Open Access. Powered by Scholars. Published by Universities.®
Other Materials Science and Engineering Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Other Materials Science and Engineering
Characterization Of Slm Printed 316l Stainless Steel And Investigation Of Microlattice Geometry, Finley H. Marbury
Characterization Of Slm Printed 316l Stainless Steel And Investigation Of Microlattice Geometry, Finley H. Marbury
Materials Engineering
The goal of this project was firstly to characterize Cal Poly’s SLM printed 316L stainless steel. SEM analysis showed Cal Poly’s as-printed 316L material to have a cellular dendritic microstructure containing mostly austenite and a small amount of δ-ferrite. After being heat treated to eliminate warp, its yeild and ultimate tensile strength were on par with the literature, however higher modulus and lower elongation were observed. XRD analysis confirmed residual stresses in the material, and that grains are preferentially oriented in both heat treated and non heat treated samples. The amount of porosity in the material was found to be …
Invariant-Based Method For Improving Efficiency Of Mechanical Testing In Aerospace Certification Of Carbon Fiber-Epoxy Composites, Alyssa Rina Gruezo, Erika Gabrielle Hansen
Invariant-Based Method For Improving Efficiency Of Mechanical Testing In Aerospace Certification Of Carbon Fiber-Epoxy Composites, Alyssa Rina Gruezo, Erika Gabrielle Hansen
Materials Engineering
The current challenge with qualification of carbon fiber composites in the aerospace industry would be the low efficiency of testing hundreds of samples. The Trace Theory strives to streamline the qualification process by utilizing a material’s Trace to predict properties of composites using Excel programs and basis data. To test this theory, predicted properties from the program, QuickLam, were compared to experimental data. Unidirectional 0° (T1), unidirectional 90° (T2), quasi-isotropic (T3), and hard quasi-isotropic (T4) laminates were made using HexTowR carbon fiber and TC250 resin provided by TenCate Advanced Composites. Tensile and compression tests were done according to ASTM D3039 …