Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Keyword
-
- Additive manufacturing (1)
- Atrial fibrillation (1)
- Composite material (1)
- Control (1)
- Control system (1)
-
- DTC (1)
- Mechatronics (1)
- Modal analysis (1)
- Motion magnification (1)
- Motor Drive (1)
- Optofluidics (1)
- PID control (1)
- Peristaltic pump (1)
- Repetitive control (1)
- Service learning (1)
- SiC (1)
- Structural health monitoring (1)
- Three-level Inverter (1)
- Virtual Space Vector (VSV) (1)
- Virtual Voltage Vector (1)
- Zinc oxide (ZnO) (1)
Articles 1 - 4 of 4
Full-Text Articles in Signal Processing
Direct Torque Control For Silicon Carbide Motor Drives, Mohammad Hazzaz Mahmud
Direct Torque Control For Silicon Carbide Motor Drives, Mohammad Hazzaz Mahmud
Graduate Theses and Dissertations
Direct torque control (DTC) is an extensively used control method for motor drives due to its unique advantages, e.g., the fast dynamic response and the robustness against motor parameters variations, uncertainties, and external disturbances. Using higher switching frequency is generally required by DTC to reduce the torque ripples and decrease stator current total harmonic distortion (THD), which however can lower the drive efficiency. Through the use of the emerging silicon carbide (SiC) devices, which have lower switching losses compared to their silicon counterparts, it is feasible to achieve high efficiency and low torque ripple simultaneously for DTC drives.
To overcome …
Design And Fabrication Of Zinc Oxide Optofluidic Laser Elements, Kyle T. Bodily
Design And Fabrication Of Zinc Oxide Optofluidic Laser Elements, Kyle T. Bodily
Theses and Dissertations
This thesis systematically goes through the derivation, simulation, and experimentation of Zinc Oxide optofluidic micro laser elements. Single and coupled ring resonators were simulated to show single mode transmission as well as enhanced coupling capabilities when surrounded by high refractive index liquid. Devices with diameters ranging from 100-500 µm were successfully fabricated inexpensively through standard cleanroom procedures. The devices were tested using two different pump laser systems. Testing included such factors as high pump intensity, various angles of excitation, and low temperature. In all cases PL emission was observed and recorded.
Design And Control Of A Peristaltic Pump To Simulate Left Atrial Pressure In A Conductive Silicone Model, Jeremy Collins
Design And Control Of A Peristaltic Pump To Simulate Left Atrial Pressure In A Conductive Silicone Model, Jeremy Collins
Mechanical Engineering Undergraduate Honors Theses
According to the CDC, atrial fibrillation is responsible for more than 454,000 hospitalizations and approximately 158,000 deaths per year. A common treatment for atrial fibrillation is catheter ablation, a process in which a long flexible tube is guided through the femoral artery and to the source of arrhythmia in the heart, where it measures the electrical potential at various locations and converts problematic heart tissue to scar tissue via ablation. This paper details the design and control of a low-cost ($400) peristaltic pump system using repetitive control to replicate blood pressure in the left atrium in a conductive silicone model …
Quality Assurance Of Lightweight Structures Via Phase-Based Motion Estimation, Ikenna E. Ifekaonwu
Quality Assurance Of Lightweight Structures Via Phase-Based Motion Estimation, Ikenna E. Ifekaonwu
Electronic Theses and Dissertations
In recent years, lightweight structures have become mature and adopted in various applications. The importance of quality assurance cannot be overemphasized hence extensive research has been conducted to assess the quality of lightweight structures. This study investigates a novel process that exploits motion magnification to investigate the damage characteristics of lightweight mission-critical parts. The goal is to assure the structural integrity of 3D printed structures and composite structures by determining the inherent defects present in the part by exploiting their vibration characteristics. The minuscule vibration of the structure was recorded with the aid of a high-speed digital camera, and the …