Engineering Commons^™

Test 478: Mccormick Super Wd-6, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 477: Mccormick Farmall Super Md, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Head Determinations For Structures On U.S 23 That Are Affected By Raising The Normal Pool Elevation Of Ohio River Lock And Dam No. 30 At Greenup, Kentucky, Eugene M. West

Kentucky Transportation Center Research Report

During a visit to this office on July 3, 1952, Mr. J.O. Cornell requested the assistance of the Hydraulics Section of the Research Laboratory in investigating the possible head to be expected on the drainage structures on U.S. 23, that would be influenced by the proposed raising of the normal pool elevation of Ohio River Lock and Dam No. 30 at Greenup, Kentucky.

In order to better evaluate the head to be expected, I have approached the problem from an analytical standpoint, outlining and comparing the results from three suggested methods. The results of the analysis of the three separate …

Vapor Phase Catalytic Air Oxidation Of P-Cymene, Salvatore Joseph Finelli

Theses

No abstract provided.

The Synthesis Of 2-Aminophenol-4-Sulfonic Acid, Joseph Salvatore Milazzo

Theses

No abstract provided.

Test 476: Mccormick Super W-6, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 475: Mccormick Farmall Super M, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 474: Cockshutt 20*, Nebraska Tractor Test Lab

Nebraska Tractor Tests

Department of Agricultural Engineering Dates of test: June 16 to June 24, 1952. Manufacturer: C O C K S H U T T F A R M E Q U I P M E NT L T D . , B R A N T F O R D , O N T A R I O , C A N A D A,

Test 473: Bolens 12bb, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Development Of A Test For Rapid Determination Of Octane Ratings Of Gasolines, Charles B. Gangwer

Mechanical Engineering ETDs

For many years, the Mechanical Engineering Department of the University of New Mexico has been interested in developing a more reliable and expedient method to determine octane readings of gasolines than the conventional CFR Motor Method of Test for Knock Characteristics of Motor Fuels. A summary of the development of the conventional CFR Test method and a brief discussion of the operational procedure of this method is necessary to better understand the need for a new fuel rating procedure. To further explain the disadvantages of the conventional test method, an introduction to the new test method to be developed will …

Corrosion Of Highway Structures By Acid-Bearing Drainage Water In Hopkins County, James H. Havens

Kentucky Transportation Center Research Report

Pursuant to your conversation with Mr. Hopgood concerning the above matter, Mr. Peed and I contacted Mr. Charlie Rogers, Resident Engineer, Madisonville, and made an inspection of the locations in question. In specific connection with this, you will recall from our Progress Report No. 1 on "A Survey of Acidity in Drainage Waters and the Condition of Highway Drainage Installations" that the acid conditions in Hopkins County were rated as extremely severe, if not the most critical in the state. It was, in part, due to the prevailing severity there that led to the selection of a location at Mortons …

A Study In Emulsions, Edward Arthur Morse

Theses

An emulsion is a dispersion of one liquid in another liquid, the liquids being insoluble in each other. An emulsion consists of two phases, a continuous phase and a dispersed phase. The dispersed phase consists of tiny droplets or particles of one liquid which is completely surrounded by the other liquid comprising the continuous phase. One of the many factors affecting the stability of an emulsion is the size of the particle of the dispersed liquid.

This study is concerned with one emulsion prepared by different mechanical devices and under different conditions. The units of equipment employed are Eppenbach Colloid …

Adherent Electroplating On Molybdenum, Robert Marius Hansen

Theses

Molydbenum, due to its high temperature properties, and potential supply, is becoming a very important structural material, particularly in the field of electronics, however, it is not new in this part of industry. As temperatures go higher in various fields, the need for satisfactory materials becomes of paramount importance.

One of the ways in which to overcome the disadvantages of poor stability, brazing difficulties, and surface resistance to high frequency conduction, is by electroplating. Until recently there has been no satisfactory method for obtaining adherent deposits. The purpose of this report has been to investigate these recent processes and devise …

Manual For Quality Control, Frank Andrew Antalec

Theses

Modern trends of industrial development have been directed toward increased output of products with greater precision and uniformity. This necessitates an inspection function that reflects more effective results than ever before. In order to rise to this occasion full use must be made of today's principles and techniques of inspection and quality control.

Industry demand the use of high precision measuring instruments to aid the inspection function in obtaining effective results. Recently, however, the techniques of Quality Control have become a well-known, useful, tool for the solution of many manufacturing problems. Effective use of these techniques depends on their complete …

Cost Reduction Through Closer Control Of Quality, Walter Robert Kuzmin

Theses

The economy of our nation differs today from that of World War II or pre-World War II days by the fact that a war-production program is being carried on without adversely affecting the production or civilian goods, At the same time management is confronted with rising costs due to the inflationary spiral of wanes and materials. To mire a profit on Products and remain in competition, management is forced to apply the latest cost reduction methods. Because of the dual economy, companies are quoting on civilian goods and war Products. Contracts released by the government specify that; adequate inspection and …

Preparation And Reduction Of Azo Dyes From 2-Amino Phenol-4-Sulfonic Acid, Guy J. Walker

Theses

Reduction of azo dyes is presented as a method for the synthesis of 2-amino phenol-4-oulfenic acid.

The synthesis and reduction of some azo derivatives of 2-amino phenol-4-sulfonic acid are described.

Preparation of the diazonium compounds of aniline, vitro aniline, 1-amino-2-nanhthol, 1-amino-2-naphthol-1-sulfonic acid, 2-amino phenol-4-sulfonic acid, 1-naphthol 1-amino, and 2-naphthylamine is discussed and their ability to couple with phenol-4-sulfonic acid evaluated.

Reduction of the resultant azo dyes is discussed with reference to fission and the benzidine rearrangement.

An overall presentation of results is Given in Tables I, II, and III on pages 27 - 29.

Test 471 ; Terratrac Gt-30, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

The Design, Construction, And Calibration Of A Stationary Wave Device For Determining Sound Absorption Coefficients Of Acoustic Materials, Douglas W. Ballard

Mechanical Engineering ETDs

The general scope of the thesis investigation is limited to the engineering design and construction of a stationary-wave device for the experimental determination of the sound absorption coefficients of various building materials, the calibration of the apparatus to give comparisons with results obtained in the more expensive reverberation method, and to attempt to correlate observed results with generally accepted acoustical standards.

The Sedimentary Petrography Of The Oil And Gas Producing Horizons In Montana, Patrick J. Donahue

Bachelors Theses and Reports, 1928 - 1970

Montana is an excellent oil province, as oil and gas are pro­duced from a wider range of beds in the geologic section than in any other district in the United States. (1,864) Commercial fields have been developed in Ordovician, Devonian, Mississippian, Pennsylvanian, Jurassic, Lower Cretaceous, and Upper Cretaceous. It is believed that by describing the physical characteristics of the producing horizons, and by placing this information in one compact volume, a better under­standing of oil and gas occurrence in Montana may be gained.

The Accessory Minerals Of Some Granitic Rocks Of The Boulder Batholith, Robert T. Donahue

Bachelors Theses and Reports, 1928 - 1970

Although the position of the Boulder batholith in space and time is well known, the modes of occurrence of various rock types and the inter-relationships between the petrographic types are not known in detail.

The Mechanical Production Of Zinc Dust, Charles A. Schroer

Bachelors Theses and Reports, 1928 - 1970

The object of this thesis is to produce zinc dust suitable for zinc leach purification, by direct application of a mechanical force on a stream of molten zinc.The project is a continuation of work done by Mr. D. S. Gleason, while working for his Master of Science degree in the spring of 1952.

Flotation Of Huebnerite, Henry Albright

Bachelors Theses and Reports, 1928 - 1970

The development of suitable beneficiation processes for treating domestic low-grade tungsten ores is a problem now facing the mineral industry. While we are now consuming more tungsten than normally because of the defense program, we are no longer able to import ores from the world's principal source, China. The problem then, is to increase our domestic production so as to ac­quire a greater degree of self-sufficiency.

The Construction Of An X-Ray Camera, Emil Bazarnicki

Bachelors Theses and Reports, 1928 - 1970

The major portion of the construction of the X-ray camera was performed in the machine shop of Montana School of Mines. However, some machine work had to be accomplished in the Butte High Machine Shop, as well as in the machine shop of the Anaconda Copper Mining Company.

Protective Refractory Coatings On Titanium Metal, Eugene F. Gibbs

Bachelors Theses and Reports, 1928 - 1970

The problem undertaken in this thesis concerns the development of a newer phase of metallurgy, namely the adaption of the strong, lightweight metal titanium to high-temperature uses. The primary objective of the investigation is to determine wheth­er the application of refractory coatings to titanium will pro­tect the metal from chemical reactions and corrosion at high temperatures.

The Birdie Mine Tungsten Deposit Butte Mining District, Silverbow County, Montana, Bernard A. Fahm

Bachelors Theses and Reports, 1928 - 1970

The importance of tungsten has encouraged the search for minerals of this metal, and consequently new deposits have been discovered, and known deposits have been re-examined. Western Montana has rather widespread deposits if low-grade types are also considered. Many deposits were known long ago, but abandoned because the use of tungsten was still in its beginning stage and therefore little attention was given to this type of mineral.

Geological Problems At Kerr Dam Lake County, Montana, Roger C. Rice

Bachelors Theses and Reports, 1928 - 1970

With an increased demand for power in Montana and sur­rounding territory, there is a need for existing power installations to produce more hydro-electric power. Kerr Dam, Lake County, Montana has been one of the dams selected for added output.The existing dam and power house installation with its two hydro-electric was finished in 1938, and has been producing power ever since.

The Occurrence Of Molybdenite In The United States, Alaska, Canada, And Newfoundland, Richard W. Brummett

Bachelors Theses and Reports, 1928 - 1970

In this study of molybdenite and its occurrence, the pub­lished literature on 66 separate deposits was reviewed, sum­marized, and coordinated. The following descriptions are in­tended to point out the important features of molybdenite oc­currences as described in the literature.

The Immersion Coating Of Indium Upon Magnesium From Sulphate Solutions Containing Flourides, John J. Harrington

Bachelors Theses and Reports, 1928 - 1970

The thesis problem that will be discussed in this report is an investiga­tion of a method of plating a coating of indium upon magnesium and magnesium alloys. The method used to accomplish the final results is the immersion pro­cess. It can be defined as the process of coating a metal with a second metal by immersing the first in a solution containing ions of the second.

Variation Of Induction And Hysteresis Curves For The Heusler Alloy, Cu2mna1, Ford W. Knight

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation is to determine the fundamental magnetic characteristics of induction and hysteresis, for the alloy Cu₂MnAl. This is a ternary, ferromagnetic Heusler alloy. The problem is not only to determine these characteristics for the alloy as-cast but to heat treat it and observe the manner in which different heat treat­ments affect these two fundamental magnetic characteristics.

The Effect Of Ferric Iron Upon The Current Efficiency And The Deposition Of Copper In The Electrowinning Of Copper From Copper Sulphate Solutions, James L. Owings

Bachelors Theses and Reports, 1928 - 1970

In the hydrometallurgy of copper, probably the most widely used method for the precipitation of copper is by electrolysis using insoluble anodes. The process is similar in many respects to the electrolytic refining of copper; one of the main differences is the use of insoluble anodes in electrowinning as compared to the use of impure copper anodes in electrorefining. Impurities, however, are common to both processes. The nature of these impurities differ and the problem of purifying the electrolyte is also different.