Physics Commons^™

Scaling And Characterization Of Direct Current Glow Discharge Plasma In Atmospheric Air, Abdel-Aleam Hefney Mohamed

Electrical & Computer Engineering Theses & Dissertations

A microhollow cathode discharge was used as a plasma cathode to sustain a stable direct current glow discharge in atmospheric pressure air. The volumetric scale of glow discharge increased from the millimeter to the centimeter range by extending the plasma in lateral and axial directions. In the axial direction, the length of the glow discharge column was varied from 1 mm to 2 cm, with the sustaining voltage increasing linearly with the glow discharge column length. Extension in the lateral direction was obtained by operating discharges in parallel. The glow discharge plasma of the parallel discharge columns was found to …

Microdischarge Arrays, Wenhui Shi

Electrical & Computer Engineering Theses & Dissertations

Microhollow cathode discharges (MHCDs) are DC or pulsed gas discharges between two electrodes, separated by a dielectric, and containing a concentric hole. The diameter of the hole, in this hollow cathode configuration, is in the hundred-micrometer range. MHCDs satisfy the two conditions necessary for an efficient excimer radiation sources: (1) high energy electrons which are required to provide a high concentration of excited or ionized rare gas atoms; (2) high pressure operation which favors excimer formation (a three-body process). Flat panel excimer sources require parallel operation of MHCDs. Based on the current-voltage characteristics of MHCD discharges, which have positive slopes …

Field Emission Based Sensors Using Carbon Nanotubes, Changkun Dong

Physics Theses & Dissertations

A number of sensitive applications would be greatly benefited by the development of better cold cathodes that employ the electron field emission process. Among the many kinds of field emitters that could be tried, carbon nanotubes (CNT) have a number of distinct advantages because of their unique geometrical structure, chemical inertness, mechanical stiffness, and high thermal and electrical conductivities. This dissertation describes research in which CNT cathodes were fabricated and their emission characteristics were measured.

Multi-walled carbon nanotubes (MWNT) were grown by chemical vapor deposition (CVD) on various substrates: Ni and Hastelloy gauze, 304 stainless steel (SS) plates, and Ni-coated …

Development Of An Efficient Ti:Sapphire Laser Transmitter For Atmospheric Ozone Lidar Measurements, Khaled A. Elsayed

Electrical & Computer Engineering Theses & Dissertations

The impetus of this work was to develop an all solid-state Ti:sapphire laser transmitter to replace the current dye lasers that could provide a potentially compact, robust, and highly reliable laser transmitter for differential absorption lidar measurements of atmospheric ozone. Two compact, high-energy pulsed, and injection-seeded Ti:sapphire lasers operating at a pulse repetition frequency of 30 Hz and wavelengths of 867 nm and 900 nm, with M² of 1.3, have been experimentally demonstrated and compared to model results. The Ti:sapphire lasers have shown the required output beam quality at maximum output pulse energy, 115 mJ at 867 nm and …

Coherent Differential Absorption Lidar For Combined Measurement Of Wind And Trace Atmospheric Gases, Grady James Koch

Electrical & Computer Engineering Theses & Dissertations

A lidar system was developed for making combined range-resolved measurements of wind speed and direction, water vapor concentration, and carbon dioxide concentration in the atmosphere. This lidar combines the coherent Doppler technique for wind detection and the differential absorption lidar (DIAL) technique to provide a multifunctional capability. DIAL and coherent lidars have traditionally been thought of and implemented as separate instruments, but the research reported here has shown a demonstration of combining the coherent and DIAL techniques into a single instrument using solid-state lasers. The lasers used are of Ho:Tm:YLF, which operates at a wavelength of 2 μm. This wavelength …

Resolution Of Overlapping Spectra By Wavelength Modulation Spectroscopy, Audra Michiele Bullock

Electrical & Computer Engineering Theses & Dissertations

Wavelength modulation absorption spectroscopy is a highly sensitive, non-intrusive technique for probing gaseous species, which employs the well-known principles of modulation spectroscopy in a novel way. With this technique, parameters such as velocity, density, and temperature can be measured with a high degree of precision. The research presented here shows that wavelength modulation is a convenient means of increasing the sensitivity of an absorption spectroscopy measurement because it allows for harmonic detection. The focus of the dissertation is resolution of overlapping spectra by harmonic detection and the advantages gained by performing detection at the higher harmonics, e.g., sixth and eighth. …

Surface Resistance Measurements Of Superconducting Niobium Samples With A Triaxial Cavity, Paul Martin Boccard

Physics Theses & Dissertations

This experimental study has revealed and investigated many of the physical issues that affect accurate measurement of the surface resistance for small samples consisting of superconducting niobium films on copper substrates. It is believed that this work provides the groundwork for future research directed towards solving this important problem. Accurate measurement of surface resistance for such samples is needed to allow the rapid evaluation and optimization of the deposition parameters necessary for manufacturing low-loss superconducting niobium films.

A superconducting niobium triaxial cavity was investigated to determine its suitability for measuring the residual surface resistance of copper samples that were sputter-coated …

Gamma-Ray Optical Studies Of ⁷³Ge And ⁵⁷Fe, Walter Carlton Mcdermott Iii

Physics Theses & Dissertations

The research described herein is among the first attempts to test one of the more popular theories for development of a gamma-ray laser. This work is a "marriage" between the Borrmann effect, which is a consequence of the dynamical theory of x-ray diffraction, and time-filtering which comes from time-domain Mossbauer spectroscopy.

Our experiments involved the search for a nuclear Borrmann effect and the subsequent time-filtering effect using ⁵⁷Fe and ⁷³Ge. In both cases, no nuclear Borrmann effect was observed; however, the methodology and criteria necessary for such an observation with any isotope were documented. The procedures necessary for …

Modelling An Optical Fiber Bragg Grating, Claudio Oliveira Egalon

Electrical & Computer Engineering Theses & Dissertations

A theoretical investigation of a single mode optical fiber with one and two superimposed Bragg grating is presented. The formulation relies in the determination of an approximate solution in the asymptotic region of one of the fiber parameters. A correction is then applied to the asymptotic solution using the Method of the Successive Approximations also known as the Piccard Method. The approximation was then compared to the numerical solution using the Runge-Kutta method. Assuming that each Bragg grating has modulation frequencies given by Ω₁ and Ω₂, it has been found that the second Bragg grating shifts the …

Compensation And Characterization Of Gallium Arsenide, Randy A. Roush

Electrical & Computer Engineering Theses & Dissertations

The properties of transition metals in gallium arsenide have been previously investigated extensively with respect to activation energies, but little effort has been made to correlate processing parameters with electronic characteristics. Diffusion of copper in gallium arsenide is of technological importance due to the development of GaAs:Cu bistable photoconductive devices. Several techniques are demonstrated in this work to develop and characterize compensated gallium arsenide wafers. The material is created by the thermal diffusion of copper into silicon-doped GaAs. Transition metals generally form deep and shallow acceptors in GaAs, and therefore compensation is possible by material processing such that the shallow …

High Resolution Laser Absorption Spectroscopy Of Ozone Near 1129.4 Cm-1, Lawrence N. Majorana

Physics Theses & Dissertations

A Beer's Law experiment was performed with a tunable laser to determine self broadened line shape parameters of one infrared absorption ozone line in the v1 band for ten pressures from 0.26 to 6.29 Torr at 285K. SO₂ line positions were used for wavelength calibration. Line shapes were iteratively fitted to the Voigt function at a Doppler width of 29.54 MHz (HWHM) resulting in values for the integrated line• strength, ( S), of (0.144 +/- 0.007 ) x ·10^-20 cm-1/molecule cm-2, line center frequency, (υ_ο) of 1129.426 cm-1 and the Lorentzian contributions to half width, (α …