Engineering Commons^™

A Finite Element Analysis Of Wood In Transverse Compression, A Mrema

Tanzania Journal of Engineering and Technology (TJET)

A two dimensional finite element analysis is utilized to predict the stress and strain distributions for wood in transverse compression. Important key var iables are incorporated into the ana lysis to define their influence on the stress and strain distributions. These variables are geometry of loading, geometry of specimen and the orthotropic ratio of the material. Based on the finite element analysis results, relationships are arising stress from developed relat ing maximum stress concentrations to the above three variables. possible appl ications of the results from this study relate to the development of more efficient design of connections such as …

Experimental Investigations On The Behaviour Of Wood In Transverse Compression, A Mrema

Tanzania Journal of Engineering and Technology (TJET)

Experimental investigations were done to study the behaviour of wood in transverse compress ion. Three key variables were incorporated in the experiments to study their influence on the •nriables were the orthotropic ratio of the behav iour. These material, the geometry of loading and that of the specimen . Deformation measurements were made at selected locations on test specimens by means of strain—gage based clip gages. Results from the experimental measurements were compared to previous deformation predictions made by a finite element analysis (9) . There is a very good agreement between measured values and those obtained trom the finite …

Frictional Resistance Of Geotextiles, Md. Khairul Alam

Theses

The pullout resistance of geotextiles was examined using pullout tests. A suitable wooden box with large (2 ft x 2 ft x 4 ft) dimensions was used to avoid the effect of boundary and to simulate field conditions. Two types of failure patterns were observed. For shallow embedment (<3 ft), geotextile produced a movement of the surrounding mass of sand in the shape of an inverted cone due to interlocking friction between geotextile and sand particles. The cone angle decreases with increase in depth of embedment. For embedment equal to or greater than 3 ft., no sand cone developed and the failure occurred along the interface of geotextile and sand. For 1 ft. surcharge, the increase in the pullout resistance due to combined horizontal and vertical embedment was about 30 %.

Stability And Durability Of Large Aggregate Asphalt Concrete, Rais A. Khan

Theses

There are many factors which affect the properties of asphalt concrete and one of these is a maximum aggregate size used in the mix. In this study of the effect of maximum aggregate size on Marshall stability, flow and durability of asphalt aggregate mixtures is investigated.

Two different mixes having gradations with maximum aggregate sizes of 3/4 and 1-1/2 inches were considered. The optimum asphalt content for mix having 3/4 inch maximum aggregate size, was determined by the standard Marshall procedure. The optimum asphalt content for the mix having 1-1/2 inch maximum aggregate size, was estimated based on thickness of …

Strength And Fragility Of Concrete, Kang-Qun Shao

Theses

It is known that both strength and fragility are two of the most important properties in concrete. In this research, theories of Chemistry, Physical Chemistry of Surfaces, Thermodynamics and Fracture Mechanics are used to study the relationships between the macromechanical behavior of concrete and the microstructure in concrete. The objectives of this research are therefore to find some effective ways to explain theoretically why the concrete is so brittle (fragile) and how to increase its strength or to decrease its fragility. Based on the present studies, an equation is formulated to calculate the coefficient of the fragility (or brittleness) of …

The Strength Of Cement Bentonite In Containment Structures, Liong Tin So

Theses

In recent years the use of cutoff or slurry walls has increased in the containment of hazardous waste. Several materials have been utilized for backfill in slurry walls. Two important properties of the material are shear strength and permeability. Previously, sodium bentonite had been used. However, it was discovered that variable pH would cause an increase in permeability. Studies have shown calcium bentonite have a constant permeability with varied pH (Oweis and Khera, 1990). This study was undertaken to determine strength of calcium bentonite as affected by cement and slag.

Triaxial shear tests and unconfined compression tests were done on …

Limits Of Limit Equilibrium And Finite Element Techniques Applied To Cracked Debris Dams On Collapsing Foundations, Stanley Soliday Jr.

Dissertations and Theses

Limits of slope stability, limit equilibrium methods, and of the finite element code FEADAM are reached in the application of these methods to the problem of cracked dams constructed on collapsing soils.

Utilizing a generic dam, various classic slope stability approaches are tested as possible dam slope failure mechanisms. Slope stability methods are rejected as a way to accurately define and quantify the collapse problem. As a result of this work a block rotation mode of collapse is postulated. Then the finite element method (FEM) is used to try to define and quantify the collapse problem. The FEM is applied …

An Expert System For The Civil Engineering In-Service Work Plan, Philip W. Melancon

Theses and Dissertations

Civil Engineering managers make many decisions each day which could be aided using expert system technology. One of the most important decision processes affecting CE operations is the scheduling of work order to be accomplished each month. A good work order schedule, or In-Service Work Plan (IWP), can ensure that material and manpower resources are fully utilized, that base facilities are properly maintained, and that customers are satisfied. The purpose of this research was to build and test a PC-based prototype expert system to schedule the IWP. Expanding on previous research, a multiplicative weighting technique was developed to provide relative …

Stochastic Hydrologic Modeling In Real Time Using A Deterministic Model (Streamflow Synthesis And Reservoir Regulation Model), Time Series Model, And Kalman Filter, Philip Kwok Fan Tang

Dissertations and Theses

The basic concepts of hydrologic forecasting using the Streamflow Synthesis And Reservoir Regulation Model of the U.S. Army Corps of Engineers, auto-regressive-moving-average time series models (including Greens' functions, inverse functions, auto covariance Functions, and model estimation algorithm), and the Kalman filter (including state space modeling, system uncertainty, and filter algorithm), were explored. A computational experiment was conducted in which the Kalman filter was applied to update Mehama local basin model (Mehama is a 227 sq. miles watershed located on the North Santiam River near Salem, Oregon.), a typical SSARR basin model, to streamflow measurements as they became available in simulated …

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

Applying The Theory Of Constraints To A Base Civil Engineering Operations Branch, Bryan K. Zachmeier

Theses and Dissertations

The purpose of this thesis is to introduce the Civil Engineering manager to the Theory of Constraints management philosophy and to show how to apply this process of ongoing improvement to the Operations Branch. One of the reasons for the success of Theory of Constraints in commercial firms is that it provides all levels of management the ability to find simple solutions for bridging the gap between local and global issues. This 'bridge' is built by clearly defining the goal of the organization and using performance measurements capable of predicting the effect of local decisions and actions on the goal. …

Bs News

Building Services Engineering

No abstract provided.

Engineering Soils Map Of Washington County, Indiana, Wei-Yao Chen

JTRP Technical Reports

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

An Experimental Study On Anisotropic Behavior Of Granular Materials, Jong Woon Choi

Civil & Environmental Engineering Theses & Dissertations

Two types of mixtures of glass bead assemblies (large beads and small beads) were used to investigate the source of the anisotropy of granular materials in volume change behaviors during shearing process. Most tests (7 series) were conducted in the conventional triaxial device while a series of the experiments were in the hollow cylinder test device. All the specimens were first isotropically consolidated up to 137.9 kPa and were subjected to shearing in triaxial compression and triaxial extension modes with a constant effective mean normal stress (137.9 kPa). The test results indicated that all the specimens had a strong but …

Parallel-Vector Design Sensitivity Analysis In Structural Dynamics, Yongxing Zhang

Civil & Environmental Engineering Theses & Dissertations

In this study, the design sensitivity analysis is for the purpose of providing constraint derivative information for structural optimization under dynamic loads. Various existing formulations are reviewed, and the direct differentiation method is justified as the best one for design sensitivity analysis in structural dynamics. An alternative formulation for design sensitivity analysis with direct differentiation method is developed. The alternative formulation works efficiently with the reduced system of dynamic equations, and it eliminates the need for expensive and complicated eigenvector derivatives, which is required in the existing reduced system formulation. The relationship of the alternative formulation and the existing reduced …

Parallel-Vector Computation For Geometrically Nonlinear Frame Structural Analysis And Design Sensitivity Analysis, Majdi A. Baddourah

Civil & Environmental Engineering Theses & Dissertations

Parallel-vector algorithms are presented for solving the geometrically nonlinear structural problems and obtaining design sensitivity information. A new algorithm is also presented for parallel generation and assembly of the finite element stiffness and mass matrices. The presented assembly algorithm is based on a node-by-node approach rather than the more conventional element-by-element approach. Three different methods, Newton Raphson, Modified Newton Raphson, and the BFGS, are used in the analysis of the nonlinear structural problems. A study is made to determine the performance of each of the mentioned methods in a parallel-vector computer environment. Medium to large-scale, practical problems are solved to …

Bs News

Building Services Engineering

No abstract provided.

Evaluating The Role Of Geogrids In The Rehabilitation Of Cracked Dams Via Numerical Techniques, Kelly Dean Uhacz

Dissertations and Theses

Collapse and cracking of debris earth embankment dams is a serious problem in areas of the arid Western United States. The use of geogrids is evaluated in this thesis as a possible solution to prevent or reduce the amount of damage to the structures from collapse and cracking.

An apparatus was designed, constructed, and instrumented to electronically acquire data to evaluate the behavior of geogrids during pullout tests under various normal stresses. The pullout tests were also modelled using numerical techniques to correlate physical test data with numerical test data. Understanding the behavior of the geogrid, in both the physical …

Load-Deformation Behavior Of Reinforced Fibrous Concrete Beams, Rujun He

Theses

This study deals with the load-deformation behavior of steel fiber reinforced concrete beams.

Theoretical development of moment-curvature and load-deformation relationships is presented in this paper. It is based on the assumption that the failure at a section occurs either when the force equilibrium equation is violated or when the concrete elements start to get crushed in the member. The complete stress-strain relationship of plain fibrous concrete in reference [2] was used in this study.

A special computer program is presented herein to carry out the theoretical studies of load-deformation behavior of simply supported beam under two-point loading. The validity of …

Automated Determination Of Air Content In Hardened Concrete, Anita R. Navalurkar

Theses

An automated system was developed for the microscopic determination of air content and the related parameters in hardened concrete using the principles of Image Analysis and Computer Technology. Slices taken from the concrete specimen were viewed through a microscope with 40X magnification. The magnified image of the concrete slice is digitized by an Image Analyzing Software. Methodologies were developed for analysis of the digitized image and determination of air content and the required parameters. The automated system included a motorized positioner which translated microscope stage in a frame by frame sequence so that the whole image is digitized. Several tests …

Evaluation Of Cracking Mechanism In Fiber Reinforced Concrete Subjected To Impulsive Loading, Rajendra K. Navalurkar

Theses

This thesis presents an experimental evaluation of J-Integral for plain and fiber reinforced concrete subjected to impact loading. A computer assisted instrumented Charpy test system was employed in applying the impact loads. Twenty two three point bend specimens with two different notch lengths were tested under impact velocity of 43.29 in/sec. Development and testing of a new fiber optic sensor, for the determination of internal Crack Tip Opening Displacements (CTOD) in concrete is described.

Evaluation of J_IC values from experimental results of this study indicate that J_IC can be characterized as a material constant. The Dynamic value of …

Water Treatment Plant Sludge As Sanitary Landfill Liner, Sinnadurai Sockanathan

Theses

This study was performed to explore the possibility of using the sludge waste from the water treatment plant at Boonton New Jersey as a containment material for the sanitary landfills or as a fill material. At present natural clay is being used as a containment liner for the landfills and by using this sludge, recycling of a waste product will be achieved in an economical manner.

As a first part of this studies, efforts were made to utilize the liquid sludge having a solid content of about 3%. Attempts to dewater the liquid sludge to a workable mix by adding …

Determination Of Water-Cement Ratio In Cement Paste By Atomic Absorption Spectrometry, Jiong Zhao

Theses

As one of the important characteristics of concrete, water-cement ratio controls porosity and thus strength and corrosion resistance of hardened concrete.

This paper presents a laboratory observation for determination of water-cement ratio of fresh concrete for quality control and quality assurance. The atomic absorption spectrophotometer and the flouresence spectrophtometer were used to determine the calcium concentration in cement solution of various water-cement ratio. The level of water-cement ratio investigated ranged from 0.4 to 0.55 which covers the most range of water-cement ratios in present practice. The result of lab experiments shows an immediate relation between the water-cement ratio and the …

Influence Of Fly Ash Characteristics On Compressive Strength Of Mortar, Poorna Rajeswari Ratnaweera

Theses

Fly ash-cement mortar, constituting of fly ash, cement and sand, vary in strength characteristics from conventional cement sand mortar. Out of many parameters effecting the compressive strength characteristics of fly ash-cement mortar, four were investigated in this study. They are particle size and its distribution, weathering of fly ash, moisture content & water/cementitious ratio and mix proportioning.

Class F fly ashes from three different sources were used in this study. The particle size distribution and moisture content of fly ashes were investigated by standard ASTM methods. The unconfined compressive strength of mortar was obtained by testing 2"x2"x2" test cubes conforming …

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

Precipitation And Inter-Event Dry Periods For Selected Areas Of Florida, Teresa Rae Lineback

Retrospective Theses and Dissertations

The increase in the pollution of existing water bodies due to poor management of storwater runoff has demanded continuous re-evaluation of present design methods for stormwater management facilities. Current criteria used in determining water quality (treatment) volumes in pond design neglect antecedent conditions resulting from preceding rainfall. The inter-event dry period refers to that time period (hours) which occurs between rainfall events. The

minimum inter-event dry period used for pollution control design should be consistent with the time required for infiltration, chemical precipitation, sediment removal, and biological assimilation; as well as the period of time required to minimize the cumulative …

Design Curves For The Reuse Of Stormwater, Gregory Miller Harper

Retrospective Theses and Dissertations

The reuse of stormwater runoff is becoming an increasingly popular addition to stormwater management systems. The advantages include a reduction in pollution and volume discharges to surface waters, the return of runoff to the ground, and savings in the cost of using potable water. This research, by developing a relationship between the reuse volume (temporary storage volume), the rate at which stormwater is reused, and the percentage of annual surface runoff that is reused, provides a procedure in which to design stormwater reuse systems. The traditional design of pond temporary storage volume has been based on the consideration of water …