Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Institution
- Keyword
- Publication
- Publication Type
Articles 1 - 3 of 3
Full-Text Articles in Industrial Technology
The Determination Of Failure Occurring In The Stator Coil Winding Due To The Over-Voltage Using Matlab Software, Ali Reza Alavizadeh
The Determination Of Failure Occurring In The Stator Coil Winding Due To The Over-Voltage Using Matlab Software, Ali Reza Alavizadeh
Morehead State Theses and Dissertations
A thesis presented to the faculty of the College of Science & Technology at Morehead State University in partial fulfillment of the requirements for the degree of Master of Science in Vocational Education & Technology by Ali Reza Alavizadeh on December 1, 2000.
An Efficient Cnc Programming Approach Based On Group Technology, Manocher Djassemi
An Efficient Cnc Programming Approach Based On Group Technology, Manocher Djassemi
Industrial Technology and Packaging
Many studies and reports support the significant impact of the application of group technology on various aspects of product design and manufacturing. The fact that group technology is the common solution to similar problems is the main source of such impact. In this paper, one of the less frequently utilized features of CNC technology known as parametric part programming is used to implement the common solution feature of group technology in processing a set of similar parts. Using three part families, the advantages of blending the concept of group technology and parametric programming for CNC machining operations are illustrated. The …
Pre-Inoculation Effect Of Sic In Production Of Thin Wall Ductile Iron Castings, Nikolay Y. Laukhin
Pre-Inoculation Effect Of Sic In Production Of Thin Wall Ductile Iron Castings, Nikolay Y. Laukhin
Dissertations and Theses @ UNI
Pre-inoculation effect of SiC additions and its effect on castability, microstructure, and magnesium recovery in thin wall ductile iron plates have been studied. Experimental results were compared with alternative FeSi75 furnace pre-inoculation additions.
The first series of experiments aimed to set the baseline of iron quality, when using FeSi75 pre-inoculant
In the second series of experiment, different methods of introduction of Sic into liquid iron were studied. It was established that Sic added into the stream during the tapping into the flow-through chamber or added directly into the flow-through chamber produced lower Si recovery. The most effective method of introduction …