Signal Processing Commons^™

Indoor Positioning Using Synchronized Ultrasonic Ofdma Signals, Julian Bartolone

Master's Theses

This paper proposes a method of short-range indoor localization using differential phase measurements of synchronized two-tone ultrasonic signals in an Orthogonal Frequency Multiple Access (OFDMA) scheme. This indoor positioning system (IPS) operates at an ultrasonic frequency of approximately 40kHz and synchronizes using an infrared signal. The OFDMA scheme allows for a receiver to process the signals from multiple transmitters continuously without the signals interfering with each other. The phases of the signals are measured using Goertzel Filters, allowing for low-complexity frequency content analysis. A MATLAB simulation using the proposed localization method is performed using four transmitter nodes in the corners …

Reference Design Of An Online Emulation And Hot-Patching Approach For Power Electronic Controller Validation, Estefano Soria Pearson

Graduate Theses and Dissertations

This thesis aims to develop a reference design of an online security system approach embedded in a power electronic controller for cybersecurity purposes. Cybersecurity in power electronics focuses on reducing vulnerabilities in the system, where most reside in the communication with the hardware devices. Although methods to secure communications lessen the probability and effects of cyber-attacks, discovering vulnerabilities is inevitable. This thesis attempts to provide a fail-safe approach to securing the system by targeting the safety of the power-electronic controller. This approach applies an additional security layer in case of a malicious or accidental controller firmware malfunction.

The online security …

Bibliometric Review Of Predictive Maintenance Using Vibration Analysis, Aashna Midha Ms., Ishita Maheshwari Ms., Kaushik Ojha Mr., Kritika Gupta Ms., Shripad V. Deshpande Mr.

Library Philosophy and Practice (e-journal)

Every day the world is depending more and more on machines in almost every aspect of life. With the increasing use of machines, there also needs to be an evolution in the maintenance of these machines. Predictive maintenance is a process used to monitor the equipment and machinery during its operation to detect any damages and/or deteriorations and enable the required maintenance plan in advance, resulting in reduced operational costs and full utilization of tools and parts. The fundamental goal of this bibliometric review paper is a comprehension of the extent and sources of the literature available for predictive maintenance …

Diseño E Implementación De Un Sensor De Impedancia Para La Medición De La Fracción Volumétrica En Un Tubo, Jhon William Fagua Arias, Oscar Arley Moreno Bejarano

Ingeniería Eléctrica

Este documento presenta una propuesta para comparar dos métodos, que permiten tener la medida de las fracciones volumétricas de una mezcla de fluidos bifásica, por medio de la respuesta al cambio de la capacitancia entre dos electrodos. A través de un dispositivo electrónico, llamado puente autobalanceado, se tomó el registro de una sección volumétrica y se comparó entre dos métodos de medición, con esto se obtuvo la permitividad o capacitancia del fluido, y se consiguió el volumen de forma eléctrica, el cual se contrastó con la magnitud eléctrica medida entre una lectura patrón y la obtenida en el circuito contenido …

Hard Hat Ambient Liability Observer (Halo), Hunter Hykes, Nathan Kish, Brian Thomson

Williams Honors College, Honors Research Projects

Capturing workplace incident information is a growing area of concern for most companies. To assist with this, the design team proposed the H.A.L.O. This design uses time-of-flight sensors connected to LEDs to create a proximity-based hazard warning system. It also records incident data using an accelerometer and micro-SD card. This helps workers avoid some of the most common workplace injuries, slips, trips, and falls and accidental collisions.

Students have created a design with engineering, and marketing requirements that accomplish this task. The proposed design allows for this monitoring and mitigation systems to be attached to hard hats. Team members developed …