Engineering Commons^™

Futureman, Norm Lynott

Space Journal

No abstract provided.

Space Books, Space Enterprises, Inc.

Space Journal

No abstract provided.

Green Mountain Proving Ground: Gateway To Tomorrow, G Harry Stine

Space Journal

No abstract provided.

Space Journal, Vol. 2, No. 1, September 1959, Space Enterprises, Inc.

Space Journal

No abstract provided.

Space Exploration And The Value Of Man, Donald N. Michael

Space Journal

No abstract provided.

Does The Moon Possess A Magnetic Field?, Zdenek Kopal

Space Journal

No abstract provided.

Meteorites, Space Enterprises, Inc.

Space Journal

No abstract provided.

Is Time The Missing Link?, Helmut Hoepnner, B Spencer Isbell

Space Journal

No abstract provided.

Time For A Change/Project Able And Baker, Douglass B. Spears Jr., Space Enterprises, Inc.

Space Journal

No abstract provided.

Front Matter, Space Enterprises, Inc.

Space Journal

No abstract provided.

Reaction, Space Enterprises, Inc.

Space Journal

No abstract provided.

Thrust Control Of Solid Propellant Motors, Harold W. Ritchey

Space Journal

No abstract provided.

Back Matter, Space Enterprises, Inc.

Space Journal

No abstract provided.

An Experimental Method For Three-Dimensional Dynamic Stress Analysis, Larry E. Williams

Mechanical Engineering ETDs

It is the purpose of this thesis to present an evaluation of a method of experimental dynamic stress analysis utilizing electrical resistance strain gauges located internally. If it can be shown that the proposed experimental procedure is valid, then the transient stress phenomena could be continuously recorded from an internal, integral strain gauge placed at any desired location and in any orientation in a suitable model.

Test 714: Case Model 610 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 713: Case Model 810 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Colorado "Rush To The Rockies Centennial" Spectroscopy Conference

Rocky Mountain Conference on Magnetic Resonance

Program from the Colorado "Rush to the Rockies Centennial" Spectroscopy Conference, sponsored by the Rocky Mountain Spectroscopy Society. Held in Denver, Colorado, August 10-11, 1959.

Test 712: Case Model 1010 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 710: Caterpiller Model D-7 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 711: Caterpiller Model D-8 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 709: Case Model 310-C (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

The Design Of Thin, Silica Sand-Asphalt, Wearing Surfaces For Highways And Bridges, Robert L. Florence

Kentucky Transportation Center Research Report

This study was performed at the Highway Materials Research Laboratory in Lexington, Kentucky. In this study the various sands were combined with a sphalt cement of penetration 60 to 70 and tested by the Marshall method to determine the physical characteristics of the mixtures. Other variables investigated were the hardness of the asphalt cement and the amount of mineral filler. A coefficient of friction was determined, by means of a laboratory testing device, for each of the mixtures.

Due to the promising results of the laboratory testing, and the successful re-surfacing of bridges with silica sand-asphalt mixtures in the New …

The Use Of Epoxy Resin For Sealing Cracks In A Reinforced Concrete Bridge, Milton Evans Jr.

Kentucky Transportation Center Research Report

In the summer of 1958, a special formulation of epoxy resin was used to seal hairline cracks in the safety walks of the Levisa-Fork bridge at Paintsville, Kentucky. This bridge, a reinforced concrete box girder-type, Fig. 1, developed fine cracks soon after the falsework was removed. The cracks which were typically like those in Figs. 2 and 3, occurred in two areas, each extending about 30 ft. on either side of the center piers. They were through the full depth of the slab and ranged from about .005 in. to .031 in. in width. In all, there were 55 cracks …

Test 708: Fiat Model 411-C (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Vapor Liquid Equilibria Of Diacetone Alcohol In Various Solvents, John A. Mulligan

Theses

This paper presents the initial study of vapor-liquid equilibria data for the systems (a) diacetone alcohol-methanol (b) diacetone alcohol-ethanol and (c) diacetone alcohol-benzene at 100mm and 200mm and confirms the data reported by Hack and Van Winkle (6) on the system (d) diacetone alcohol-water at the same pressures. Margules and Redlich and Kister constants have been determined from the data, and are presented for use in future studies.

A comparison has been made between Redlich and Kister constants determined from laboratory data, and Redlich and Kister constants predicted from the physical properties of the components. Redlich and Kister constants predicted …

Alkylation With Some Alkyl Borate By The Friedel-Crafts Methods, Richard Ernest Huber

Theses

Normal butyl, allyl, methylbutyne and 2-chloroethyl borates were synthesized in yields above 90.0% from their corresponding alcohols and boric acid. Using some of the above alkyl borates, and others commercially available, as alkylating agents, benzene was alkylated by the Friedel-Crafts method, using aluminum chloride as the catalyst. Yields were dependent on catalyst concentration. The alkyl benzenes were identified by means of: 1) physical constants, 2) infrared spectra, 3) melting points of derivatives, and 4) chemical analysis. Starting with normal alkyl borates, the formation of isomeric and dialkylated products was established through the analytical data.

Enthalpies And Partial Molal Enthalpies For Methane-Carbon Dioxide System, Isaac Pass

Theses

Enthalpies and partial molal enthalpies have been calculated by a combination of analytical and graphical procedures for the methane carbon dioxide binary system at 160°F, and at pressures from 200 to 9000 psia.

Mixtures containing .0852, .19912, .3583 and .6685 weight fraction of methane in carbon dioxide, as well as the pure components were used. The method for calculation of the enthalpies was outlined by Van Ness (1) and involves the application of residuals to the Redlich-Kwong equation of state (2).

The results of this paper illustrate the value of the method as an accurate and reasonably convenient tool. Excellent …

Fugacity And Activity Coefficients For Methane-Carbon Dioxide System, Robert J. Capik

Theses

The Redlich and Kwong equation of state has been used along with the method derived by H. C. Van Ness (18) to calculate the fugacity and activity coefficients of the components of the methane-carbon dioxide system. Calculations have been carried out for the pure gases and four mixture compositions at 160°F. and 280°F. with pressures up to 600 atmospheres.

The method of Van Ness was used because it offered an accurate and simple way of calculating the fugacity and activity coefficients. This is accomplished by a combination of analytical and graphical procedures in which the graphical error is minimized by …

Reductive Dehalogenation Of Alkyl Iodides, Vsevolod Gruenman

Theses

The rates of reductive dehalogenation reactions of alkyl iodides with zinc and acetic acid relative to the rate of deiodination of methyl iodide were investigated.

The order of ease of replacement of the iodine for the various substituents on the carbon atom of methyl iodide was found to be;

Exploratory Study High Purity Colbalt Using An Anion Exchange Resin, Charles Edward Hoffman

Theses

This investigation accounts for the exploratory phase of a program to develop a commercial or semi-commercial process for producing high purity cobalt; in effect, a separation of cobalt and nickel.

An extensive review of all published literature, patents, etc. from 1900 to 1958 of all known commercial, semi-commercial and analytical methods of separating cobalt and nickel was completed. Qualitative evaluation of these methods to determine the possibility of one being practically extended and/or developed to produce high purity cobalt yielded one potential commercial method. Developed for analytical purposes by Moore and Kraus (1), use is made of the fact that …