VLSI and Circuits, Embedded and Hardware Systems Commons^™

Sun-Tracking Solar-Powered Led Street Light, Wesley Ballar, Harrison Wong

Electrical Engineering

Street lighting is an essential utility especially in urban and industrialized areas because it provides illumination and safety for vehicles and pedestrians throughout the night. However, street lights are relatively inefficient; they consume large amounts of power from electrical grids and have predetermined operation times that are often non-optimal for the surrounding environment. The Sun-Tracking Solar-Powered LED Street Lamp is a self-sustaining device, built to replace the current lighting sources. The device features sun-tracking capabilities for maximum energy gathering and darkness recognition to establish optimal operation times. The project provides a reliable and enhanced alternative to current street lighting systems.

Phase Locked Loop Integrated Circuit, Scott Buchanan, Jonathan Bonello

Electrical Engineering

No abstract provided.

Current Protection For The Energy Harvesting From Exercise Machines (Ehfem) Project, Colton Crivelli

Electrical Engineering

The Energy Harvesting from Exercise Machines (EHFEM) project intends to create an exercise machine that recycles the energy expended by an athlete operating the machine by sending it to the electric grid. The work done by the user goes through a DC-DC converter and an inverter in order to prepare it for delivery to the grid. A protection circuit ensures that the inverter does not try to pull too much current from the DC-DC converter. The project implements a current protection system that ensures the system doesn’t experience an overcurrent condition.

Chipper: Capacitive Bed Occupancy Sensing For An Intelligent Alarm Clock, David Levi

Electrical Engineering

What if your alarm clock knew when you got out—and stayed out—of bed? Current alarm clocks happily let you go back to bed after turning them off. In this project, I build an alarm which only stops ringing when you get out bed, and starts ringing again if you lie back in bed.

This project uses capacitance to detect bed occupancy. A person on or near the bed creates a tiny, picofarads level increase in capacitance, as seen by a sensor placed under the mattress. A microprocessor interprets this signal, and also drives an audio alarm. Shielding of the sensor …

Dual Channel Matrix Switch Audio Receiver, Austin Fox

Electrical Engineering

The Dual Channel Matrix Switch Audio Receiver controls 2 separate audio output channels. Each channel plays any of the system's 3 inputs. This controller enables a user to play two separate audio signals through two separate speaker channels. The system design allows audio input from 2 RCA sources or 1 RCA source and a phono source. The system outputs an audio signal for each output simultaneously at up to 36W on each channel for an 8Ω load. The device allows a user to control the audio input and the volume of each output channel. An Arduino Uno R3 microcontroller interfaced …

Wd Data Aquisition Board, Charmaine Guintu

Electrical Engineering

The Data Acquisition (DAQ) Board project is a continuation of a project that started last year. It is a project in collaboration with Western Digital. Western Digital (WD) Power LSI Systems Validation group has stress testing equipment called the Torture Stand. Inside the Torture Stand hard drives are compacted and tested until failure. However, the transient responses of voltage and current signals from the hard drives are currently obtained from oscilloscopes. The oscilloscopes are bulky and expensive, so to replace the oscilloscopes the DAQ was created. The small size and much cheaper cost of the DAQ allows Western Digital to …