Open Access. Powered by Scholars. Published by Universities.®
Articles 121 - 150 of 171
Full-Text Articles in Public Policy
Ddasaccident143, Hd-Aid
Ddasaccident143, Hd-Aid
Global CWD Repository
The investigators determined that a dog had indicated a reading and Victim No.1 used his detector at the site and got two readings 35cm apart. He marked one of the indications and uncovered a MK 7 AT mine. Thinking that the second reading must be a fragment, he began investigating it carelessly and detonated the mine. His bayonet was "lost".
Ddasaccident145, Hd-Aid
Ddasaccident145, Hd-Aid
Global CWD Repository
The investigators found that "the ground was suitable for prodding in a prone position, but the victim was performing prodding in the squatting position. During prodding he failed to maintain the correct prodding angle and applied excessive pressure on the mine…it is presumed that the locator of the victim might not have been working properly…" The deminer's visor and glove were damaged, and his bayonet was reported to have been "lost".
Ddasaccident147, Hd-Aid
Ddasaccident147, Hd-Aid
Global CWD Repository
The investigators determined that the accident occurred when the deminer used only one marking stone to mark a detector signal, then prodded in a squatting position which "failed him to maintain the correct prodding angle". It is suggested that he was careless because he thought he had detected a fragment (having detected many fragments immediately beforehand).
Ddasaccident008, Hd-Aid
Ddasaccident008, Hd-Aid
Global CWD Repository
At 10:30 the victim was walking through the area to reach the rest area when he stood on a mine, thought to be a PMN buried to a depth of about 5cm. The victim suffered a below knee amputation to his left leg and minor injuries to both arms and legs.
Ddasaccident138, Hd-Aid
Ddasaccident138, Hd-Aid
Global CWD Repository
The accident area was undulating and steep with dry earth and rock. The team had found "many" PMNs in the area prior to the accident. The deminer was clearing a safe-lane and was using a prodder to inspect a reading when a PMN exploded at 11:20. He suffered minor blast injuries to his neck and chin as well as small injuries to both hands in the dorsal area and his right shoulder. His visor and helmet took most of the blast. The victim walked out of the accident area and was taken to the Emergency hospital in Sulymania along with …
Ddasaccident150, Hd-Aid
Ddasaccident150, Hd-Aid
Global CWD Repository
The investigators determined that the victim investigated a signal and found part of the handle of a metal spoon. When checking the spot again, the detector signalled again and the deminer did not re-mark the signal properly because he thought the signal would be from the rest of the spoon. He prodded in a squatting position and initiated the mine with his bayonet – which was "destroyed".
Ddasaccident152, Hd-Aid
Ddasaccident152, Hd-Aid
Global CWD Repository
The investigators determined that the victim was clearing a breaching lane. He got a detector reading, marked it with a single stone, and began to prod in a squatting position. During prodding he initiated the mine. The victim was wearing a helmet and visor.
Ddasaccident154, Hd-Aid
Ddasaccident154, Hd-Aid
Global CWD Repository
The investigators decided that the two victims were assigned a breaching lane to clear. Victim No.1 was eager to finish investigating a signal when a rest period was announced, so hurried and used excessive force. Victim No.2: was not maintaining the safety distance required and was also injured.
Ddasaccident012, Hd-Aid
Ddasaccident012, Hd-Aid
Global CWD Repository
The victim had last attended a revision course seven months before and had last been on leave eight days before the accident. The accident occurred on ground described as soft agricultural land. A photograph showed the ground which appeared to be dust on top of compacted fine-silt.
Ddasaccident078, Hd-Aid
Ddasaccident078, Hd-Aid
Global CWD Repository
The Team leader was preparing to destroy the discovered mines when he was injured in the first mine accident on the site that day [See accident No.227]. After the Supervisor had dealt with that accident he went looking for the deminer who had found the mines, intending to appoint him as the acting Team Leader.
Ddasaccident077, Hd-Aid
Ddasaccident077, Hd-Aid
Global CWD Repository
A deminer [the victim in a later accident on the same day] began clearance and located a PMN. He informed the Team Leader and then continued work and located another two PMNs. He then moved to the end of the clearance lane and found a further three PMNs. As he worked he marked the lane by taking markers from the right side and putting them on the left side. Each of the discovered mines was marked with a wooden picket.
Ddasaccident157, Hd-Aid
Ddasaccident157, Hd-Aid
Global CWD Repository
The investigators determined that the victim was working in a “small garden”. His detector registered a signal and he prodded and located a fragment. He checked the area with the detector and it signalled again, so he prodded the same area and the mine initiated. The deminer's helmet and bayonet prodder were "destroyed". A photograph showed that the visor has been torn from the helmet on one side.
Ddasaccident156, Hd-Aid
Ddasaccident156, Hd-Aid
Global CWD Repository
The investigators determined that the victim used his detector over the two meter clearance lane he was working. He then put on an anti-fragment jacket and a helmet to start prodding. During the prodding he "made mistake by inserting excessive pressure on the top of the mine…"
Ddasaccident026, Hd-Aid
Ddasaccident026, Hd-Aid
Global CWD Repository
On the day of the accident a truck initiated a mine with its right front wheel as it turned onto the verge to unload. The driver was sitting above the wheel that caused the detonation. He escaped from the cab before it caught fire. He was taken to hospital but later discharged in "good health". The blast wave threw the truck one-meter forward, destroyed the wheel and made the cab and front tyres catch fire. [Photographs indicate minimal blast damage to the cab above the wheel arch – implying deflagration rather than detonation of the device, or an incendiary/small blast …
Ddasaccident082, Hd-Aid
Ddasaccident082, Hd-Aid
Global CWD Repository
The investigators determined that the victim had checked the area with a detector then started to cut the grass and bush with a sickle. He stepped on a mine that he has missed at the end of his work on the previous day. The investigation was limited by bad security in the area and the investigators were unable to validate a claim that the Schiebel detector signalled constantly and so was unreliable.
Ddasaccident084, Hd-Aid
Ddasaccident084, Hd-Aid
Global CWD Repository
The investigators determined that the victim was clearing the side of a small stream when he got a detector signal and marked it, then prodded but could not find anything. He checked the reading but did not "remark" it and started to prod again. The mine detonated. The victim's visor shattered into many shards in the blast (as shown in a photograph). His bayonet had a bent blade and the handle had broken up.
Ddasaccident083, Hd-Aid
Ddasaccident083, Hd-Aid
Global CWD Repository
The victim had been a deminer for three years. It was two months since he had last attended a revision course and seven days since his last leave. The area being cleared was described as "hard and bushy". The investigators decided that the mine involved was a PMN and that either the victim was cutting bushes without sweeping/detecting the area in front of him, or the deminer lost his balance while squatting to cut bush and stepped sideways onto a mine. His helmet was reported to have been damaged in the blast.
Ddasaccident086, Hd-Aid
Ddasaccident086, Hd-Aid
Global CWD Repository
The investigators determined that the victim had investigated a reading in the squatting position with a prod. He was not "wearing his helmet properly". They identified the mine as a PMN (from "found fragments") and recorded that the victim's helmet and bayonet were "destroyed".
Ddasaccident088, Hd-Aid
Ddasaccident088, Hd-Aid
Global CWD Repository
The investigators determined that, after a dog had signalled at a spot, the deminer located a signal with a detector and marked it, then started digging with a pick. His partner warning him to change to a bayonet at the second marker but he ignored the warning. He dug up to the third marker with the pick, so struck the mine. His pick was "destroyed".
Ddasaccident101, Hd-Aid
Ddasaccident101, Hd-Aid
Global CWD Repository
The investigators determined that the victim thought a detector reading was a fragment and was careless when prodding. The mine was identified as a PMN (from "found fragments/pieces"). The victim's bayonet was "lost" and his helmet damaged.
Ddasaccident089, Hd-Aid
Ddasaccident089, Hd-Aid
Global CWD Repository
The investigators determined that the victim was prodding with a bayonet in the squatting position, but was not wearing a frag-vest. He was wearing his helmet when he prodded onto a PMN mine. The victim's bayonet was "lost" and the helmet damaged.
Ddasaccident090, Hd-Aid
Ddasaccident090, Hd-Aid
Global CWD Repository
The investigators determined that the victim was working in a bushy clearance lane with continuous detector readings. Because of the continuous reading, he was digging all of the area and prodded with excessive force and let off a PMN. They identified the device by "found fragments". The victim believing that he had touched a tripwire with his bayonet.
Ddasaccident092, Hd-Aid
Ddasaccident092, Hd-Aid
Global CWD Repository
The investigators decided that the accident occurred because the victim ignored technical safety procedures and used a shovel for investigation and prodding purposes. He applied too much pressure on the device and "caused the explosion".
Ddasaccident093, Hd-Aid
Ddasaccident093, Hd-Aid
Global CWD Repository
The Investigators determined that the accident occurred when the Assistant Team Leader and the Section Leader went to inspect the site of another accident that had occurred the day before [believed to be 1st June]. They did this without the permission of the Team Leader, and without his being aware of it.
Ddasaccident094, Hd-Aid
Ddasaccident094, Hd-Aid
Global CWD Repository
The investigators determined that the victim was working in an area with barbed wire obstacles (that should have been cut and removed). After going around the wire and detecting again he got a reading. He did not mark the reading but squatted and started to prod with his bayonet, and detonated the mine (which was identified as a PMN from "found fragments".
Ddasaccident095, Hd-Aid
Ddasaccident095, Hd-Aid
Global CWD Repository
The investigators determined that the victim did not centralise the reading point from his detector and "did not follow the marking procedures properly". He prodded while in a squatting position. They noted that the device was identified as a PMN (from "found fragments") and that the victim's helmet and bayonet were "destroyed".
Ddasaccident096, Hd-Aid
Ddasaccident096, Hd-Aid
Global CWD Repository
The investigators determined that the victim was checking the boundary land and got a reading with his detector and investigated it with his prodder. He prodded in the squatting position but found nothing. As he stood up to recheck the position with his detector the device went off in front of him.
Ddasaccident099, Hd-Aid
Ddasaccident099, Hd-Aid
Global CWD Repository
The investigators determined that the victim was marking the cleared area up to a mine he had uncovered and which was awaiting detonation. It was near the end of the day so he wanted to go off duty after the found mine was destroyed. He dropped a stone close (25cm) to the found mine and the impact detonated another mine close by. His visor was up at the time, so his face was unprotected. The mine was identified as a PMN [presumably by inference].
Ddasaccident102, Hd-Aid
Ddasaccident102, Hd-Aid
Global CWD Repository
The investigators determined that the victim was clearing the dry bed of a lake [this appears to conflict with "hillside"] and prodded to investigate an area that the dog had indicated. He used his detector then investigated the reading with a pick. The mine was identified as a PMN (from "found fragments"). The victim's pick handle and his visor were damaged. The victim walked out of mined area unaided.
Ddasaccident028, Hd-Aid
Ddasaccident028, Hd-Aid
Global CWD Repository
The accident occurred at 12:30 in a minefield laid by the Portuguese in the early 1970s. The mines were Italian AUPS mines, with and without fragmentation jackets. The demining group had been working in the area since 1996 and 234 AUPS mines had been destroyed. "The minefield crosses the road many times as it is linked as an obstacle with the river which is running along the valley. At the accident site, the minefield following the road alignment at a distance of about six metres on a rocky slope of approximately 35 degrees." Clearance of ten metres had occurred at …