Engineering Commons^™

Morton’S Gap Culvert-Pipe Installation, James H. Havens

Kentucky Transportation Center Research Report

The attached report, "Interim Performance Report on Morton's Gap Culvert Pipe Installation", by James H. Havens, is primarily a listing of the status of the condition of pipe still in the test and the date of failure or removal of the other sections.

Mr. Havens has prepared as background information, a brief record of the Department's practices involving pipe use for the past 10 years. He has begun with the Research Division's first study into pipe damaged by the corrosive action of acid water. This information is presented primarily because of its significance in the development of the culvert pipe …

Bituminous Concrete Pavement Surface Damage From Soil Action, James H. Havens

Kentucky Transportation Center Research Report

During the last week of August, Mr. J. S. Riley, Supervisory Construction Engineer, Area D, called our attention to a unique problem which arose during the final dressing of the most recent extension of the New Circle Road in Fayette County. Because of the uniqueness of the situation, the memo is intended to be a record of the phenomenon observed and a report of our investigation and analysis of the circumstances related thereto.

Specification For The Design Of Light Gage Cold-Formed Steel Structural Members, American Iron And Steel Institute

American Iron and Steel Institute (AISI) Specifications, Standards, Manuals and Research Reports (1946 - present)

No abstract provided.

Instructions For Contributors, Academy Editors

Journal of the Arkansas Academy of Science

No abstract provided.

Advertising Brochure: 1960 Case Tractors, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

A Study Of The Inlet Characteristics And Entrance Losses Of Pipe Culvert With A Flush Mounted, Sharp Edged Inlet, Luke Lea Callaway Jr.

Masters Theses

"Of all hydraulic structures, culverts are by far the most numerous. Lack of understanding of the functioning of culverts has resulted in many of them being implaced improperly and as a result, they function with less efficiency and at reduced capacity. Much has been written regarding the flow of water in open channels, culverts included, but little has been done regarding inlet conditions. It is necessary in the design of culverts, as with any other structure, that conditions which govern the operation of the structure be established. This paper is a study of the inlet conditions of a circular cross …

Australian Tractor Tests : No. 30, G. H. Vasey, W. F. Baillie

Journal of the Department of Agriculture, Western Australia, Series 4

THIS Report is taken from the full Technical Report No. 30 of this test; test results are shown here in briefer form: fuller explanations are added.

Values quoted may be rounded out to two instead of three significant figures; to this extent the values may differ slightly but not significantly from those shown in the Technical Report.

Graphs of belt test performance, shown in the Technical Report, are not shown here.

Australian Spark Arrester Tests : Spark Arrester For International B-250, W. F. Baillie, G. H. Vasey

Journal of the Department of Agriculture, Western Australia, Series 4

FORMAL tests on spark arresters are conducted by The Tractor Testing Committee at the Testing Station, Werribee, on behalf of those companies concerned with tractors, engines or spark arresters who wish to have these equipments tested.

Shearing Shed Design, W L. Mcgarry, D. A. Young, M. Butler

Journal of the Department of Agriculture, Western Australia, Series 4

PLANNING the layout of a shearing shed requires a good deal of thought to ensure its maximum working efficiency.

If the contemplated structure is to serve the dual purpose of storage-shearing shed, it is better to plan a shearing shed that can be used for storage, rather than a storage shed with a view to its utilisation as a shearing shed.

A Useful Farm-Made Roller, V E. Western

Journal of the Department of Agriculture, Western Australia, Series 4

A very serviceable compacting roller can be constructed at little expense by using discarded truck tyres.

The roller described here has an overall width of 5 ft. 3 in. and carries seven 9.00 x 24 semi-trailer tyres which had been discarded when the treads were worn smooth.

Help Those Lambs To Live, C J. Spencer

Journal of the Department of Agriculture, Western Australia, Series 4

IN almost all breeding flocks the most serious stage of sheep loss is from birth to three days of age with the majority of these losses occurring at birth or during the first day.

The number of lambs lost at this time is rarely known, but survey work shows that on most properties ten to twenty of every hundred lambs born are dead before three days of age.

The economic importance of such losses cannot be emphasised too much. Money has been expended for rams as sires, while the ewes have received extra feed and have had their wool production …

Department Of Agriculture Moved To South Perth, Department Of Agriculture, Western Australia

Journal of the Department of Agriculture, Western Australia, Series 4

After more than half a century in the historic but time-worn building, one of few adorned with the British Government crest of the Lion and the Unicorn, on the Eastern side of government gardens in St George's Terrace, the Departmnet of Agriculture has been transfred to a new location in South Perth.

Tractor Testing In Australia, G H. Vasey, W. F. Baillie

Journal of the Department of Agriculture, Western Australia, Series 4

AUSTRALIA is one of several countries that have set up "official" tractor testing schemes.

These schemes mean testing stations that, while providing a testing service for both the manufacturing industry and the consumer, in effect mainly the farming industries, are independent of either.

Agricultural Aircraft Equipment, N. Shafer

Nebraska Agricultural Experiment Station: Historical Circulars

This bulletin gives a detailed account of the installation, operation, and performance of spray dispersal equipment as tested on the Piper PA-18A airplane. Equipment is also applicable to other types of agricultural aircraft now being used. A list of various aircraft equipment and where it can be obtained is included.

Overcoming Stock Watering Problems In The Kimberleys, B Swan

Journal of the Department of Agriculture, Western Australia, Series 4

ONE of the ever-present problems of the pastoral areas is that of providing: watering-points in reasonably close proximity to the grazing areas.

All too frequently, the country on the river frontages and that in the vicinity of the water-holes becomes eaten out and although there may be ample feed on other portions of the run, it is too far distant from the available water to be effectively utilised.

Termites Or White Ants, Clee Francis Howard Jenkins

Journal of the Department of Agriculture, Western Australia, Series 4

TERMITES are commonly but erroneously called "white ants."

Actually they are more nearly related to cockroaches than to ants, but their general appearance and subterranean habits have given strong support to the popular designation.

They may be divided into two major groups from an economic point of view, viz., wood-dwelling and earth-dwelling termites.

Australian Spark Arrester Tests. Test No. Spa-5 : Caterpillar 3b-2655, W. F. Baillie, G. H. Vasey

Journal of the Department of Agriculture, Western Australia, Series 4

FORMAL tests on spark arresters are conducted by The Tractor Testing Committee* at the Testing Station, Werribee, on behalf of those companies concerned with tractors, engines or spark arresters who wish to have these equipments tested.

The arrester is tested on the engine for which it is specially designed or if this is not convenient (as in this instance) it is tested on an engine having the characteristics and power for which the spark arrester is intended.

Tractor Testing In Australia. Part 2, G H. Vasey, W. F. Baillie

Journal of the Department of Agriculture, Western Australia, Series 4

AUSTRALIAN test procedures, though differing: in some details, and in some ways going further and telling more about the tractor, conform in essentials to overseas standards.

The tests are in four main parts—

(a) the physical properties of the tractor;

(b) the power of the engine, and its stationary outlets—the belt and the p.t.o;

(c) the power on the drawbar when working on a formalised test surface or track;

(d) the reliability of the tractor when running under test, and its condition after the test.

The Burnett Control Gate For Irrigation Channels, B Swan

Journal of the Department of Agriculture, Western Australia, Series 4

THIS type of check-gate for use in irrigation ditches, was evolved on the Kimberley Research Station and has definite advantages over wooden or concrete structures in that it is termite-proof and can be removed and replaced in a few minutes to permit of the channel being cleaned out by straight runs with modern machinery.

Making Your Own Beehives, R S. Coleman

Journal of the Department of Agriculture, Western Australia, Series 4

THE publication of this article runs counter to my own principles to some extent as I have long maintained that most beekeepers will find it cheaper in the long run to purchase factory-made hives and frames.

I realise, however, that many apiarists possess both the skill and equipment to make hive-bodies, and that some at least can occupy slack periods profitably in this manner.

Test 771: Case 541 (Gasoline), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Advertising Brochure: International Harvester B-275, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 733: Mccormick International B-275 (Diesel) Also International 354 (Diesel) 8-Speed, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 807: Massey-Ferguson Mf-50 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

The Redesign And Construction Of A Rotating Disc Contactor, Richard Henry Okenfuss

Masters Theses

"Liquid-liquid extraction has played a major role in the processing of nuclear fuels. The Department of Chemical Engineering of the Missouri School of Mines and Metallurgy realizing this, petitioned the Atomic Energy Commission for funds to design and construct an instructional facility representing the chemical processing of nuclear fuels. With this unit and its solvent recovery equipment, in which stress is placed on extraction and distillation, not only are the principles of nuclear fuels processing demonstrated, but the more basic concepts of mass and energy transfer are also illustrated. Extraction depends upon solubility differences to achieve a transfer of a …

The Separation Of Selected Radioactive Fission Products By Electrodialysis, Jerry David Vie

Masters Theses

"The recent advent of nuclear energy has opened an era of almost unlimited power and countless problems. A problem of extreme importance is the recovery of unburned nuclear fuel and the claiming of transmutation products, such as Pu²³⁹ and U²³³, from the irradiated fuel elements. The chemical processing must also separate the fission products from the fissionable material if the fuel is to be used again.

At present, the irradiated fuel elements are stored for 90 to 120 days to allow the intense short half-life activity to decay. After "cooling down", the nuclear fuels are separated from …

Water Resources Development -- An Analysis Of Economic Justification Practices Of The Corps Of Engineers, Kerwood W. Barrand

Masters Theses

"Presented herein is a brief analysis of the economic justification practices of the Corps of Engineers as commonly implemented in proposals concerning water resources projects. Where applicable, recommended methods are compared to similar methods advocated for, and accepted by, private engineering firms in similar situations.

The major problem exists in the lack of a profit motive in programs undertaken with the use of public funds. However, a profit can be said to have been realized in public works programs if the total benefits of the programs to all the people exceed the costs of these programs and, further, if the …

Stress Distribution In Splined Shafts In Torsion By The Membrane Analogy, Charles L. Edwards

Masters Theses

"The purpose of this investigation is to determine torsional shearing stress distribution in various shapes of shafts. The project will include shafts with circular boundaries. No attempt will be made to show the relation between stress and applied torque"--Preface, page iii.

A Method Of Fuel Testing In A Cfr Engine, George R. Baumgartner

Masters Theses

"At the present time, only a very small fraction of motor fuels produced for domestic use in the United States contain any alcohol in their blends. Soma foreign markets, notably the Philippine Islands and South American Countries use high proportions of alcohol in their motor fuel blends. Special purpose fuels in the United States which have alcohol blended with other compounds, have been used for engines from which maximum horsepower output is imperative. An example of this type of motor fuel blend might be found in the competitive motor sports involving motorcycles, stock automotive equipment, and special racing equipment.

An …

The Status Of Gas-Lubricated Bearings, Bhaskar Dattatraya Shiwalkar

Masters Theses

"The idea of gas-lubricated bearings was suggested as far back as 1854 by Hirn, but it is only very recently that they have aroused a great amount of interest. The interest is centered on the advantages of gas-bearings for the following major applications:

1. High temperature lubrication where ordinary liquid or grease lubrication fails.
2. Bearings operating in radio-active atmospheres where conventional lubrication may break down.
3. Applications sensitive to contamination where fouling from lubricating oil becomes serious.
4. Low-friction devices--an especially important advantage because of the trend to high speed machinery.
5. Applications where positional accuracies down to micro-inches are required.

As a result …