Operations Research, Systems Engineering and Industrial Engineering Commons^™

Investigating Potential Improvements To Mbse Software To Support Dodaf, Jennifer Marie Kimpson

Theses and Dissertations

The integration of models created through model-based systems engineering methods with DoDAF is not a new concept. By creating DoDAF-aligned models, DoD program managers are following DoD guidelines to hopefully achieve more effective communication with stakeholders and improve efficiency of their programs. With the use of MBSE tools to create these models, DoD program managers are able to take further advantage of the benefits of MBSE methods. However, even with the use of MBSE tools, there continue to be issues throughout DoD programs. The literature has shown that a continuous improvement approach regarding the use of MBSE tools with DoDAF …

A Design Science And Implementation Framework For Studying Interruptions And Its Application In A Dental Clinic., Carsten Ziegler

Electronic Theses and Dissertations

Interruptions during dental treatment are frequent, and often have detrimental effects on quality of care, patient safety and processing times, and have an impact on provider satisfaction and performance. Interruptions can significantly increase the cognitive load on dental providers, making it hard for them to concentrate on complex procedures. Frequent interruptions also disrupt the workflow in general, leading to delays in treatment, which can reduce the overall throughput of a clinic. Unfortunately, there is no comprehensive approach to collectively (i) analyze interruptions in dental healthcare, (ii) design an intervention, and (iii) implement and sustain it. This research proposes a comprehensive …

A Transdisicplinary, Survivor-Centered Approach For Creating A System Dynamics Model Of Closed-Buyer Sex Trafficking Networks, Kemonte Yow

All Theses

One of the largest drivers of sex trafficking operations is the demand for commercial sex. To date, research from a quantitative side typically focuses on understanding how to best identify and remove victims from their trafficking situation and then support their healing and recovery. This may be because this is where data exists (in limited forms) to support quantitative modeling. This thesis broadens that scope to understand how demand for commercial sex impacts trafficking operations. In particular, this research implemented a transdisciplinary, survivor-centered approach to build a system dynamics model of a closed-buyer sex trafficking network, which is a network …

Denoising Diffusion Probabilistic Models Based Accelerated Mri, Alexander Francis Bugielski

Theses and Dissertations

Magnetic Resonance Imaging (MRI) is a cornerstone in obtaining intricate visualizations of anatomy and physiological processes within the human body. However, its extensive scan duration not only causes patient discomfort but also increases the likelihood of motion-induced artifacts in the images. To address such a challenge, this study investigates deep neural network models for reconstructing high-resolution MRI images from noisy and significantly undersampled data in a supervised learning manner. Specifically, it compares three models: a conventional U-Net, a self-attentive U-Net, and an innovative probabilistic diffusion model that builds upon the self-attentive U-Net architecture. These models are evaluated on their ability …

An Adaptive Large Neighborhood Search For The Multi-Vehicle Profitable Tour Problem With Flexible Compartments And Mandatory Customers, Vincent F. Yu, Nabila Yuraisyah Salsabila, Aldy Gunawan, Anggun Nurfitriani Handoko

Research Collection School Of Computing and Information Systems

The home-refill delivery system is a business model that addresses the concerns of plastic waste and its impact on the environment. It allows customers to pick up their household goods at their doorsteps and refill them into their own containers. However, the difficulty in accessing customers’ locations and product consolidations are undeniable challenges. To overcome these issues, we introduce a new variant of the Profitable Tour Problem, named the multi-vehicle profitable tour problem with flexible compartments and mandatory customers (MVPTPFC-MC). The objective is to maximize the difference between the total collected profit and the traveling cost. We model the proposed …

Causes And Consequences Of Inefficient Drilling And Blasting In Mine Development Headings: A Case Study Of Hard Rock Gold Mining Operations In Northern Tanzania, George Bennett

Tanzania Journal of Engineering and Technology (TJET)

Despite the introduction of the perimeter blasting technique at the Tulawaka Gold Mine, the mine continued to suffer from an overbreak of mine development headings, with an average overbreak of 24% every 22 m, which is approximately twice the acceptable 10% overbreak. The causes of this problem include ineffective drilling practices and uneven and excessive charging of explosives, resulting in a slightly high powder factor of 3.94 kg/m3 instead of 3.8 kg/m3, as per the design. The problem of overbreak resulted in ore dilution, a longer mine development cycle time and additional costs of approximately US$ 45 per cut, especially …

An Optimization Tool For A Standalone Photovoltaic System, Johanes Kasilima

Tanzania Journal of Engineering and Technology (TJET)

Stand-alone photovoltaic systems (SAPV) are often used in remote areas where access to grid electricity is limited. This system depends on solar energy. However, Photovoltaic (PV) systems need a greater initial investment than conventional sources of energy, and their effectiveness is reliant on a number of environmental conditions such as the unpredictable solar radiation. One step in reducing the investment cost of a PV system is determining the optimal size of solar PV components that minimize costs. This paper presents a Particle Swarm based optimization tool for sizing Stand-alone PV systems. The optimization tool selects the optimal Levelized Cost of …

Design And Optimization Of An Azeotropic Distillation Pilot Plant For The Production Of Pure Ethanol, Samwel V. Manyele

Tanzania Journal of Engineering and Technology (TJET)

This study aimed to design an azeotropic distillation plant using Aspen Plus® V10 software and determine optimal process conditions for producing pure ethanol greater than 95% from pre-concentrated near-azeotropic ethanol-water solution. The non-random two-liquid Redlich-Kwong thermodynamic model was the base method for property analysis and performance prediction. Modelling and simulation of the converged process were conducted for fixed column variables (R = 5, N = 12 and p = 1 atm). Plant operating parameters were varied in the range of 0 to 1 for the pre-heater vapour fraction, 2 to 10 for the column feed plates (NFP), 2 to 6 …

Effect Of Zr And W Doping On Microstructures, Transition Temperature And Solar Transmittance Modulation Of Thermochromic W/Zr Co-Doped Vo2 Thin Films, Haji F. Haji

Tanzania Journal of Engineering and Technology (TJET)

Thermochromic W/Zr co-doped VO2-based thin films with different concentrations of Zr were successfully deposited on soda lime glass substrates by direct current (DC) magnetron sputtering of V(99)W(01) alloy and Zr targets at a substrate temperature of 425 °C. The films were characterized by x–ray diffraction (XRD), atomic force microscopy (AFM), Rutherford backscattering spectroscopy (RBS), two-point probe and UV/VIS/NIR spectroscopy. The film’s structural properties evolution was significantly influenced by Zr concentration in the films. The transition temperature and hysteresis loop widths of the films were found to decrease with increasing Zr concentration. For the Zr concentrations of 0.21 at.%, 0.23 at.% …

Evaluation Of Cybersecurity In Remote Working Settings For Mobile Network Operators, Victoria Mahabi

Tanzania Journal of Engineering and Technology (TJET)

Cybersecurity has increasingly been a primary concern to people as technology advances and allows them to work remotely. This study thus evaluated the cybersecurity posture for organisations that have opted for remote working culture, whereas emerging cyber threats, practices to combat them, and appropriate guidelines for managing cyber threats were discussed. The study used a descriptive design with a quantitative approach from 118 information technology personnel working for Tanzania's three major mobile network operators (MNOs). SPSS analysed the collected data. The study revealed that predominant cyber-threats affecting MNOs in remote working include human errors, phishing attacks, malicious domains, denial of …

Examining Mechanical Property Differences In Concrete With Natural And Synthetic Fiber Additives, Walid Fouad Edris, Sammy Elbialy, Ayman El-Zohairy, Ashraf Mohamed Soliman

Faculty Publications

The rapid growth of Natural Fiber Laminate (NFL) innovation is a direct response to environmental challenges, positioning these materials as superior alternatives to synthetic fiber composites. This paper delved into the outcomes of an extensive experimental study investigating the influence of sisal fiber (SLF), banana fiber (BF), and glass fiber (GF) on the mechanical and microstructural characteristics of concrete. The water absorption curves were established for sisal fiber concrete (SLFC), banana fiber concrete (BFC), and glass fiber concrete (GFC). Furthermore, Scanning Electron Microscope (SEM) observations were conducted to perform microanalysis and failure analysis of the tested specimens. The results revealed …

Sol-Gel Synthesis And Microstructure Characterization Of Nio-Tio2 Semiconductor, Godlisten N. Shao

Tanzania Journal of Engineering and Technology (TJET)

NiO-TiO2 is a fascinating p-n semiconducting binary metal oxide with unique electronic and optical properties. The NiO-TiO2 has been synthesized using complicated preparation methods and expensive precursors that hamper their large-scale production. The present study reports the preparation of NiO-TiO2 semiconductor with improved physicochemical properties. NiO-TiO2 samples were prepared through one-pot sol-gel synthesis process followed by sintering of the as-synthesized materials at temperatures ranging from 600 to 1000 °C. The role of thermal treatment and NiO content on the microstructures was exquisitely studied. The microstructure of the NiO-TiO2 samples was examined by Raman spectroscopy, XRD, XRF, SEM-EDAX, high resolution TEM, …

Sediment Characteristics And Hydrocarbon Composition Of Makukwa Seep In Southern Tanzania: Potential Implications For Subterranean Hydrocarbon Accumulation, Makungu M. Madirisha

Tanzania Journal of Engineering and Technology (TJET)

Exploring the interplay between natural seeps and nearby sediment and hydrocarbon properties is key to unlocking subsurface hydrocarbon potential. This study presents findings on the hydrocarbon composition and sediment characteristics of the Makukwa seep in southern Tanzania, providing insight into subterranean hydrocarbon accumulation. Sediment analysis across areas A and B, located approximately 20 m apart, showed a decrease in porosity with depth, indicative of typical sandstone formations. Area A, near the seeps, exhibited porosity ranging from 23% to 36%, whereas Area B, further away, showed porosity ranging from 22% to 38%. This suggests that a lower cretaceous sandstone layer may …

Optimal Load Shedding During Service Restoration In Electrical Secondary Distribution Network Based On Reinforcement Learning, Rukia J. Mwifunyi

Tanzania Journal of Engineering and Technology (TJET)

Increased stress in traditional power systems results in blackouts due to voltage instability attributed to a mismatch between available capacity and load demand, especially in distribution networks. Service restoration schemes are designed to return power supply to the affected parts of the networks. The availability of insufficient supply is a complex problem that requires operational experience or an automatic system. The stochastic nature of load demand significantly impacts service restoration as it results in increased restored demand in case a fault occurs during off-peak hours and helps reduce overload if the fault occurs during peak hours. The study adopts an …

Production Of Biofertilizer From Fruit And Garden Waste, Neema Msuya

Tanzania Journal of Engineering and Technology (TJET)

The project focused on the production of bio-fertilizer from fruit and garden waste, with a specific emphasis on utilizing pineapple tops in the composting process. The objective was to produce and assess the properties of the bio fertilizer obtained from this process and evaluate its potential application in agriculture. In this study, the composting process was done in a 0.7 m long, 0.85 wide and 1.1 m high vessel, and 0.238 m3 pineapple top wastes, resulting in 0.35 m3 of biofertilizer. The bio fertilizer produced exhibited favorable characteristics, including a moisture content of 36%, pH of 7.1, and a total …

Assessment Of Risk Factors Related To Body Pain Complaints In Tanzania Construction Industry, Fatma K. Mohamed

Tanzania Journal of Engineering and Technology (TJET)

The construction industry is associated with risks that can result in musculoskeletal diseases. Although young male workers who are presumed to be healthy dominate the industry in Tanzania, body pain complaints have been widely reported. The aim of this study is to assess the prevalence and causes of body pains in workers. A cross-sectional study involving 396 workers was conducted. A chi square test was used for testing association of independent categorical variables and binary logistic regression analysis was used to determine predictors for body pain complaints. The results show that all study participants complained of at least one form …

Comparison Of Meteorological Drought Indices In Tanzania Using The Meteorological Drought Monitoring Software Package, Paul Ts Limbu

Tanzania Journal of Engineering and Technology (TJET)

Low precipitation, substantial evaporation, and an unequal distribution of precipitation throughout the area are the characteristics of drought, a climatic abnormality. This study used the Meteorological Drought Monitoring (MDM) software and monthly rainfall data from the Tanzania Meteorological Authority (TMA) to examine and compare the Deciles Index (DI), Standardised Precipitation Index (SPI), Percent of Normal Index (PNI), Rainfall Anomaly Index (RAI), Z-Score Index (ZSI), China-Z Index (CZI), and Modified China-Z Index (MCZI) for drought monitoring in Tanzania from 1988 to 2017. It was found that ZSI represented the dry years better than other indices, followed by DI, RAI, PNI, SPI, …

Study Of The Effects Of Thermal Aging Coupled With Shot-Peening Treatment Of Carbonitrided Din 1.6587 Low Alloy Steel On Retained Austenite And Residual Stresses, Richard J. Katemi

Tanzania Journal of Engineering and Technology (TJET)

This work investigated the effects of thermal aging and shot-peening of carbonitrided 1.6587 steel grade on retained austenite and residual stresses. After carbonitriding samples contained maximum of 0.87% carbon, 0.34% nitrogen and 50 mass. -% retained austenite. Thermal aging conditions investigated were -30°C, 90°C and 150°C while the aging period were 14, 96 and 720 hours. After thermal aging, some of the samples were subjected to shot-peening treatment using standard cut wire shots StD – G3 - 0.6 mm VDFI 8001 with intensity in the range of 0.25 to 0.30 mmA and coverage of 1.00 to 1.24 x 98%. It …

Synthesis Of Local Control Systems For Underwater Units Cleaning Bottom Sediments In Reservoirs, Yuriy Gennadiyevich Shipulin, Zebiniso Akmalovna Zayniddinova

Chemical Technology, Control and Management

The article discusses the issues of synthesizing local control systems for underwater units for cleaning bottom sediments in reservoirs. It is shown that the protection and rational use of natural reservoirs and the fight against their premature siltation is becoming an urgent task.

It is proposed to use small-sized underwater units, consisting of information and measuring devices, to carry out search work for cleaning bottom sediments under water; control systems; actuators and means of communication with humans.

It is shown that the task of controlling the loading of an underwater unit (UU) requires maintaining optimal performance while simultaneously taking into …

Modernization Of Water Flow Measurement In Open Irrigation Systems Using The Slope-Area Method, R.M. Aliev, Djalilov Anvar

Chemical Technology, Control and Management

This article describes two methods for determining water flow in open irrigation systems: “speed - area” and “slope - area”. The authors considered the problem of its modernization using the existing method for determining water flow “slope - area” in open irrigation systems. The essence of the issue is the remote transfer of parameters necessary for calculating water flow in open irrigation systems and improving the means of their processing. In scientific studies conducted by the authors, the required hydraulic parameters were studied using the “slope - area” and “speed - area” water flow methods. Based on experimentally obtained data, …