Open Access. Powered by Scholars. Published by Universities.®

Controls and Control Theory Commons

Open Access. Powered by Scholars. Published by Universities.®

Theses and Dissertations

Discipline
Institution
Keyword
Publication Year

Articles 61 - 79 of 79

Full-Text Articles in Controls and Control Theory

Improved Numerical Solution Of Mixed H2/H Optimization With Applications, Linda D. Smith Dec 1994

Improved Numerical Solution Of Mixed H2/H∞ Optimization With Applications, Linda D. Smith

Theses and Dissertations

This study improved the numerical optimization technique used to compute mixed H2/H controllers. The run time to generate the full curve of an H2/H design was reduced by a factor of almost 200 for a specific example. This was accomplished by improving gradient calculations, upgrading the H norm calculation to capture multiple peaks in the singular value plot and using routines that minimized processing time. The optimization routine used was the MATLAB CONSTR' Sequential Quadratic Programming (SQP) routine. This SQP routine was compared to a FORTRAN SQP numerical optimizer, IMSL-DNCONG. The method was …


Control Of A Large Space Structure Using Multiple Model Adaptive Estimation And Control Techniques, Gordon C. Griffin Jr. Dec 1994

Control Of A Large Space Structure Using Multiple Model Adaptive Estimation And Control Techniques, Gordon C. Griffin Jr.

Theses and Dissertations

A moving bank multiple model adaptive estimator-controller (MMAE-MMAC), based on linear system, quadratic cost, and Gaussian noise (LQG) assumptions, is used to quell unwanted vibrations in a large flexible space structure. The structure, known as the SPace Integrated Controls Experiment, or SPICE, exists at Phillips Laboratory, Kirtland AFB, NM. The structure consists of a large platform and a smaller platform connected by a tripod of flexible legs. The purpose of the control system is to maintain a very precise line-of- sight vector through the center of the spacecraft. Kalman filtering, used to estimate the position and velocity of the bending …


Flight Control Design Using Mixed H2/Μ Optimization, Douglas D. Decker Dec 1994

Flight Control Design Using Mixed H2/Μ Optimization, Douglas D. Decker

Theses and Dissertations

This thesis examines the use of the mixed H2-Microns optimal control synthesis method in the design of a flight control system for the lateral-directional axes of the F-16 Variable Stability In-Flight Simulator Test Aircraft (VISTA). The method is designed to minimize the H2 norm (two-norm) for a given value of microns. This should provide adequate noise and disturbance rejection while maintaining robustness against several types of uncertainties in the system. This thesis finds that, for this problem, the two-norm is not an accurate representation of the outputs of interest. When the two-norm is broken up into its constituent parts an …


A Comparison Of The Neal-Smith And ΩSpΤΘ2, ΣSp, ΤΘ Flying Qualities Criteria, Brian A. Kish Dec 1994

A Comparison Of The Neal-Smith And ΩSpΤΘ2, ΣSp, ΤΘ Flying Qualities Criteria, Brian A. Kish

Theses and Dissertations

Aircraft pitch response is a vital element of piloted vehicle flying qualities. There has been controversy over both the form and the substance of the requirements for short-term pitch response. Currently, MIL-STD- 1797A offers six different methods for evaluating short-term pitch response. These six methods often give conflicting results. Two methods are analyzed in this thesis - the Neal-Smith criteria and the ωspΤθ2, ςsp, τθ criteria. Domains from both criteria are mapped into each other identifying regions of conflict and regions of agreement. Parametric studies are performed and evaluated for trends. Further, a …


H2 Optimal Control With H, Μ, And L1 Constraints, David E. Walker Jun 1994

H2 Optimal Control With H∞, Μ, And L1 Constraints, David E. Walker

Theses and Dissertations

H2 optimization with convex constraints is considered. The optimal order-free solution is shown to be unique through convex analysis. H constraints with feedforward terms and singular constraints are also allowed. The optimal fixed-order solution is shown to have the same characteristics as a mixed problem with regular H constraints. Furthermore, these results are shown to hold for controller orders as low as the optimal H2 order. A numerical method is developed based on analytical gradients which results in sub- and super-optimal fixed-order controllers. The problem is extended to include an upper bound on a mu constraint …


Mixed H2-H Optimization With Multiple H Infinity Constraints, Julio C. Ullauri Jun 1994

Mixed H2-H∞ Optimization With Multiple H Infinity Constraints, Julio C. Ullauri

Theses and Dissertations

A general mixed H2/H optimal control design with multiple H constraints is developed and applied to two systems, one SISO and the other MIMO. The SISO design model is normal acceleration command following for the F- 16. This design constitutes the validation for the numerical method, for which boundaries between the H2 design and the H constraints arc shown. The MIMO design consists of a longitudinal aircraft plant (short period and phugoid modes) with stable weights on the H2 and H transfer functions, and is linear- time-invariant. The controller order is reduced …


Direct Reduced Order Mixed H2/H Control For The Short Take-Off And Landing-Maneuver Technology Demonstrator (Stol-Mtd), William C. Reigelsperger Jr. Mar 1994

Direct Reduced Order Mixed H2/H∞ Control For The Short Take-Off And Landing-Maneuver Technology Demonstrator (Stol-Mtd), William C. Reigelsperger Jr.

Theses and Dissertations

One of the conclusions from the STOL/MTD program was the need for a multivariable method of designing controllers of low order. This research investigated that problem by studying reduced order mixed H2/H control theory applied to the STOL Landing configuration which employs both thrust vectoring and the use of a canard. Model matching techniques were used to obtain responses that met handling qualities criteria and reduced pilot workload by decoupling pitch rate and velocity commands. The time responses were found through nonlinear simulation and showed that the full order designs did match the ideal models very well …


A Handling Qualities Investigation Of Conventional, Rate Command- Attitude Hold, And Attitude Command-Attitude Hold Response-Types In The Probe And Drogue Air Refueling Task, Michael J. Taschner Mar 1994

A Handling Qualities Investigation Of Conventional, Rate Command- Attitude Hold, And Attitude Command-Attitude Hold Response-Types In The Probe And Drogue Air Refueling Task, Michael J. Taschner

Theses and Dissertations

This investigation examines the suitability of conventional, rate command/attitude hold (RCAH), and attitude command attitude hold (ACAH) response-types for the probe and drogue air refueling task. Data from a 1974 Calspan handling qualities investigation involving conventional response-types in the probe and drogue air refueling task were analyzed using the Bandwidth and STI Dropback criterions. Flight control laws were developed to achieve twelve superaugmented and two conventional configurations. The NT-33A analog variable stability system was used to simulate a relaxed static stability fighter and the NT-33A programmable digital flight control computer simulated the desired response-types. The handling qualities of the fourteen …


Automation Of Formation Flight Control, Vincent P. Reyna Jan 1994

Automation Of Formation Flight Control, Vincent P. Reyna

Theses and Dissertations

The research contained in this thesis explores the concepts of Automated Formation Flight Control documented in three previous AFIT theses. The generic formation analyzed consists of a Leader and Wingman, with the Wingman referencing its maneuvers off of Leader maneuvers. Specifically, planar formation flight control concerning only heading and velocity changes is considered. Next, the vertical separation constraint is relaxed to allow wing maneuvers outside of the flight plane of the lead in order to minimize the energy expended by the wing in a maneuver. Analysis of the two forms of formation flight control investigated in this thesis reveals the …


Evaluation Of Moderate Angle Of Attack Roll Of A Dual Engine, Thrust Vectoring Aircraft Using Quantitative Feedback Theory, Kevin E. Boyum Dec 1993

Evaluation Of Moderate Angle Of Attack Roll Of A Dual Engine, Thrust Vectoring Aircraft Using Quantitative Feedback Theory, Kevin E. Boyum

Theses and Dissertations

This thesis develops an innovative approach to the design of a flight control system for performing the large-amplitude velocity vector roll maneuver at high angles of attack AOAs. A six degree of freedom aircraft model is developed from the fundamental nine-state equations of motion using a modified linearization technique. The MIMO multiple-input multiple-output Quantitative Feedback Theory QFT robust control design technique is then used to jointly address the system nonlinearities present in this maneuver and the changes in the system parameters due to changes in flight condition, treating them as structured uncertainty in the design of a three-axis rate-commanded control …


Design Of A Flight Controller For An Unmanned Research Vehicle With Control Surface Failures Using Quantitative Feedback Theory, Mark S. Keating Dec 1993

Design Of A Flight Controller For An Unmanned Research Vehicle With Control Surface Failures Using Quantitative Feedback Theory, Mark S. Keating

Theses and Dissertations

This thesis describes the application of the multiple-input multiple- output (MIMO) Quantitative Feedback Theory (QFT) design technique to the design of a digital flight control system for the Lambda Unmanned Research Vehicle (URV). The QFT technique allows the synthesis of a control system which is robust in the presence of structured plant uncertainties. Uncertainties considered in this design are the aircraft's plant variation within the flight envelope and the effects of damage to aircraft control surfaces. Mathematical models of control surface failure effects on aircraft dynamics are derived and used to modify an existing small perturbation model of the Lambda. …


Optimal Control Design Advantages Utilizing Two-Degree-Of-Freedom Controllers, Michael J. Stephens Dec 1993

Optimal Control Design Advantages Utilizing Two-Degree-Of-Freedom Controllers, Michael J. Stephens

Theses and Dissertations

The purpose of this study was to investigate and describe the differences between a one-degree-of-freedom (1-DOF) controller, in which a controller is placed in a single location in the control loop, and a two-degree- of-freedom (2-DOF) controller, in which two separate controllers are designed -- one in the feedback loop and the other as a prefilter in the forward loop. The approach involved summarizing the major rules governing loop shaping for performance and robustness in the 1-DOF case and then extending the concepts to the 2-DOF case. H2 optimization was utilized to perform several types of SISO examples and …


Simultaneous Design Of Active Vibration Control And Passive Damping, Michele Lynn Devereaux Gaudreault Dec 1993

Simultaneous Design Of Active Vibration Control And Passive Damping, Michele Lynn Devereaux Gaudreault

Theses and Dissertations

A modified form of the standard linear quadratic regulator LQR cost functional is used to optimally blend active vibration control and passive structural damping, whether viscous or viscoelastic. Viscoelastic damping is first modelled by a standard linear model, and then by a fractional derivative model. For the viscous damping case and the classically modelled viscoelastic damping case, a sub-optimal closed form solution is derived that is independent of the initial conditions. An iterative technique that minimizes the average value of the cost functional and one that minimizes the maximum value are developed. Both techniques are applicable to viscous and viscoelastic …


Analysis And Characteristics Of Compressor Stall Precursor Signals In Forward And Aft Swept High Speed Compressor, Bernard J. Frank Dec 1993

Analysis And Characteristics Of Compressor Stall Precursor Signals In Forward And Aft Swept High Speed Compressor, Bernard J. Frank

Theses and Dissertations

The stall characteristic of four single-stage transonic compressor rotors were investigated as they were throttled to stall. Forward-swept, backward-swept, and straight leading edge rotors were examined. Three methods of analysis (1) windowed power spectrum densities of pressure and spatial Fourier coefficients, (2) phase tracking analysis, and (3) system identification were used to identify the first appearance of modal waves and their accompanying frequencies in order to identify a stall warning time. A direct correlation between the amount of stall warning time and the shape of the compressor characteristic was found. Specifically, if the compressor characteristic had a significant period of …


Investigation Into Model-Based Fuzzy Logic Control, Michael W. Logan Dec 1993

Investigation Into Model-Based Fuzzy Logic Control, Michael W. Logan

Theses and Dissertations

This thesis investigates the feasibility of a proposed hybrid linear/Fuzzy controller for nonlinear plants. The proposed controller concept is based on the use of multiple linearizations of a nonlinear plant, which describe the dynamics of perturbations about equilibrium points throughout the desired envelope of operation. A bank of linear compensators is developed, each corresponding to a linearized plant about a different equilibrium. The multiple control signals generated by the bank of compensators are then weighted and summed using Fuzzy Logic to produce a composite control perturbation signal, which is used to drive the nonlinear plant. Experiments were conducted to test …


Design Of A Subsonic Envelope Flight Control System For The Vista F-16 Using Quantitative Feedback Theory, Odell R. Reynolds Dec 1993

Design Of A Subsonic Envelope Flight Control System For The Vista F-16 Using Quantitative Feedback Theory, Odell R. Reynolds

Theses and Dissertations

A controlled plant's characteristics can vary widely throughout its operational envelope. This is a major problem in nominal plant-based control system design. Hence, gain scheduling is often used for full envelop design. In this paper, it is proposed to address the plant's variability using robust control design concepts. In particular, the frequency domain based Quantitative Feedback Theory Multiple-Input Multiple-Output robust control design method is employed for the synthesis of a full envelop flight control system for an F-16 derivative. Compensators for the aircraft's pitch and lateral directional channels are designed, and the designs are validated using linear simulations.


Neural Networks For Dynamic Flight Control, Ronald E. Setzer Dec 1993

Neural Networks For Dynamic Flight Control, Ronald E. Setzer

Theses and Dissertations

This thesis examines the application of artificial neural networks (NNs) to the problem of dynamic flight control. The specific application is the control of a flying model helicopter. The control interface is provided through a hardware and software test bed called the Fast Adaptive Maneuvering Experiment (FAME). The NN design approach uses two NNs: one trained as an emulator of the plant and the other trained to control the emulator. The emulator neural network is designed to reproduce the flight dynamics of the experimental plant. The controller is then designed to produce the appropriate control inputs to drive the emulator …


Exploring Qdes As A Tool For Determining Limits Of Achievable Performance In Aircraft Design, Mark F. Reidinger Dec 1993

Exploring Qdes As A Tool For Determining Limits Of Achievable Performance In Aircraft Design, Mark F. Reidinger

Theses and Dissertations

This thesis explores the usefulness of a computer aided control design software package called QDES in determining the limits of achievable aircraft performance as it relates to controller capability. Modern aircraft, particularly fighters, are being designed to be statically unstable to enhance their maneuverability and performance. It is possible that the aircraft, although physically capable of a certain level of performance due to its engine/ airframe combination, may be uncontrollable up to this level. This study sought to develop a methodology to use QDES to make a preliminary analysis of an aircraft design to determine if there exists a controller …


Study Of Longitudinal Landing Flying Qualities Evaluation Using Pilot Model Theory, Eric D. Didomenico Dec 1984

Study Of Longitudinal Landing Flying Qualities Evaluation Using Pilot Model Theory, Eric D. Didomenico

Theses and Dissertations

Control Anticipation Parameter (CAP), used in MIL-SPEC-8785C as a longitudinal handling qualities criterion does not adequately distinguish between different flight phases. Recent flight test data from the Landing Approach Higher Order Systems (LAHOS) study further indicate the inadequacy of the second order approximations for higher order longitudinal landing flying qualities. Nine Aircraft that fall within the Level 1 boundary reveal pilot ratings ranging from 1.5 to 10 (Cooper/Harper). These nine aircraft are studied by combining their longitudinal dynamics with pilot modelling to examine a better method of landing flying quality prediction and evaluation. Pilot model theory (cross-over pilot model) is …