Engineering Commons^™

The Anodic Dissolution Of Zinc In Nitrate Solution., Jo Lisle Reed

Masters Theses

"The increasing demand for protective metals as coatings and non-corrosive alloys has stimulated extensive research on the fundamental behavior of metals in corrosive media.

One of the problems still unsolved is the nature of the mechanism of the anodic dissolution of metals like zinc, magnesium, beryllium, cadmium, and aluminum in aqueous salt solutions. Several schools of investigators have proposed different and opposing theories to explain the discrepancies which often arise between coulometric data and the weight loss of metal electrodes in certain salt solutions.

The purpose of this investigation was to obtain experimental data for the anodic dissolution of zinc …

Correlation Of Chemical Structure And Distensibility Of Polyesters., Nitin Jhaverbhai Bhimani

Masters Theses

"Maleic anhydride and fumaric acid are important raw materials for the manufacture of unsaturated polyesters. Unsaturated polyesters are the esterification products of unsaturated dibasic acids and polyvalent alcohols, polymerized to a high molecular weight resin"--Introduction, p. 1

The Prediction Of The Viscosity Of Multi-Component Non-Polar Gaseous Mixtures At Atmospheric Pressure., Gary D. Fehsenfeld

Masters Theses

"The applicability of the Strunk, Custead, and Stevenson method for predicting the viscosities of multicomponent, non-polar, gaseous mixtures vas investigated. The viscosities of 24 ternary and quaternary gaseous mixtures were experimentally determined, at 3 temperature levels, and compared with the corresponding calculated viscosities resulting from the prediction method. In addition, the published viscosities of 64 multicomponent mixtures were compared with the corresponding calculated viscosities.

Altogether, the viscosities of 136 multicomponent, non-polar, gaseous mixtures were compared. The mixtures contained from 3 to 7 components including 16 different gases in the temperature range from 5• to 1014 ° c, and at a …

A Study Of Rotational Critical Speeds For A Multi-Mass System By Influence Coefficients, Kantikumar G. Patel

Masters Theses

"In this investigation an attempt has been made to determine the critical speeds of a multi-mass rotational system by using influence coefficients. Modes of vibrations are also examined at these critical speeds.

A shaft carrying five masses, supported by bearings at the ends, has been studied analytically. The length of the bearings is considered small with respect to the shaft length and therefore, the configuration is assumed to be point supported as a simple beam. The five masses, each weighing one pound, were placed at equal distances of 10 inches on a 60 inch shaft. The critical speed was examined …

The Effect Of Metallic And Inert Electrodes On The Electrochemical Degradation Of Alkyl Benzene Sulfonate., Thomas Patrick O'Farrell

Masters Theses

"The purpose of this study was to investigate the effects of various metallic and inert electrode combinations on the electrochemical degradation of alkyl benzene sulfonates (ABS) in water and to determine the rate and degree of AB3 removal.

Selected combinations of copper, aluminum, iron, and carbon plate electrodes were studied in systems of tap, distilled and river waters containing an initial ABS concentration of 10 mg/1, using a current density of approximately 0.5 milliamperes per square centimeter and a total detention time of 6 hours. Samples were collected at appropriate time intervals and were analyzed for ABS, chemical oxygen demand …

Lattice Parameters, Thermal Expansion Coefficients, Densities, And Imperfections In Silver And In The Alpha-Phase Of The Silver-Indium System, Samir Moustafa Riad

Doctoral Dissertations

“An investigation of structure insensitive properties (lattice parameters, thermal expansion coefficients, densities, and imperfections) of silver and the α-phase of the silver-indium system was suggested by the desirable uses for silver and its indium alloys.

Both silver and indium used were 99.999 per cent pure. The silver-indium alloys were prepared by melting both metals inside evacuated and sealed fused quartz tubes. The solidified alloys were annealed and then examined by X-ray diffraction for homogeneity.

This experimental work is divided into three main parts:-

I. X-ray diffraction investigation to determine the solid solubility limit of the Ag-In α-phase at 25° C, …

Mechanism Of Siliconizing Of Molybdenum And Tantalum By Vapor Deposition, Gordon Pu Kong Chu

Doctoral Dissertations

"Molybdenum and tantalum were siliconized in an enclosed system by the hydrogen reduction of silicon tetrachloride with induction heating between 900°C and 1450°C.

The siliconizing process was primarily influenced by the gaseous composition, temperature, time, molar flow ratio (SiCl₄/H₂), geometrical shape and ionization charges. The rate of siliconizing, measured as the weight gain by the fused quartz helix balance, generally follows a parabolic law, y = k t^1/2, where y = weight gain, t = time, and k = rate constant. The activation energy is estimated at 21.6 k cal/mole for siliconizing of molybdenum. …

A Study Of Transient Excitations Useful For Determining Vehicle Characteristics : Progress Report, Erling Hestad

JTRP Technical Reports

No abstract provided.

Laboratory Thermal Expansion Measuring Techniques Applied To Bituminous Concrete : Informational Report, C. C. Hooks, William Harner Goetz

JTRP Technical Reports

No abstract provided.

A Study Of Certain Atmospheric Effects On Radar Accuracy, Kenneth R. Swimm

Electrical and Computer Engineering ETDs

Along with other factors, accurate radar target location is dependent upon a knowledge of the electromagnetic propagation path. The propagation path is a function of the characteristics of the medium through which the signal travels. Advances in the resolution capabilities of modern electronic tracking equipment have led to requirements for more accurate prediction of atmospheric refraction characteristics. The inherent error of the equipment is, in many cases, less than the error introduced by the atmospheric refractive effects. After corrections to observed launch angle and target range have been made on the basis of atmospheric refraction information, residual errors in range …

The Irish Plumber And Heating Contractor, December 1963 (Complete Issue)

Building Services Engineering

No abstract provided.

Design Parameters For Fuel Batteries Operating In A Zero G Field, A. P. Hardt, Harold M. Cota, J. L. Fick, T. Katan

Civil and Environmental Engineering

Some design parameters of a hydrazine-oxygen fuel battery operating in a zero G field are described in a digital computer programming treatment. The power balance for a battery employing a gas-producing electrode and an electrolyte pump is treated; optimum power densities and flow rates are established.

The Irish Plumber And Heating Contractor, November 1963 (Complete Issue)

Building Services Engineering

No abstract provided.

The Development Of A Temperature Probe And Temperature Survey Of The Interaction Of An Oblique Shock Wave And A Turbulant Boundary Layer, Donald M. Yano

Mechanical Engineering ETDs

The purpose of this investigation was to develop a miniature air temperature probe and to measure temperatures in the interaction region of an oblique shock wave and a turbulent boundary layer.

Test 855: Allis-Chalmers D-21 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 854: Massey-Ferguson Mf 25 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 853: John Deere 4020 Lpg, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 852: John Deere 3020 Lpg, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

The Irish Plumber And Heating Contractor, October 1963 (Complete Issue)

Building Services Engineering

No abstract provided.

The Magnetocardiogram A New Approach To The Fields Surrounding The Heart, R. A. Stratbucker, C. M. Hyde, S. E. Wixon

Department of Electrical and Computer Engineering: Faculty Publications

Experiments have been conducted which reveal the existence of a detectable magnetic field associated with cardiac electrical activity. The relationship between the magnetic record and the electrocardiogram has been explored and it is shown that under certain conditions of axis orientation the voltage induced into a toroidal sensing element around the heart has the form of the first time derivative of the electrocardiogram. A formula based on Maxwell's equations has been developed to relate these two phenomona.

Test 850: John Deere 4020 Gasoline, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 851: John Deere 3020 Gas, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 849: John Deere 4020 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 848: John Deere 3020 Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 847: Oliver 1900 Series B Diesel 4wd, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 846: Oliver 1800 4wd, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 845: Ford 5000 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT GENERAL CONDITIONS East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers. PREPARATION FOR PERFORMANCE RUNS The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Analysis Of The Transient Response Of A Flat Rotating Disk By Generalized Transforms, Kenneth Wayne Chase

Theses and Dissertations

The object of this thesis was to lay a foundation for a comprehensive study of the dynamic response of rotating members. This initial phase of the study includes a theoretical investigation and proposes experimental techniques for the determination of the stresses and strains in a thin, rotating disk with a concentric hole, subjected to transient shaft inputs. There are many practical applications of this problem including computor memory storage disks, turbine rotors, grinding wheels, saw blades, gears, optical reflectors, and solar sails for space vehicles.

Pc 315/1-1-63, Characteristics Of U.S. Vessels, Vehicles, And Equipment For Amphibious Operations, September 1963, Defense Intelligence Agency Production Center, Robert Bolin , Depositor

United States Department of Defense Military Intelligence

The cover and the forward claim that PC 315/1-1-63 is a publication of the, then new, intelligence Production Center of the Defense Intelligence Agency.

This appears to be an excellent technical-intelligence type document about American weapons and equipment. It could just as easily be a product of Soviet military intelligence. It contains descriptions and illustrations about various categories of landing craft and equipment. The categories of material covered include:

• Landing Craft
• Landing Ships
• Amphibious Vehicles
• Support Ships (including command ships and fire support ships) and
• Auxiliary equipment

The appendices contain information about:

• The capacities of various types of craft
• Comparisons …

The Irish Plumber And Heating Contractor, September 1963 (Complete Issue)

Building Services Engineering

No abstract provided.