Engineering Physics Commons^™

Reflection-High Energy Electron Diffraction Study Of Si(100) Homoepitaxy By Femtosecond Pulsed Laser Deposition, Mohammed S. Hegazy

Electrical & Computer Engineering Theses & Dissertations

The dynamics of femtosecond pulsed laser deposition (fsPLD) of Si(!00)-1 x I and Si(!00)-2x I homoepitaxy are studied by in situ reflection high-energy electron diffraction (RHEED) and ex situ atomic force microscopy (AFM). The effects of substrate temperature, laser fluence and the pressure of a passive gas on the Si(!00)-1 x I growth mode are discussed. It is shown that films grow following the Volmer-Weber (3D) growth mode. The substrate temperature largely affects the morphology of the grown film. Below ~ 400 °C (at laser fluence of~ 1.9 J/cm²), randomly oriented 3D clusters are grown. This is shown …

Cuin1-Xalxse2 Thin Films And Solar Cells, P. D. Paulson, M. W. Haimbodi, S. Marsillac, R. W. Birkmire, W. N. Shafarman

Electrical & Computer Engineering Faculty Publications

CuIn[sub 1-x]Al[sub x]Se[sub 2] thin films are investigated for their application as the absorber layer material for high efficiency solar cells. Single-phase CuIn[sub 1-x]Al[sub x]Se[sub 2] films were deposited by four source elemental evaporation with a composition range of 0≤x≤0.6. All these films demonstrate a normalized subband gap transmission >85% with 2 µm film thickness. Band gaps obtained from spectroscopic ellipsometry show an increase with the Al content in the CuIn[sub 1-x]Al[sub x]Se[sub 2] film with a bowing parameter of 0.62. The structural properties investigated using x-ray diffraction measurements show a decrease in lattice spacing as the Al content increases. …

Improvements In Wavelength Modulation Spectroscopy Using Ratios Of Higher Harmonics, James Michael Barrington

Electrical & Computer Engineering Theses & Dissertations

Experiments in Wavelength Modulation Spectroscopy have been conducted at Old Dominion University since 1996. The method provides a highly sensitive, nonintrusive method of probing gases. Research has concentrated on effectively modeling the higher harmonic shapes that are measured experimentally. Accurately modeling these signals will result in the ability to reliably extract the information contained in transition line shapes.

In order to accurately depict the signals, the theory must be thoroughly understood. This thesis develops the theory of Wavelength Modulation Spectroscopy from two aspects: a direct Fourier series expansion of a time varying intensity profile and through communication theory. In addition, …

Collisional Dynamics Of Bi2 A(0U+). Ii. State-To-State Rotational Energy Transfer, Robert E. Franklin, Glen P. Perram

Faculty Publications

Rotational-to-translational (R–T) energy transfer within v′=1 of the A(0⁺_u) state of Bi₂ has been investigated using spectrally resolved, laser induced fluorescence techniques. Spectrally resolved emissions from collisionally populated rotational levels of Bi₂(A,v′=1) were observed for helium, neon, and argon collision partners after laser excitation of the high rotational levels J′=171, 201, and 231. Total rotational removal rates from the initially prepared state range from 2.8–8.9×10−10 cm3/molecule s. Collisional population of rotational states with |ΔJ|⩽56 was observed at pressures of 0.09–1.4 Torr. The state-to-state rates are adequately modeled by the energy based statistical power gap …

Specification Of Jecp/Sp: Stereographic Projection With An Application For Specimen Orientation Adjustment Using Tem Holders, Xingzhong Li

Nebraska Center for Materials and Nanoscience: Faculty Publications

1. Purpose of the program 2. Graphic user interface and program design 3. Crystallographic principle and implementation 4. System requirement 5. Installation and user instruction 6. How to contact the author 7. References

1. Purpose of the program JECP/SP is a computer program in Java Electron Crystallography Package. JECP is developed for quantitative electron diffraction and image processing, the package is designed and written by Dr. XingZhong Li. JECP/SP provides the all necessary functions of stereographic projection for regular application and furthermore it can be used to minimized the difficulties encountered when tilting highly beam-sensitive, or small-grain-size specimens with known …

Cooling Atoms In An Optical Trap By Selective Parametric Excitation, Nicola Poli, Robert J. Brecha, Giacomo Roati, Giovanni Modugno

Physics Faculty Publications

We demonstrate the possibility of energy-selective removal of cold atoms from a tight optical trap by means of parametric excitation of the trap vibrational modes. Taking advantage of the anharmonicity of the trap potential, we either selectively remove the most energetic trapped atoms or excite those at the bottom of the trap by tuning the parametric modulation frequency. This process, which had been previously identified as a possible source of heating, also appears to be a robust way for forcing evaporative cooling in anharmonic traps.

Jecp/Ed Manual, Xingzhong Li

Nebraska Center for Materials and Nanoscience: Faculty Publications

JECP/ED is a Java program with graphic interface for simulating electron diffraction pattern. It is designed and written by Dr. Xingzhong in University of Nebraska- Lincoln. This is verision 12-2002. It can be used for simulating electron diffraction zone pattern(ZOLZ with/without FOLZ), it allows to select zone axis, high voltage, sample thickness in the simulation, optional to show index, intensity and Laue center, featureed with manuniplating the pattern with slightly tilting, 360 degree rotation, zoom. The diffraction intensity is calculated on the basis of the kinematical theory. The program is extended to simulate electron diffraction with a precession of incident …

High-Efficiency Solar Cells Based On Cu(Inal)Se[Sub 2] Thin Films, S. Marsillac, P. D. Paulson, M. W. Haimbodi, R. W. Birkmire, W. N. Shafarman

Electrical & Computer Engineering Faculty Publications

A Cu(InAl)Se₂solar cell with 16.9% efficiency is demonstrated using a Cu(InAl)Se₂thin film deposited by four-source elemental evaporation and a device structure of glass/Mo/Cu(InAl)Se₂/CdS/ZnO/indium tin oxide/(Ni/Algrid)/MgF₂. A key to high efficiency is improved adhesion between the Cu(InAl)Se₂ and the Mo back contact layer, provided by a 5-nm-thick Ga interlayer, which enabled the Cu(InAl)Se₂ to be deposited at a 530 °C substrate temperature. Film and device properties are compared to Cu(InGa)Se₂ with the same band gap of 1.16 eV. The solar cells have similar behavior, with performance limited by recombination through …

Advances In Space Radiation Shielding Codes, John W. Wilson, Ram K. Tripathi, Garry D. Qualls, Francis A. Cucinotta, Richard E. Prael, John W. Norbury, John H. Heinbockel, John Tweed, Giovanni De Angelis

Mathematics & Statistics Faculty Publications

Early space radiation shield code development relied on Monte Carlo methods and made important contributions to the space program. Monte Carlo methods have resorted to restricted one-dimensional problems leading to imperfect representation of appropriate boundary conditions. Even so, intensive computational requirements resulted and shield evaluation was made near the end of the design process. Resolving shielding issues usually had a negative impact on the design. Improved spacecraft shield design requires early entry of radiation constraints into the design process to maximize performance and minimize costs. As a result, we have been investigating high-speed computational procedures to allow shield analysis from …