Navigation, Guidance, Control and Dynamics Commons^™

System Integration And Validation Of The Cal Poly Spacecraft Attitude Dynamics Simulator Mk. Iv, Bricen S. Rigby

Master's Theses

The Cal Poly Spacecraft Attitude Dynamics Simulator (SADS) is an ongoing project that seeks to enable the simulation and validation of sensors, actuators, and control logic related to spacecraft attitude control. The SADS platform rests atop a spher- ical air-bearing device which allows for nearly frictionless rotation in all three axes. The orientation of the platform is controlled by four reaction wheels arranged in a pyramidal configuration. Over the past few years, there have been significant updates to the reaction wheel subsystem, as well as requests for a more capable central com- puter. Therefore, a new system architecture for the …

Robust Spacecraft Autonomy For Deep Space Exploration In Special Euclidean Group Se(3), Matthew Wittal

Doctoral Dissertations and Master's Theses

Over the past half-century, humanity has gained extensive experience conducting manned spaceflight near Earth. Arguably, "near Earth" could even include the Moon — the most distant destination humans have reached. However, "near" in this work primarily refers low Earth orbit (LEO). One could argue that we have not truly left Earth since the Apollo, as spacecraft in some LEOs remain subject to atmospheric drag thus emphasizing their continued connection to Earth's immediate environment. Reflecting on this, it becomes clear that humanity has largely remained bound to Earth’s immediate vicinity since the Apollo missions reached the Moon. However, that is set …

Cubesat Reaction Wheel Attitude Control Platform System Architecture, Justin Hartland

Beyond: Undergraduate Research Journal

In the classroom, physics behind spacecraft attitude dynamics and controls is abstract and difficult to comprehend. It is common that students struggle to develop the connection between the math they learn and how it can be applied in the real world. The goal of this project is to design and manufacture a 1U, 3U, and 6U CubeSat testbed for autonomous control systems utilizing reaction wheels. The testbed will include three separate reaction wheels each mounted on its own respective axis to control the attitude in 3 degrees of freedom. The end goal of the CubeSat Control Platform is to be …

Dual Quaternion Relative Dynamics For Gravity Recovery Missions, Ryan Kinzie, Riccardo Bevilacqua, Seo Dongeun

Student Works

A dual quaternion modeling approach is compared to traditional modeling methods for formation flying spacecraft utilized for gravity recovery missions. A modeling method that has traditionally been used for gravity recovery missions is presented which models the motion of two formation flying spacecraft and a test mass. This is followed by the dual quaternion-based formulation for the equations of motion of the twelve degree-of-freedom coupled relative dynamics of formation flying spacecraft and a test mass. Lastly, utilizing data products from the Gravity Recovery and Climate Experiment Follow-On mission, a comparison of these two modeling methods is presented which proves the …

Developing A Light Curve Simulation Tool For Ground And Space-Based Observations Of Spacecraft And Debris, Andrew T. Ochoa

Master's Theses

A light curve is a plot of brightness versus time of an object. Light curves are dependent on orbit, attitude, surface area, size, and shape of the observed object. Using light curve data, several analysis methods have been developed to derive these parameters. These parameters can be used for tracking orbital debris, monitoring satellite health, and determining the mission of an unknown spacecraft.

This paper discusses the development, verification, and utilization of a tool that simulates light curve data. This tool models ground-based observations, space-based observations, self-shadowing geometry, tumbling debris, and controlled spacecraft. The main output from the tool is …

Interior Point Optimization Of Low-Thrust Spacecraft Trajectories, Jordan D. Frederiksen

Master's Theses

Low-thrust interplanetary spacecraft trajectory optimization poses a uniquely difficult problem to solve because of the inherent nonlinearities of the dynamics and constraints as well as the large size of the search space of possible solutions. Tools currently exist that optimize low-thrust interplanetary trajectories, but these tools are rarely openly available to the public, and when they are available they require multiple interfaces between multiple different packages. The goal of this work is to present a new piece of low-thrust interplanetary spacecraft trajectory optimization software that is open-source and entirely self-contained so that more people can have access to the ability …

Spacecraft Trajectory Planning For Optimal Observability Using Angles-Only Navigation, Francisco José Franquiz

Doctoral Dissertations and Master's Theses

This work leverages existing techniques in angles-only navigation to develop optimal range observability maneuvers and trajectory planning methods for spacecraft under constrained relative motion. The resulting contribution is a guidance method for impulsive rendezvous and proximity operations valid for elliptic orbits of arbitrary eccentricity.

The system dynamics describe the relative motion of an arbitrary number of maneuvering (chaser) spacecraft about a single non-cooperative resident-space-object (RSO). The chaser spacecraft motion is constrained in terms of the 1) collision bounds of the RSO, 2) maximum fuel usage, 3) eclipse avoidance, and 4) optical sensor field of view restrictions. When more than one …

Control Of A Spacecraft Using Mixed Momentum Exchange Devices, Blake J. Currie

Master's Theses

Hardware configurations, a control law, and a steering law are developed for a mixed hardware spacecraft that uses both control moment gyros and reaction wheels. Replacing one or more gyros in a spacecraft with a reaction wheel has potential for cost savings while still achieving much greater performance than using reaction wheels alone. Several simulated tests are run to compare the performance to a traditional all reaction wheel or all control moment gyro spacecraft, including analysis of failure modes and singular configurations. The mixed system performed similarly to all gyro systems, responding within 6% of the gyro system’s time for …

Modification Of The Cal Poly Spacecraft Simulator System For Robust Control Law Verification, Tomoyuki Kato

Master's Theses

The Cal Poly Spacecraft Dynamics Simulator, also known as the Pyramidal Reaction Wheel Platform (PRWP), is an air-bearing four reaction wheel spacecraft simulator designed to simulate the low-gravity, frictionless condition of the space environment and to test and validate spacecraft attitude control hardware and control laws through real-time motion tests. The PRWP system was modified to the new Mk.III configuration, which adopted the MATLAB xPC kernel for better real-time hardware control. Also the Litton LN-200 IMU was integrated onto the PRWP and replaced the previous attitude sensor. Through the comparison of various control laws through motion tests the Mk.III configuration …

Development Of A Pyrotechnic Shock Simulation Apparatus For Spacecraft Applications, Joseph Binder, Matthew Mccarty, Chris Rasmussen

Aerospace Engineering

This report details the research, design, construction, and testing of a pyrotechnic shock simulation apparatus for spacecraft applications. The apparatus was developed to be used in the Space Environments Lab at California Polytechnic State University. It will be used for testing spacecraft components with dimensions up to 24”x12”x12” as well as CubeSats. Additionally, it may be used as an instructional or demonstrational tool in the Aerospace Department’s space environments course. The apparatus functions by way of mechanical impact of an approximately 20 lb stainless steel swinging hammer. Tests were performed to verify the simulator’s functionality. Suggestions for improvement and further …

Adaptive Control Applied To The Cal Poly Spacecraft Attitude Dynamics Simulator, Matthew C. Downs

Master's Theses

The goal of this thesis is to use the Cal Poly Spacecraft Attitude Dynamics Simulator to provide proof of concept of two adaptive control theories developed by former Cal Poly students: Nonlinear Direct Model Reference Adaptive Control and Adaptive Output Feedback Control. The Spacecraft Attitude Dynamics Simulator is a student-built air bearing spacecraft simulator controlled by four reaction wheels in a pyramidal arrangement. Tests were performed to determine the effectiveness of the two adaptive control theories under nominal operating conditions, a “plug-and-play” spacecraft scenario, and under simulated actuator damage. Proof of concept of the adaptive control theories applied to attitude …

Control System Design And Simulation Of Spacecraft Formations Via Virtual Formation Approach, Pavan Donepudi

Master's Theses - Daytona Beach

The problem of formation control of multiple spacecraft using the virtual structure approach is studied. The thesis first summarizes the progress made in the area of spacecraft formation control and then provides an overview of the virtual structure method. Modifying earlier established control design techniques, new feedback laws are constructed to control both the rotational and translational motion of a group of spacecraft. Several computer simulations are performed to illustrate the effectiveness of the modified control laws. The ephemeris and attitude data files generated via Matlab are exported to Satellite Tool Kit (STK) to create 3D animations. Various formation scenarios …

Maneuvering Control Of A Spacecraft With Propellant Sloshing, Philip A. Savella

Master's Theses - Daytona Beach

Propellant slosh has been a problem studied in spacecraft designs since the early days of large, liquid-fuel rockets. The conventional design solution involves physical structures inside the fuel tanks that limit propellant motion. Although effective, baffles and bladders add to spacecraft mass and structural complexity. In this research, the sloshing fuel mass is treated as an unactuated degree of freedom within a rigid body. Specifically, the propellant is modeled as a pendulum mass anchored at the center of a spherical tank. After obtaining the coupled equations of motion, several linear controllers are developed to achieve planar spacecraft pitch-maneuvers while suppressing …

Modeling And Slew-Maneuver Control Of A Flexible Spacecraft, Jeremy E. Eckhart

Master's Theses - Daytona Beach

Slew-maneuver control problem is studied for a flexible spacecraft consisting of a rigid main body to which a long flexible appendage is attached. Nonlinear dynamical system models are developed using both distributed parameter modeling and discrete parameter modeling; these models are shown to be equivalent for appropriately chosen system parameters. Lyapunov-based nonlinear feedback controllers are designed for the control of rigid-body motion while suppressing the lowest frequency vibrational mode. In case of large-angle maneuvers, these nonlinear controllers are shown to outperform the linearization-based controllers including the filtered proportional-derivative (PD) controllers as well as the linear quadratic regulator (LQR) controllers. Finally, …