Aerospace Engineering Commons^™

Effects Of Nose Bluntness And Shock-Shock Interactions On Blunt Bodies In Viscous Hypersonic Flows, Dal J. Singh

Mechanical & Aerospace Engineering Theses & Dissertations

A numerical study has been conducted to investigate the effects of blunt leading edges on the viscous flow field around a hypersonic vehicle such as the proposed National Aero-Space Plane. Attention is focused on two specific regions of the flow field. Analysis of these flow regions is required to accurately predict the overall flow field as well as to get necessary information on localized zones of high pressure and intense heating.

The forebody is modeled by slender cones and ogives with spherically blunted nose. A combination of Navier-Stokes and parabolized Navier-Stokes equations is used to compute the flow field. The …

Numerical Simulation Of Turbulent Flows Past Three-Dimensional Cavities, Shivakumar Srinivasan

Mechanical & Aerospace Engineering Theses & Dissertations

Computations have been performed to simulate turbulent supersonic, transonic, and subsonic flows past three-dimensional deep, transitional, and shallow cavities. Simulation of these self sustained oscillatory flows has been generated through time accurate solutions of Reynolds averaged full Navier-Stokes equations using the explicit MacCormack scheme. The Reynolds stresses have been modeled, using the Baldwin-Lomax algebraic turbulence model with certain modifications. The computational results include instantaneous and time averaged flow properties everywhere in the computational domain. Time series analyses have been performed for the instantaneous pressure values on the cavity floor. Comparison with experimental data is made in terms of the mean …

Nusat I Project: Final Report, Charles A. Bonsall

Robert "Bob" Twiggs STEM Education Collection

A report composed by Charles A. Bonsall titled "NUSAT I Project: Final Report" from August of 1987.

Weatherford Air Show And General Thomas P. Stafford Museum Dedication, City Of Weatherford

Programs

This is a program from the 1987 Weatherford Air Show and General Thomas P. Stafford Museum Dedication in Weatherford, Oklahoma.

Unless stated otherwise within this repository collection, all materials are shared under the following Creative Commons license: [Creative Commons Attribution-NonCommercial 4.0 International License].

Nusat 1 - The First Ejectable Getaway Special, Charles A. Bonsall, R. Gilbert Moore

Robert "Bob" Twiggs STEM Education Collection

A presentation made by Charles A. Bonsall and R. Gilbert Moore titled "NUSAT 1 - The First Ejectable Getaway Special" from October 8, 1985.

The Nusat I Project, Charles Allen Bonsall

Robert "Bob" Twiggs STEM Education Collection

A history of the NUSAT I Project submitted by Charles Allen Bonsall in April of 1985.

Bonsall Faa Report, Charles A. Bonsall

Robert "Bob" Twiggs STEM Education Collection

The Federal Aviation Administration report related to the NUSAT system from Charles A. Bonsall from October 18, 1984.

Functional Philosophy Of The Nusat System And The Organization That Developed It, Charles A. Bonsall

Robert "Bob" Twiggs STEM Education Collection

A report composed by Charles A. Bonsall titled "Functional Philosophy of the NUSAT System and the organization that developed it" from October 18, 1984.

Second Annual Great Oklahoma Balloon Race & Airshow Gala Reception, Clarence E. Page Oklahoma Air And Space Museum

Programs

This is the program from the second annual Great Oklahoma Balloon Race & Airshow Gala Reception in honor of Astronaut, Lt. General Thomas P. Stafford. The event was held at the Clarence E. Page Oklahoma Aviation and Space Hall of Fame and Museum in the Kirkpatrick Center in OKC, OK, on Thursday, August 16th, 1984.

Unless stated otherwise within this repository collection, all materials are shared under the following Creative Commons license: [Creative Commons Attribution-NonCommercial 4.0 International License].

Studies On The Interference Of Wings And Propeller Slipstreams, Ramadas K. Prabhu

Mechanical & Aerospace Engineering Theses & Dissertations

The small disturbance potential flow theory is applied to determine the lift of an airfoil in a nonuniform parallel stream. The given stream is replaced by an equivalent stream with a certain number of velocity discontinuities, and the influence of these discontinuities is obtained by the method of images. Next, this method is extended to the problem of an airfoil in a nonuniform stream of smooth velocity profile. This model allows perturbation velocity potential in a rotational undisturbed stream. A comparison of these results with numerical solutions of Euler equations indicates that, although approximate, the present method provides useful information …

An Analytical Design Procedure For The Determination Of Effective Leading Edge Extensions On Thick Delta Wings, Farhad Ghaffari

Mechanical & Aerospace Engineering Theses & Dissertations

An analyt1cal des1gn procedure for Lead1ng-Edge Extensions (LEE) has been developed for thick delta wings. This LFE device is des1gned to be mounted to a w1ng along the pseudo-stagnation stream surface associated w1th the attached flow design lift coeff1cient of greater than zero. The intended purpose of the device is to improve the aerodynamic performance of high subsonic and low super son1c aircraft at incidences above that of attached flow design lift coefficient, by us1ng a vortex system emanating along the leading edges of the device. The low pressure assoc1ated with these vort1ces would act on the LEE upper surface …

Interaction Of A Two-Dimensional Transverse Jet With A Supersonic Mainstream, Gilbert Otto Kraemer

Mechanical & Aerospace Engineering Theses & Dissertations

A experimental investigation of the interaction of a twodimensional sonic jet injected transversely into a confined main flow has been conducted. The main flow consisted of air at a Mach number of 2.9. The effects of varying the jet parameters on the flow field were examined using surface pressure and composition data. Also, the downstream flow field was examined using static pressure, pitot pressure, and composition profile data. The jet parameters varied were gapwidth, jet static pressure, and injectant species of either helium or nitrogen. The values of the jet parameters used were 0.039, 0.056,and 0.109 cm for the gapwidth …

Low Speed Handling Characteristics Of A Supersonic Transport By Eigenstructure Assignment, Michael Peter Lazar

Mechanical & Aerospace Engineering Theses & Dissertations

A synthesis procedure, based upon optimal regulator theory and eigenvalue/eigenvector assignment technique, was used in the design of a low-speed lateral control system for the SCAT-15F supersonic transport. Emphasis was placed on reducing the lateral acceleration at the pilot's station. Control laws were designed to make the aircraft handling characteristics acceptable with the exception of the lateral acceleration. It was found that a compromise between the roll performance requirements and the peak lateral acceleration requirement is needed for a successful SCAT-15F design.

Experimental Study Of Delta Wing Leading-Edge Devices For Drag Reduction At High Lift, Thomas Dwight Johnson Jr.

Mechanical & Aerospace Engineering Theses & Dissertations

Future fighter aircraft requirements specify efficient supersonic cruise and high-g maneuverability at high lift. The slender delta wing meets the first requirement but has large lift induced drag increments at high lift. One method to alleviate the drag is to control the flow at the wing leading edge (LE) by means of small LE devices, so as to maintain locally attached flow to higher angles of attack and thus increase the level of aerodynamic thrust.

The devices selected for evaluation were the fence, slot, pylon-type vortex generator (VG), and sharp leading-edge extension (SLEE). These devices were tested on a 60° …

Analytic And Experimental Studies Of A True Airspeed Sensor, Joseph Yao-Cheng Shen

Mechanical & Aerospace Engineering Theses & Dissertations

The objective of this study was to analyze and design a true airspeed sensor which will replace the conventional pitot-static pressure transducer. This sensor should have the following characteristics: the flow phenomenon is vortex procession, or the "vortex whistle", it should have no moving parts, and also is to be independent of temperature, density, altitude or humidity changes. This sensor has been designed mainly for small commercial aircraft with the airspeed up to 321.9 km/hr (200 mph).

In an attempt to model the complicated fluid mechanics of the vortex precession, three-dimensional, inviscid, unsteady, incompressible fluid flow was studied by using …

Apollo/Soyuz Tv Guide: "Soyuz, Soyuz, This Is Apollo...", Bob Button

Articles

This is a TV Guide from 1975 that features a story about the televised Apollo/Soyuz mission.

Computer-Aided Design Of Light Aircraft To Meet Certain Aerodynamic And Structural Requirements, Joanne Lynn Walsh

Mechanical & Aerospace Engineering Theses & Dissertations

Nonlinear mathematical programming techniques are applied to a particular aircraft design problem, that of determining the maximum range design for light aircraft subject to certain aerodynamic and structural requirements. Search techniques available in an existing nonlinear optimization computer program, AESOP, are applied to the design problem. Seven design variables are used to define the wing dimensions, the wing skin thickness, the cruise velocity, the amount of fuel carried, and the engine horsepower. The influence of different design requirements on the range is observed and discussed.

The Analysis Of A Subsonic Jet Issuing Perpendicular To A Freestream Flow From A Flat Plate And A Body Of Revolution, Donald R. Haberman

Mechanical & Aerospace Engineering Theses & Dissertations

An investigation was undertaken to determine the nature of the pressure region around a jet issuing perpendicular to a free stream flow from a flat plate and a cylindrical surface, and to determine the forces which resulted from such a pressure region. It was also attempted to develop an empirical relation to enable the prediction of surface pressure regions from known physical parameters.

The jet was exhausted from a 0.375 inch nozzle perpendicular to a free stream flow of about 90 ft./sec. The flow rate of the jet was then varied to give three free stream to jet velocity ratios …

The Control And Use Of Drag-Free Satellites, Benjamin Lange

Robert "Bob" Twiggs STEM Education Collection

A research thesis by Ben Lange for the Department of Aeronautics and Astronautics at Stanford University titled "The Control and Use of Drag-Free Satellites" from June of 1964.

Astronaut Activity Involving Pete Conrad, Elliot See, Thomas Stafford And Ed White, Nasa

Videos

Astronaut Activity Involving Pete Conrad, Elliot See, Thomas Stafford and Ed White

• This item documents the time period of July 8, 1963–July 12, 1963.

Aircraft To Be Used On Agricultural Advisory Work, F L. Shier

Journal of the Department of Agriculture, Western Australia, Series 3

For the first time in Western Australia, an aircraft will shortly be used as an adjunct to the Department of Agriculture's advisory services.

Mr. J. R. M. Wolfe, an advisor on the staff of the Department of Agriculture's North-West Branch, recently took delivery of a canopied Tiger Moth aircraft which he will use for travelling between stations in the Port Hedland district.

Aircraft Quality Casting Standards, Robert Katz, Robert Bolin , Depositor

Robert Katz Publications

These standards are to be used in connection with the Handbook for Instructions for Aircraft Designers, 8^th Edition …

In the radiography of aircraft castings, markings appearing on the film may be attributed to either the condition of the castings examined, or to some details of the radiographic process entirely unrelated to the quality of the castings, These latter patterns must be recognized and related to the radiographic process so that sound castings will not be unnecessarily rejected. Radiographs must be carefully compared with the surface irregularities of the casting they represent before an attempt is made to …