Engineering Physics Commons^™

Plasma Processes And Polymers Special Issue On: Plasma And Cancer, Mounir Laroussi, Michael Keidar

Electrical & Computer Engineering Faculty Publications

During the last two decades, research efforts on the application of low temperature plasmas in biology and medicine have positioned nonequilibrium lowtemperature plasmas as a technology that has the potential of revolutionizing healthcare.[1,2] Low temperature plasmas can be applied in direct contact with living tissues to inactivate bacteria,[3] to disinfect wounds and accelerate wound healing,[4] and to induce damage in some cancer cells.[5–11]

Feedback Stabilization At Spear3, Daniel Kelley, Jeff Corbett

STAR Program Research Presentations

The SPEAR3 synchrotron lightsource at SLAC relies on a sophisticated radio frequency (RF) timing system to maintain current – electrons – in the storage ring. One problem SPEAR3 operators have dealt with is the thermal expansion of one of the cables supporting this RF timing system. As the cable expands and contracts with the diurnal rise and fall of the sun, the phase of the RF in the cable shifts. This shifting phase affects the timing accuracy of electron injections into the storage ring.

A common feedback control algorithm PID (Proportional Integral Derivative) has countless applications in engineering. PID feedback …

Study Of A Non-Equilibrium Plasma Pinch With Application For Microwave Generation, Ahmad Al Agry

UNLV Theses, Dissertations, Professional Papers, and Capstones

The Non-Equilibrium Plasma Pinch (NEPP), also known as the Dense Plasma Focus (DPF) is well known as a source of energetic ions, relativistic electrons and neutrons as well as electromagnetic radiation extending from the infrared to X-ray. In this dissertation, the operation of a 15 kJ, Mather type, NEPP machine is studied in detail. A large number of experiments are carried out to tune the machine parameters for best performance using helium and hydrogen as filling gases. The NEPP machine is modified to be able to extract the copious number of electrons generated at the pinch. A hollow anode with …

Examining The Validity Of Using A Gaussian Schell-Model Source To Model The Scattering Of A Fully Coherent Gaussian Beam From A Rough Impedance Surface, Santasri Basu, Milo W. Hyde Iv, Salvatore J. Cusumano, Michael A. Marciniak, Steven T. Fiorino

Faculty Publications

Military applications that use adaptive optics (AO) often require a point source beacon at the target to measure and correct for wavefront aberrations introduced by atmospheric turbulence. However, turbulence prevents the formation of such a point beacon. The extended beacons that are created instead have finite spatial extents and exhibit varying degrees of spatial coherence. Modeling these extended beacons using a Gaussian Schell-model (GSM) form for the autocorrelation function would be a convenient approach due to the analytical tractability of Gaussian functions. We examine the validity of using such a model by evaluating the field scattered from a rough impedance …

Magnetic Bunch Compression For A Compact Compton Source, B.R.P. Gamage, T. Satogata

Physics Faculty Publications

A compact electron accelerator suitable for Compton source applications is in design at the Center for Accelerator Science at Old Dominion University and Jefferson Lab. Here we discuss two options for transverse magnetic bunch compression and final focus, each involving a 4-dipole chicane with M56 tunable over a range of 1.5-2.0m with independent tuning of final focus to interaction point \beta*=5mm. One design has no net bending, while the other has net bending of 90 degrees and is suitable for compact corner placement.

Mechanical Analysis Of The 400 Mhz Rf-Dipole Crabbing Cavity Prototype For Lhc High Luminosity Upgrade, S. U. De Silva, H. Park, J. R. Delayen, Z. Li

Physics Faculty Publications

The proposed LHC high luminosity upgrade requires two crabbing systems in increasing the peak luminosity, operating both vertically and horizontally at two interaction points of IP1 and IP5. The required system has tight dimensional constraints and needs to achieve higher operational gradients. A proof-of-principle 400 MHz crabbing cavity design has been successfully tested and has proven to be an ideal candidate for the crabbing system. The cylindrical proof-of-principle rf-dipole design has been adapted in to a square shaped design to further meet the dimensional requirements. The new rf-dipole design has been optimized in meeting the requirements in rf-properties, higher order …

Multipole Field Effects For The Superconducting Parallel-Bar/Rf-Dipole Deflecting/Crabbing Cavities, S. U. De Silva, J. R. Delayen

Physics Faculty Publications

The superconducting parallel-bar deflecting/crabbing cavity is currently being considered as one of the design options in rf separation for the Jefferson Lab 12 GeV upgrade and for the crabbing cavity for the proposed LHC luminosity upgrade. Knowledge of multipole field effects is important for accurate beam dynamics study of rf structures. The multipole components can be accurately determined numerically using the electromagnetic surface field data in the rf structure. This paper discusses the detailed analysis of those components for the fundamental deflecting/crabbing mode and higher order modes in the parallel-bar deflecting/crabbing cavity.

Study Of Cavity Imperfection Impact On Rf-Parameters And Multipole Components In A Superconducting Rf-Dipole Cavity, R. G. Olave, J. R. Delayen, S. U. De Silva, Z. Li

Physics Faculty Publications

The ODU/SLAC superconducting rf-dipole cavity is under consideration for the crab-crossing system in the upcoming LHC luminosity upgrade. While the proposed cavity complies well within the rf-parameters and multipolar component restrictions for the LHC system, cavity imperfections arising from cavity fabrication, welding and frequency tuning may have a significant effect in these parameters. We report on an initial study of the impact of deviation from the ideal shape on the cavity’s performance in terms of rf-parameters and multipolar components.

Comparison Of Electromagnetic, Thermal And Mechanical Calculations With Rf Test Results In Rf Dipole Deflecting/Crabbing Cavities, H. Park, S. U. Silva, J. R. Delayen

Physics Faculty Publications

The current requirements of higher gradients and strict dimensional constraints in the emerging applications have required the designing of compact deflecting and crabbing rf structures. The superconducting rf-dipole cavity is one of the first novel compact designs with attractive properties such as higher gradients, higher shunt impedance and widely separated higher order modes. The recent tests performed on proof-of-principle designs of the rf-dipole geometry at 4.2 K and 2.0 K in a vertical test assembly have proven the designs to achieve higher gradients with higher intrinsic quality factors and easily processed multipacting conditions. The design frequency sensitivity to pressure (df/dp) …

Geometry Effects On Multipole Components And Beam Optics In High-Velocity Multi-Spoke Cavities, C. S. Hopper, K. Deitrick, J. R. Delayen

Physics Faculty Publications

Velocity-of-light, multi-spoke cavities are being proposed to accelerate electrons in a compact light-source [1]. There are strict requirements on the beam quality which require that the linac have only small non-uniformities in the accelerating field. Beam dynamics simulations have uncovered varying levels of focusing and defocusing in the proposed cavities, which is dependent on the geometry of the spoke in the vicinity of the beam path. Here we present results for the influence different spoke geometries have on the multipole components of the accelerating field and how these components, in turn, impact the simulated beam properties.

Contamination Effects On Fixed-Bias Langmuir Probes, C.T. Steigies, A. Barjatya

Publications

Langmuir probes are standard instruments for plasma density measurements on many sounding rockets. These probes can be operated in swept-bias as well as in fixed-bias modes. In swept-bias Langmuir probes, contamination effects are frequently visible as a hysteresis between consecutive up and down voltage ramps. This hysteresis, if not corrected, leads to poorly determined plasma densities and temperatures. With a properly chosen sweep function, the contamination parameters can be determined from the measurements and correct plasma parameters can then be determined. In this paper, we study the contamination effects on fixed-bias Langmuir probes, where no hysteresis type effect is seen …

Superconducting Spoke Cavities For Electron And High-Velocity Proton Linacs, J. R. Delayen

Physics Faculty Publications

Spoke resonantors are currently under development for many proton machines but these structures are also considered for high beta electron linacs as well. These structures compare well to traditional elliptical cavities.

Multipacting Analysis Of High-Velocity Superconducting Spoke Resonators, C. S. Hopper, J. R. Delayen

Physics Faculty Publications

Some of the advantages of superconducting spoke cavities are currently being investigated for the high-velocity regime. When determining a final, optimized geometry, one must consider the possible limiting effects multipacting could have on the cavity. We report on the results of analytical calculations and numerical simulations of multipacting electrons in superconducting spoke cavities and methods for reducing their impact.

Ignition Of A Large Volume Plasma With A Plasma Jet, M. Laroussi, M. A. Akman

Electrical & Computer Engineering Faculty Publications

Here we report on a method to generate a long plasma plume and to ignite a large volume plasma by means of the jet. The plasma plume is generated by our tube reactor and then introduced into a chamber where the pressure is controlled. We discovered there are three operating phases:Aphasewhere the plume length remains approximately constant, followed by a second phase where the jet increases in length as the pressure decreases. Then at pressures below 70 Torr a mode transition occurs where the plume length decreases and the plasma expands until the entire chamber is filled.

Finite Element Analysis Of Ring-Shaped Emission Profile In Plasma Bullet, Yukinori Sakiyama, David B. Graves, Julien Jarrige, Mounir Laroussi

Electrical & Computer Engineering Faculty Publications

Using a one-way coupled model of neutral gas flow and plasma dynamics we report a mechanism to explain the ring-shaped emission pattern that has been observed experimentally in plasma bullets at atmospheric pressure. We solve a fluid model with the local field approximation in one-dimensional cylindrical coordinates, corresponding to a cross-section of a plasma bullet. Pulselike uniform electric field is assumed to be applied perpendicular to the simulation domain. Time and spatially resolved spectroscopic measurements support the simulation results.

Coupled Ray-Tracing And Fokker-Planck Ebw Modeling For Spherical Tokamaks, Jakub Urban, Joan Decker, Y. Peysson, Josef Preinhaelter, Gary Taylor, Linda L. Vahala, George Vahala

Electrical & Computer Engineering Faculty Publications

The AMR (Antenna—Mode-conversion—Ray-tracing) code [1, 2] has been recently coupled with the LUKE [3] Fokker-Planck code. This modeling suite is capable of complex simulations of electron Bernstein wave (EBW) emission, heating and current drive. We employ these codes to study EBW heating and current drive performance under spherical tokamak (ST) configurations—typical NSTX discharges are employed. EBW parameters, such as frequency, antenna position and direction, are varied and optimized for particular configurations and objectives. In this way, we show the versatility of EBWs.

The Adaptability Of Langmuir Probes To The Pico-Satellite Regime, Andrew Jay Auman

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The purpose of this thesis is to investigate whether it is feasible to use Langmuir probes on pico-satellites flying in low Earth orbit over mid- to low-latitude geographic regions. Following chapters on the expected ionospheric conditions and an overview of Langmuir probe theory, a chapter addressing the difficulties involved with pico-satellite Langmuir probes is presented. Also, the necessary satellite-to-probe surface area requirements in order to achieve confidence in pico-satellite Langmuir probe data, for the orbital regions of interest to this thesis, are stated.

Plasma Treatment Of Bulk Niobium Surfaces For Srf Cavities, M. Rašković, L. Vuškovic, S. Popović, L. Phillips, A. -M. Valente-Feliciano, S. B. Radovanov, L. Godet

Physics Faculty Publications

Two types of electric discharges were used to demonstrate the validity of plasma surface treatment for superconducting radio-frequency (SRF) cavities. The experiments were performed on disc-shaped Nb samples and compared with identical samples treated with buffer chemical polishing (BCP) techniques. Surface analysis indicates comparable or superior properties of plasma-treated samples. These promising results are still preliminary and additional work is in progress.

Dynamics Of An Atmospheric Pressure Plasma Plume Generated By Submicrosecond Voltage Pulses, Xinpei Lu, Mounir Laroussi

Electrical & Computer Engineering Faculty Publications

Nonequilibrium plasmas driven by submicrosecond high voltage pulses have been proven to produce high-energy electrons, which in turn lead to enhanced ionization and excitations. Here, we describe a device capable of launching a cold plasma plume in the surrounding air. This device, "the plasma pencil," is driven by few hundred nanosecond wide pulses at repetition rates of a few kilohertz. Correlation between current-voltage characteristics and fast photography shows that the plasma plume is in fact a small bulletlike volume of plasma traveling at unusually high velocities. A model based on photoionization is used to explain the propagation kinetics of the …

Design And Fabrication Of A Prototype Fabry-Perot Cavity For The Compton Polarimeter Upgrade At Jefferson Lab, Deepa Deepa

Mechanical & Aerospace Engineering Theses & Dissertations

Upcoming experiments at Hall A at Jefferson lab require 1 % absolute accuracy of the electron beam polarization measurement at 0.85 Ge V energy. The Compton polarimeter at Hall A is capable of measuring beam polarization with 3 - 4 % accuracies at this beam energy. Hence it was proposed to upgrade the present Compton by doubling the laser frequency [2]. The present Compton polarimeter operates with a 1064 nm, continuous wave laser at 200 mW. This power is enhanced to 1.5 kW using a 0.85 m long Fabry-Perot Cavity. Changing to 532 nm laser with the same power would …

Optimization Of Ultraviolet Emission And Chemical Species Generation From A Pulsed Dielectric Barrier Discharge At Atmospheric Pressure, Xinpei Lu, Mounir Laroussi

Electrical & Computer Engineering Faculty Publications

One of the attractive features of nonthermal atmospheric pressure plasmas is the ability to achieve enhanced gas phase chemistry without the need for elevated gas temperatures. This attractive characteristic recently led to their extensive use in applications that require low temperatures, such as material processing and biomedical applications. The agents responsible for the efficient plasma reactivity are the ultraviolet (UV) photons and the chemically reactive species. In this paper, in order to optimize the UV radiation and reactive species generation efficiency, the plasma was generated by a dielectric barrier discharge driven by unipolar submicrosecond square pulses. To keep the discharge …

Effect Of Magnetic And Density Fluctuations On The Propagation Of Lower Hybrid Waves In Tokamaks, George Vahala, Linda L. Vahala, Paul T. Bonoli

Electrical & Computer Engineering Faculty Publications

Lower hybrid waves have been used extensively for plasma heating, current drive, and ramp-up as well as sawteeth stabilization, The wave kinetic equation for lower hybrid wave propagation is extended to include the effects of both magnetic and density fluctuations. This integral equation is then solved by Monte Carlo procedures for a toroidal plasma. It is shown that even for magnetic/density fluctuation levels on the order of 10^-4, there are significant magnetic fluctuation effects on the wave power deposition into the plasma. This effect is quite pronounced if the magnetic fluctuation spectrum is peaked within the plasma. For …