Open Access. Powered by Scholars. Published by Universities.®

Radiology Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 9 of 9

Full-Text Articles in Radiology

Lead X-Ray Vests: Pros And Cons In Dental Radiography And Patient Education On Radiographic Technology, Kayla D. Oakley, Emily Deker Jan 2020

Lead X-Ray Vests: Pros And Cons In Dental Radiography And Patient Education On Radiographic Technology, Kayla D. Oakley, Emily Deker

Dental Hygiene Student Scholarship

Problem: There is a greater need to emphasize and educate patients and providers about radiologic advancements and patient exposure. The tradition of placing lead x-ray vests on patients for all radiographs is no longer a necessity. Without the explanation of why lead aprons are no longer needed, unnecessary steps for the provider and potential harm to the patient could be caused.

Methods: This review of literature was assembled by analyzing data from primary and secondary sources through online databases. The most recent research on the risks and benefits of the use of lead x-ray vests towards patients in …


Using Cone Beam Computed Tomography To Identify A Prediction Model For Obstructive Sleep Apnea, Jodi Parker Sep 2009

Using Cone Beam Computed Tomography To Identify A Prediction Model For Obstructive Sleep Apnea, Jodi Parker

Loma Linda University Electronic Theses, Dissertations & Projects

Introduction: Obstructive Sleep Apnea (OSA) patients have increased risk of morbidity and mortality. Early diagnosis may reduce morbidity and mortality. Prediction of OSA from imaging may help to identify OSA patients earlier in life. CBCT can be used for OSA diagnostic imaging due to its three-dimensional (3D) visualization of the upper airway and craniofacial complex. Magnification associated with conventional 2D radiography is eliminated with CBCT, and radiation to the patient is significantly less than previous modalities used to measure craniofacial & airway measurements associated with OSA. During a CBCT scan, the patient's image is taken supine, rather than the upright …


Cephalometric Analysis Using Magnetic Resonance Imaging, Wade A. Williams Sep 2008

Cephalometric Analysis Using Magnetic Resonance Imaging, Wade A. Williams

Loma Linda University Electronic Theses, Dissertations & Projects

Purpose: The purpose of this study was to determine if T1-weighted 3D magnetic resonance images performed at 3.0 Tesla could be used to conduct routine orthodontic cephalometric analysis.

Methods: Three cranial imaging methods were compared using sixteen non-growing subjects (10 male and 6 female) who were not claustrophobic, did not have any metallic restorations on the distal of first molars, had no medical implants and the female subjects were not pregnant. Sagittal cranial images were produced by three methods: (1) a digital lateral cephalometric (LC) radiograph (Orthophos XG Plus, SironaTM, Bensheim, Germany), (2) a 12-inch FOV cone beam …


Variability In Selecting Lateral Cephalometric Landmarks In Two Cbct Image Modes, Dana Nguyen Dec 2006

Variability In Selecting Lateral Cephalometric Landmarks In Two Cbct Image Modes, Dana Nguyen

Loma Linda University Electronic Theses, Dissertations & Projects

Purpose: The purpose of this study was to determine the variability of lateral cephalometric landmark selection in two cone beam computed tomography (CBCT) lateral cephalometric simulations: 1) a mean projection image (MPI) and 2) a serial sagittal slice image (SSSI).

Methods: A MPI is a two-dimensional (2D) image obtained from the NewTom 3GTM CBCT that resembles the conventional lateral cephalogram. A SSSI is a 2D image also obtained from CBCT data, but is created by superimposing a series of selected thin sagittal slices containing the required cephalometric landmarks. This study compared the Ricketts and Steiner analysis of the MPI …


Comparison Of Different Methods Of Assessing Ridge Width Prior To Implant Placement, Lung-Cheng Chen Jun 2005

Comparison Of Different Methods Of Assessing Ridge Width Prior To Implant Placement, Lung-Cheng Chen

Loma Linda University Electronic Theses, Dissertations & Projects

The aim of this study was to compare the following 3 methods of assessing alveolar ridge dimensions prior to placement of dental implants: 1) ridge mapping measurement before surgical flap reflection using a caliper; 2) direct caliper measurement following surgical exposure of the bone, and 3) measurement using images from cone beam computerized tomography.

Sixteen subjects having 25 sites for planned implant placement or ridge augmentation were recruited. An acrylic stent was fabricated for each patient. The stent provided 3 buccal/lingual pairs of consistent measurement points for each implant site, located 4, 7 and 10 mm from the summit of …


Prevalence Of Degenerative Joint Disease In A Pre-Orthodontic Adolescent Sample, Marie Mansour Sep 2004

Prevalence Of Degenerative Joint Disease In A Pre-Orthodontic Adolescent Sample, Marie Mansour

Loma Linda University Electronic Theses, Dissertations & Projects

The purpose of this research was to determine a prevalence of degenerative joint disease in our pre-orthodontic adolescent patients age ten through seventeen. The prevalence was assessed according to gender. Severity of DJD was established for each patient and a "red flag" for diagnosis was identified. The purpose was also to establish norms for joint space for patients with and without degenerative joint disease. Correlations to distal condyle position and angle classification were described. 123 consecutive patients, 77 female and 46 male T1 NewTom records were reviewed. Severity of DJD was classified according to none, mild, moderate, and severe. Sagittal …


Measured Effects Of Rapid Palatal Expansion On Nasal Cavity Volume Utilizing Cbct, Jon Neal Robinson Dec 2003

Measured Effects Of Rapid Palatal Expansion On Nasal Cavity Volume Utilizing Cbct, Jon Neal Robinson

Loma Linda University Electronic Theses, Dissertations & Projects

The purpose of this study was to evaluate and predict the expected changes that occur in the nasal cavity volume following rapid palatal expansion. Eighteen subjects (11 female, 7 male), ages 9 to 18, requiring rapid palatal expansion in conjunction with comprehensive orthodontic treatment, were selected for the study. Rapid palatal expansion was accomplished using the standard, banded hyrax appliance. Three-dimensional cone beam computed tomograms using the NewTom 9000™ were acquired before and after expansion. Serial coronal slices of the nasal cavity were made using the QV9000™ software program. The resultant serial images were imported into 3-D Doctor™ for analysis …


Linder-Aronson S Analysis Using Rhinomanometry And Newtom, Noel Moser Aug 2002

Linder-Aronson S Analysis Using Rhinomanometry And Newtom, Noel Moser

Loma Linda University Electronic Theses, Dissertations & Projects

Investigations into the effects of airway patency on craniofacial development are essential to ensure that interceptive orthodontic treatment provides the maximum benefit to the patient. The aims of this study were to (1) compare the size of the nasopharyngeal airway space on lateral cephalometric and 3D volumetric radiographs to determine if volumetric scans can be of greater diagnostic value than a lateral cephalometric film in determining the degree of airway blockage or patency and (2) to examine the correlation between functional airway resistance, as evaluated by rhinomanometry, and radiographic constriction due to nasal turbinate and adenoid size.

Twenty-eight subjects from …


A Method Of Analyzing Mandibular Movement, Richard B. Mccoy Jun 1973

A Method Of Analyzing Mandibular Movement, Richard B. Mccoy

Loma Linda University Electronic Theses, Dissertations & Projects

Mandibular movement is considered to be a fundamental factor in the study, analysis, and treatment of occlusion. For many years, dentists have realized that dental health depends upon the compatibility of mandibular movements and occlusion. This realization has led to the development of new methods and techniques for recording accurately and scientifically the movements of the mandible. In order for this data to be of scientific value, it must be stored in a usable form which is easily available for analysis.

The purpose of this research project was to develop a procedure for storing and recalling mandibular-movement information. Before such …