Engineering Commons^™

The Composition And Analysis Of Zinc-Lead Pigment, Evans Walker Buskett

Professional Degree Theses

"Zinc is present as oxide and sulphate. There are also probably zinc and lead sulphites. It has been suggested that there may be carbonates in this pigment, but this is not probable as the high temperature of the furnace, the complete combustion of the fuel to CO2 and the large excess of SO2 gas in the bagroom would tend to prevent their formation. There is also a chemical combination between the zinc oxide and the lead oxide which is probably a zinc plumbate. Some light can be thrown on the subject by the following experiments:"--page 1.

Design Of A Lead Blast Furnace, Walter Irving Phillips, Andrew Jackson Seltzer

Bachelors Theses

"In order to get the approximate size of the Furnace we made the following assumptions, being guided as far as possible by the practice of the Globe Smelting Works at Denver, Colorado whenever that could be ascertained"--page 1.

Chemical And Physical Analysis Of Steel And Iron, John T. E. Ericson

Bachelors Theses

No abstract provided.

The Manufacture Of Coal Gas In St. Louis, Albert Dyke Wilson

Professional Degree Theses

"Coal gas is made by heating Bituminous Coal in closed fire-clay retorts, for four or five hours, at a bright red heat. An exhauster pulls the gas from the retort as fast as it is generated in order to prevent, as much as possible, the breaking up of the hydrocarbons into carbon and hydrogen by the hot molls of the retort"--page 2.

Analytical Determination Of Copper Products, Charles Dosh Smith

Bachelors Theses

"It is a well known fact that the presence of impurities in copper products has been a source of annoyance to the Chemist. The object of this thesis was to make myself familiar with the actions of different impurities in copper products, and the methods for the determination of Arsenic in the same"--page 1.

Neutralization Of Free Acid (H₃P O₄) In Commercial Mono-Calcium Phosphate (Ca H₄ (Po₄), George William Harris, Harry Adam Grine

Bachelors Theses

"The object of this thesis has been a systematic research based on the characteristic properties and reactions of mono-calcium phosphate, Ca H₄ (PO₄)₂, tending towards the development of a process for neutralizing the free phosphoric acid, H₃PO₄ formed during its manufacture"--page 1.

Influence Of Time And Temperature In The Roasting Of Sulphides, Roger Hanson Hatchett

Bachelors Theses

"The original object of this work was to determine the relation between the quantities of oxide and sulphate formed in roasting a sulphide under known conditions of temperature, time and supply of air. But difficulties arose in constructing apparatus, which in the short time allotted could not be overcome. These are mentioned in description of apparatus, and were of such a nature that the relations between products and conditions are for the most part qualitative"--page 1.

Assay Of Copper Matte For Gold And Silver, Walter E. Soest

Bachelors Theses

"Ores containing copper, and especially copper matte, have always been very annoying in assaying for the precious metals. In assaying copper matte, and ores containing much copper, by the usual method of scorification, the losses of silver an gold are considerable, owing to the fact that in order to obtain lead buttons, which are soft and free from copper, repeated scorifications are necessary, and moreover it is impossible to obtain lead buttons which are entirely free from copper"--page 1.

Action Of Caustic Hydroxides Upon Aluminum, Herbert Fordyce. Rogers

Bachelors Theses

No abstract provided.

White Lead, Evans Walker Buskett

Bachelors Theses

No abstract provided.

Producer Gas, Edward P. Dwyer

Bachelors Theses

"Producer gas, so named owing to being produced in special forms of apparatus known as Producers. The fuel is decomposed into combustible gases, whereby most of the C is burnt to CO, whilst the H either remains free, or is converted into carburretted Hydrogen. Directly above the grate carbonic anhydride is formed but thus is rapidly converted into carbonic oxide; reaction as follows: CO₂ + C = 2CO.

Amongst these heavy carburetted hydrogen (C₂H₄) is that which principally increases the value of the gas as fuel and the drier the fuel used the more of the gas is produced. A …

Russell's Lixiviation Process For Silver Ores, Frank L. Tyrrell

Professional Degree Theses

"It has long been known that there are many ores worked in which a large per cent of silver and gold are continually lost, either in tailings or slimes. As far back as 1848 Dr. Percy suggested the extraction of silver from argentiferous ores, by its conversion into the chloride. The chloride was treated with sodium hyposulphite"--Russell's Process, page 1.

The Cyanide Process For Gold, John C. Reid

Bachelors Theses

"Since the discovery of Cyanogen in the latter part of the 18th century records of many experiments are in existence, showing, that at various periods, exhaustive researches have been made, in which the point at issue was to investigate that property which now constitutes the foundation of what is known to Metallurgical Science of today as The Cyanide Process, vis. The solvent power of alkali cyanides on gold & silver"--page 2.

Aluminum, Edward Mackey Johnson

Bachelors Theses

"Ores: Cost of Production: Alloys. It is not the purpose of this thesis to discuss all the ores in which Al is found, but to describe rather fully the ores from which Al is obtained: such as Bauxite and cryolite. In regard to the alloys only the principal ones will be considered and described, especially the Al-bronze which is a very important alloy of copper and Al"--page 1.

Problem For Examination In Metallurgy, Herman H. Schwarz

Professional Degree Theses

"It is required to furnish plans, specifications and estimate for a Flintshire furnace, capable of smelting 2100 pounds of good galena, per shift of 8 hours. Give two drawings showing elevation and plan, drawn to a scale of 1/2 inch to the foot.

Fire brick, red brick and iron to be shown in colors. Estimates must cover both iron and brick work"--Problem to be Solved, page 2.

Ore Of Certain Composition, Walter W. Wishon

Professional Degree Theses

The metallurgic treatment of an ore having the following composition:
SiO₂ 20.10
PbS 9.90
ZnS 40.25
CuS 19.75
Sb₂S₃ 4.95
Ag₂S 3.10 or 787.48 oz per ton
Undeter. 1.95
100.00

To obtain the Silver by the Chlorination and Amalgamation process. The discussion of the subject consists of the following sections:
1st Preparation of the Ore
2nd Roasting
3rd Amalgamation
4th Retorting
5th Fusion in the Bars

The Metallurgic Treatment Of An Ore For Lead And Silver, Arthur C. Carson

Bachelors Theses

"The metallurgic treatment of an ore for Lead and Silver….

The discussion of which will consist of the following steps;

1. Preparation of ore for smelting, which consists in roasting, and of the addition of fluxes such as will produce an easy flowing slag as the ... silicate
2. The Production of Crude Lead, which will contain the Silver
3. Extraction of Silver from the Crude Lead, which includes the retorting of the zinc-silver alloy and the cupellation of the rich lead
4. The Refining of the desilverized lead"--page 1.

The Production Of Spelter From Zinc Blende, Lee R. Grabill

Bachelors Theses

"The problem which has been assigned to me for discussion as examination in metallurgy, is the treatment of a zinc blende from Sevier County, Arkansas; using the common Missouri or Illinois coal for fuel and the Spadra coal of Johnson County, Arkansas, as a reducing agent in the distillation process; and as clay for the manufacture of retorts, etc. that from the works at Cheltenham, Missouri, furnished by Parker, Russell & Company. Analysis of the materials used are to be given with details of processes and drawings & descriptions of machinery used; also approximate cost of furnaces, and approximate cost …

Treatment Of Gold And Silver Ores As Found In The Comstock Lode, Lee R. Grabill

Professional Degree Theses

"Statement of Problem: Metallurgy of Gold, etc.

Required, description of process and machinery used in the extraction of Gold and Silver from earthy and siliceous ores as found in California, the ores being represented by the following- SiO₂, 91.44; (Zn,Pb)+Cu₂S, 1.38; Al₂O₃, Fe₂O₃, etc. 6.39; Au, .0017, Ag₂S .12, Variable in 1st, 2nd, and 3rd class ores.

1° - The methods, etc. employed in treating 1st class ores, -such as exceed in value $150 per ton.

2° - Methods, etc. in treating 2nd class ores, such …

Metallurgy Of Gold, Wilton R. Brown

Bachelors Theses

"Metallurgy of Gold: Problem

Required, description of processes and machinery used in Extraction of Gold (and Silver) from earthy or siliceous ores as found in California

Ores represented by following:--SiO₂ 91.44; S(Zn,Pb)-Cu₂S 1.38; Al₂O₃, FeO &c 6.39; Au .0017, Ag₂S .12, variable in 1^st and 2^nd class ores

1⁰--The methods &c. employed in treating 1⁰ class ore (i.e. such as exceed in value $150 per ton)

2⁰--The methods &c. in treating 2⁰ class ore, such as contain less than $150 per ton.

Give in detail the chemistry of each process described; also illustrated by drawings of machinery for …

Silver Amalgamation, James A. Pack

Professional Degree Theses

"The process of amalgamation is one of the oldest known methods of extracting silver from its ores. The process arose from the finding of rich silver ores in districts where little or no fuel existed.

This method of silver extraction has been known and used for over three hundred years; but the method of pan amalgamation which came into use much later and has been so fully developed under American management is the one which we will here consider.

The process of pan amalgamation is peculiarly adapted to certain mining districts of the western territory of the United States"--page 2.

Project For The Treatment Of An Iron Ore, James A. Pack

Professional Degree Theses

"So great is the degree of perfection that marks the various processes of iron production that it seems almost useless to essay to further study a subject which has received the best thoughts and lifetime labors of the greatest metallurgists of all ages. Yet as we believe that there are still isolated cases whose various conditions have not received that consideration necessary to the most economical production of the pug; and believing that a most perfect knowledge of these conditions is essential to the final perfection of the metallurgy; and knowing further that a wide extended interchange of experience and …

De Re Metallica, Georgius Agricola

Rare Books

No abstract provided.