Engineering Commons^™

Effect Of Surface Conditions On Nucleate Pool Boiling Of Refrigerant-11, Abbas M. Sinnarwalla

Masters Theses

"The purpose of this investigation was to determine the effect of surface conditions on the heat transfer for nucleate pool boiling from flat horizontal surfaces. Experiments were carried out using Refrigerant-11 at atmospheric pressure as the test fluid with Inconel-600 as the heater material. The heat transfer coefficient was determined for mirror finished, chemically etched, glass beaded and sandpaper roughened heater surfaces over heat flux ranging for 0 to 18000 BTU/HR SQ FT. At a given heat flux, the heat transfer coefficient was found to be the lowest for mirror finished surface and the highest for sandpaper roughened surface"--Abstract, page …

The Evaluation Of Radar Guided Missile Performance Using Various Target Glint Models, Franklin Delano Hockett

Masters Theses

"A radar guided missile seeker approaching a target arrives at a crossover point beyond which the entire target is illuminated by the missile seeker's radar antenna beam. When this occurs, for a complex target, the radar senses a time changing target center location which may greatly complicate the terminal tracking portion of the seeker's flight. This thesis documents various glint models in use today and compares the performance of these models by using a seeker model to determine the effect of glint on terminal tracking performance. A large volume of data has been compiled describing various radar characteristics of complex …

Time And Load Independent Properties Of Bituminous Mixtures: Technical Paper, S. A. Swami, William Harner Goetz, Milton Edward Harr

JTRP Technical Reports

No abstract provided.

Flow In Aggregate-Binder Mixes : Technical Paper, Egons Tons, William Harner Goetz, Virgil L. Anderson

JTRP Technical Reports

No abstract provided.

A Study Of Relative Costs Of Flexible Highway Pavements, Farideh Ramjerdi

JTRP Technical Reports

No abstract provided.

Analysis Of Concrete Slabs On Ground And Subjected To Warping And Moving Loads: Technical Paper, Karl Harcourt Lewis, Milton Edward Harr

JTRP Technical Reports

No abstract provided.

A Generalized Investigation Of Selected Highway Design And Construction Factors By Regional Geomorphic Units Within The Continental United States, Matthew W. Witczak

JTRP Technical Reports

No abstract provided.

Precast, Prestressed Concrete For Bridge Decks : Technical Paper, Martin J. Gutzwiller, Robert H. Lee, Charles F. Scholer

JTRP Technical Reports

No abstract provided.

Carburization Of Type 316l Stainless Steel In Static Sodium, F. B. Litton, Arthur E. Morris

Materials Science and Engineering Faculty Research & Creative Works

The transport of carbon from an iron-87 wt.% carbon alloy through static sodium to Type 316L stainless steel was investigated at temperatures of interest to the liquid-metal fast-breeder reactor (LMFBR) program. The rate-controlling step for the experimental geometry employed was the diffusion of carbon in the source. © 1970.

Exact Solution For A Model Of Dislocation Pipe Diffusion, J. Mimkes, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

The dislocations are treated as an ideal array of parallel pipes of radius and diffusivity Dp embedded in the bulk material of the diffusivity Db. The exact solution of this problem of diffusion along semi-infinite edge dislocations is presented for cubic, tetragonal, and hexagonal crystals. The solution makes it possible to evaluate the dislocation pipe radius a and the ratio of diffusivities from one experiment. It is applied to experimental data for self-diffusion in tellurium available in the literature. The results of the calculations are a dislocation pipe radius a=(1.5 0.5)x10-4 cm and an activation energy for the pipe diffusion …

Test 1046: International Farmall 826 Hydrostatic Diesel (Also International 826 Hydrostatic Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1047: International Farmall 1026 Hydrostatic Diesel (Also International 1026 Hydrostatic Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1048: International Farmall 1456 Diesel (Also International 1456 Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1058: Case 770 Power Shift Diesel, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Test 1061: Case 770 Manual Gasoline, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT

GENERAL CONDITIONS

East tractor is a production model equipped for common usage. Power consuming accessories can be disconnected only when it is convenient for the operator to do so in practice. Additional weight can be added as ballast if the manufacturer regularly supplies it for sale. The static tire loads and the inflation pressures muse conform to recommendations in the Tire Standards published by the Society of Automotive Engineers.

PREPARATION FOR PERFORMANCE RUNS

The engine crank case is drained and refilled with a measured amount of new oil conforming to specifications in the operator’s manual. The …

Australian Tractor Test Report. No. 56. Zetor 5511, G H. Vasey, W. F. Baillie

Journal of the Department of Agriculture, Western Australia, Series 4

AUSTRALIAN TRACTOR TEST REPORT

The Zetor 5511 is a general purpose farm tractor. With 43 drawbar horsepower and 51 h.p. at the P.T.O. at rated engine speed it comes within Class 5 of Australian Standard Classification of Wheeled Tractors for Agricultural Purposes, A.S. Dl0-1967. It is equipped with 18.4 x 28 pneumatic tyres.

It has a five-speed gear box with a High and Low ratio change giving 10 forward and 2 reverse speeds

Super Spreader Distributes Snail Baits, G D. Rimes, W. M. O'Donnell

Journal of the Department of Agriculture, Western Australia, Series 4

THE problem of distributing snail bait on broad acres has been overcome by simple modifications to a conventional super spreader.

Urea Drilled With Seed Affects Germination And Yield, M G. Mason, A. Loutit, J. A. C. Smith, D. Highman, P. Stallwood

Journal of the Department of Agriculture, Western Australia, Series 4

Trials in 1968 at Burracoppin and York again showed it is safer to topdress urea just before seeding than to drill a mixture of seed and urea.

At all but the lowest urea rates, urea drilled with the seed reduced the number of plants emerging and surviving, and reduced final wheat yields.

The Setting And Control Of Disc Ploughs, P A. Taylor

Journal of the Department of Agriculture, Western Australia, Series 4

THE trailed disc plough is the most commonly used tillage implement in Australian broadacre farming, yet it is considered in some areas to be difficult to set and to operate. These notes provide information resulting from C.S.I.R.O. research to assist operators in the control and operation of trailed disc ploughs.

How Many Acres Per Hour?, J G. Drever

Journal of the Department of Agriculture, Western Australia, Series 4

MANY farm tractor operators don't know exactly how much land is covered in an hour by implements drawn by their tractors. This information, useful on any farm where tractors are used, is of particular value in contract work.

The capacity of the machine or implement, or in other words, its rate of working, depends on the width of the machine, how fast it travels, how efficiently it is operated and the time it works.

Electrochemical Reduction Of Chromate In The Presence Of Nickel Chloride In Molten Lithium Chloride-Potassium Chloride Eutectic, Branko N. Popov, H. A. Laitinen

Faculty Publications

Chronopotentiometry of chromate in the presence of NiCl₂ in molten LiCl-KCl eutectic reveals a diffusion controlled, three electron reduction step. In the presence of excess NiCl₂, chromate is reduced at −0.35V vs. Pt(II)/Pt reference electrode and the electroactive species responsible for the chrono-potentiometric wave is estimated to have a diffusion coefficient of 1.06 · 10⁻⁵ cm² sec⁻¹ at 450°C. The stoichiometry of the reduction product depends mainly on the temperature at which the deposit is formed. At 500°C the deposit approaches the composition LiNi₂CrO₄. X-ray powder diffraction shows the deposit …

Stability Of Asymmetric Hydrodynamically Developing Channel Flows, T. S. Chen, E. M. Sparrow

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Linear stability is studied for developing channel flows induced by asymmetric velocity profiles at the inlet. Neutral stability curves and axial variations of the critical Reynolds number are presented, showing greater stability for more skewed inlet profiles.

Linear Regression Models Of Sound Velocity In The North Atlantic Ocean Below A Critical Depth, Richard Roland Kunkel

Doctoral Dissertations

"Sound velocity models currently in use by the U. S. Navy require difficult data sampling at great expense. This study is to investigate the feasibility of a sound velocity model dependent only upon position that would be valid for a selected, reasonably large, near homogeneous area of the ocean. The most important position parameters are latitude, longitude, and depth. To accomplish this objective a critical depth of 2500 meters was established for an 8° by 20° rectangle of the Sargasso Sea which lies within the North Atlantic Ocean. The critical depth is defined as the depth at which the characteristics …

Diffusion And Internal Friction In Sodium-Rubidium Silicate Glasses, Gary L. Mcvay

Doctoral Dissertations

"The internal friction and self diffusion coefficients of sodium and rubidium ions for (1 - X) Na₂O·X Rb₂O·3 SiO₂ glasses have been measured. The diffusion measurements employed radioactive isotopes and a thin sectioning technique and extended from 350 to 500°C. Internal friction measurements were made from -150 to 500°C and at frequencies of 0.05 to 6000 Hz. The maximum height for the mixed alkali internal friction peak occurs at the composition where the sodium and rubidium diffusion coefficients are equal. It is concluded that the mechanism responsible for the mixed alkali peak is a cooperative rearrangement of sodium-rubidium ions and …

Anodic Dissolution Of Zinc In Potassium Iodide-Potassium Iodate Solutions, Chi-Chiu Yao

Doctoral Dissertations

"The anodic dissolution of Zn was studied in KI-KIO₃ solutions at 25ºC. In I⁻ solutions, it was found that the apparent valence of Zn ions going into solution is approximately two. Smaller values are obtained in IO₃⁻ solutions, with the most pronounced changes occurring in the higher concentrations. An empirical equation is derived relating the apparent valence (or anode efficiency) to the current density and concentrations of IO₃⁻ and I⁻. An anodic dissolution mechanism is proposed"--Abstract, page 1.

Water Management Research In Arid And Sub-Humid Lands Of The Less Developed Countries: Second Annual Progress Report, Utah Water Research Laboratory

Reports

No abstract provided.

Subcritical Flow At Open Channel Structures Bridge Constructions, Gaylord V. Skogerboe, Lloyd H. Austin, Kuan-Tao Chang

Reports

The techniques previously employed by the writers for describing subcritical flow at open channel constrictions have been found valid for analyzing nonuniform flow in open channels. Combining the nonuniform flow analysis with the submerged flow ratings for various bridge geometrics has provided an analytical means for determining the backwater due to the bridge constrictions under “abnormal stage – discharge” conditions.

Formulation And Solution Of Transient Flow Of Water From An Infiltrometer Using The Kirchhoff Transformation, Roland W. Jeppson

Reports

No abstract provided.

Determination Of Hydraulic Conductivity--Capillary Pressure Relationship From Saturation--Capillary Pressure Data From Soils, Roland W. Jeppson

Reports

No abstract provided.

Transient Flow Of Water From Infiltrometers--Formulation Of Mathematical Model And Preliminary Numerical Solutions And Analyses Of Results, Roland W. Jeppson

Reports

The partial differential equation initial-boundary value problems which describe the three-dimensional axisymmetric flow of water from an infiltrometer through partially saturated soil are solved by finite differences using the alternating direction implicit method. Pertinent features which describe the flow characteristics obtained from 34 solutions for varying initial conditions and for 12 soil types are summarized in tables and figures. Relationships between such features as depth of penetration and lateral movement of the wetting front and rate of application and initial hydraulic head or tension in the soil are developed for several of these soils types from analyses of the results.