Open Access. Powered by Scholars. Published by Universities.®

Optics Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Optics

Collision Broadening Using Alkali-Filled, Hollow Core Fibers, Luke P. Rodgers Oct 2007

Collision Broadening Using Alkali-Filled, Hollow Core Fibers, Luke P. Rodgers

Theses and Dissertations

The goal of this research was to demonstrate the possibility of collision broadening in a cesium-filled, hollow-core fiber as an alternative to the proven technique of pressure broadening. Theoretically, alkali electrons should relax from the 2P3/2 to the 2P1/2 level and the absorption spectrum should collisionally broaden due to the presence of fiber walls, as opposed to the more common pressure broadening method. An absorption dip located at 852.34nm was recorded in a pressure broadened comparison leg. This data was used as a baseline during analysis of the fiber leg's data. While the fiber was successfully …


A Study Of Bi-Directional Reflectance Distribution Functions And Their Effects On Infrared Signature Models, Samuel I. Harkiss Mar 2007

A Study Of Bi-Directional Reflectance Distribution Functions And Their Effects On Infrared Signature Models, Samuel I. Harkiss

Theses and Dissertations

Since 2004, AFIT has been developing a trend-analysis tool to assess large commercial aircraft infrared (LCAIR) signatures. In many cases, this code predicted signatures to within 10% of measured data. However, other results indicated that the single-bounce, specular-reflection algorithm being used failed to adequately simulate interactions between aircraft parts where either the specular component is dominated by diffuse reflection or part-to-part multiple-bounce reflections contribute significantly to the signature. This research incorporates Bi-Directional Reflectance Distribution Functions (BRDF's) and multiple-bounce calculations into the LCAIR model. A physical aircraft model was constructed from aluminum, and measurements were taken before and after a surface …


Optical Tracking For Relative Positioning In Automated Aerial Refueling, James H. Spencer Mar 2007

Optical Tracking For Relative Positioning In Automated Aerial Refueling, James H. Spencer

Theses and Dissertations

An algorithm is designed to extract features from video of an air refueling tanker for use in determining the precise relative position of a receiver aircraft. The algorithm is based on receiving a known estimate of the tanker aircraft's position and attitude. The algorithm then uses a known feature model of the tanker to predict the location of those features on a video frame. A corner detector is used to extract features from the video. The measured corners are then associated with known features and tracked from frame to frame. For each frame, the associated features are used to calculate …


Direct Diode Pumped Raman Amplifier Based On A Multimode Graded Index Fiberr, Charles James Baird Mar 2007

Direct Diode Pumped Raman Amplifier Based On A Multimode Graded Index Fiberr, Charles James Baird

Theses and Dissertations

The direct pumping of a Raman fiber amplifier (RFA) was attempted using an array of four 25W, fiber pigtailed diodes at 936nm, combined via a 7 channel fiber beam combiner. The initial attempt was conducted using a 1.8 km, 100 micron core, GRIN fiber with an NA of .29 and attenuation 3.6 dB/km at 936nm. While amplification was not achieved, over 200mW of conversion was shown, with 10.4W of pump power and 3.5W of seed. This corresponds to an average conversion efficiency of 2.2%. The subsequent effort utilized a 2km long, 200 micron core, GRIN fiber, with NA of .27 …