustion chamber is designed and some initial assembly fabrication and test completed as a component of a ramjet graduate project for California Polytechnic State University, San Luis Obispo Supersonic Wind Tunnel. The combustor design is driven by a theoretical model created by a Cal Poly graduate student, Harrison Sykes. Temperature, pressure, and fuel flow will be measured.

Strain Rate And Orientation Dependencies Of The Strength Of Single Crystalline Copper Under Compression, Virginie Dupont, Timothy C. Germann

Aerospace Engineering - Daytona Beach

Molecular dynamics (MD) simulations are used to model the compression under uniaxial strain of copper single crystals of different orientations at various temperatures and strain rates. Uniaxial strain is used because of the close resemblance of the resulting stress state with the one behind a shock front, while allowing a control of parameters such as strain rate and temperature to better understand the behavior under complex dynamic shock conditions. Our simulations show that for most orientations, the yield strength of the sample is increased with increasing strain rate. This yield strength is also dependent on the orientation of the sample, …

Hyperspectral Imaging Of A Turbine Engine Exhaust Plume To Determine Radiance, Temperature, And Concentration Spatial Distributions, Spencer J. Bowen

Theses and Dissertations

The usefulness of imaging Fourier transform spectroscopy (IFTS) when looking at a rapidly varying turbine engine exhaust scene was explored by characterizing the scene change artifacts (SCAs) present in the plume and the effect they have on the calibrated spectra using the Telops, Inc.-manufactured Field-portable Imaging Radiometric Spectrometer Technology, Midwave Extended (FIRST-MWE). It was determined that IFTS technology can be applied to the problem of a rapidly varying turbine engine exhaust plume due to the zero mean, stochastic nature of the SCAs, through the use of temporal averaging. The FIRST-MWE produced radiometrically calibrated hyperspectral datacubes, with calibration uncertainty of 35% …

Assessing The Potential For Improved Scramjet Performance Through Application Of Electromagnetic Flow Control, Martin F. Lindsey

Theses and Dissertations

Hypersonic flight using scramjet propulsion bridges the gap between turbojets and rockets. Recent efforts focus on magnetogasdynamic (MGD) flow control to mitigate the problems of high thermomechanical loads and low efficiencies associated with scramjets. This research is the first flight-scale, three-dimensional computational analysis of a realistic scramjet to assess how MGD flow control improves scramjet performance. Developing a quasi-one dimensional design tool culminated in the first open source scramjet geometry. This geometry was tested with the Air Force Research Laboratory's electromagnetic computational code. To increase fidelity, an algorithm was developed to incorporate thermochemistry, resulting in the only open-source model of …