Engineering Physics Commons^™

Enhanced Adhesion Of Superhydrophobic Zno Surface, Liqiu Zheng Dr., Chan Kwaichow B.

Georgia Journal of Science

The superhydrophobicity and the strong solid-liquid adhesion of the dually structured ZnO surface are attributed to the suitable size of microstructure and nanostructure. This phenomenon, so different from the Lotus effect, can be called the Petal effect— the super hydrophobicity and the enhanced solid-liquid adhesion coexist on the same surface. The Cassie impregnating model was proposed to understand the underlying reason.

The Evaluation And Implementation Of Magnetic Fields For Large Strain Uniaxial And Biaxial Cyclic Testing Of Magnetorheological Elastomers., Dave Gorman, Niall Murphy, Ray Ekins, Stephen Jerrams

Articles

Magnetorheological Elastomers (MREs) are “smart” materials whose physical properties are altered by the application of magnetic fields. In previous studies the properties of MREs have been evaluated under a variety of conditions, however little attention has been paid to the recording and reporting of the magnetic fields used in these tests [1]. Currently there is no standard accepted method for specifying the magnetic field applied during MRE testing. This study presents a detailed map of a magnetic field applied during MRE tests as well as providing the first comparative results for uniaxial and biaxial testing under high strain fatigue test …

Fabricating Superhydrophobic And Superoleophobic Surfaces With Multiscale Roughness Using Airbrush And Electrospray, Karam N. Almilaji

Theses and Dissertations

Examples of superhydrophobic surfaces found in nature such as self-cleaning property of lotus leaf and walking on water ability of water strider have led to an extensive investigation in this area over the past few decades. When a water droplet rests on a textured surface, it may either form a liquid-solid-vapor composite interface by which the liquid droplet partially sits on air pockets or it may wet the surface in which the water replaces the trapped air depending on the surface roughness and the surface chemistry. Super water repellent surfaces have numerous applications in our daily life such as drag …

Does A Plastron Improve Heat Transfer?, Madani A. Khan, Jeffrey Alston, Andrew Guenthner

STAR Program Research Presentations

Superamphiphobic surfaces strongly repel both water and oils. In this work, aluminum coupons are processed by sanding with various grit of sand paper to impart microscale roughness. Subsequent submersion of the aluminum substrate in boiling water grows nanoscale grass-like structures. The oxide layer of Al is slightly soluble in water. During a fast diffusion/equilibrium, Al₂O₃ nanograss grows on the surface. A low energy coating is then deposited on the surface. The micro and nanoscale features create re-entrant structures that trap air enabling contact liquid to be in a Cassie-Baxter state. Superamphiphobicity of the samples were confirmed by …

Investigation Of The Addition Of Basalt Fibres Into Cement, Jahi Palme

Masters Theses & Specialist Projects

Mechanical properties of concrete are most commonly determined using destructive tests including: compression, flexure, and fracture notch specimen tests. However, nondestructive tests exist for evaluating the properties of concrete such as ultrasonic pulse velocity and impact echo tests. One of major issues with concrete (which has cement as its prime ingredient) is that unlike steel it is quasi-brittle material. It tends to want to crack when tensile stresses develop. Fibres have been added to concrete for many years to reduce the amount of and size of cracks cause by temperature changes or shrinkage. In more recent years, significant research has …

Large-Scale Solution Synthesis Of Narrow Graphene Nanoribbons, Timothy H. Vo, Mikhail Shekhirev, Donna A. Kunkel, Martha D. Morton, Eric Berglund, Lingmei Kong, Peter M. Wilson, Peter A. Dowben, Axel Enders, Alexander Sinitskii

Nebraska Center for Materials and Nanoscience: Faculty Publications

According to theoretical studies, narrow graphene nanoribbons with atomically precise armchair edges and widths of(1.1 eV), which makes them potentially promising for logic applications. Different top–down fabrication approaches typically yield ribbons with width >10nm and have limited control over their edge structure. Here we demonstrate a novel bottom–up approach that yields gram quantities of high-aspect-ratio graphene nanoribbons, which are only ~1 nm wide and have atomically smooth armchair edges. These ribbons are shown to have a large electronic bandgap of ~1.3 eV, which is significantly higher than any value reported so far in experimental studies of graphene nanoribbons prepared by …

Experimenting With Polymer Blend Solar Cells And Active Layer Thickness, Ryan Blumenthal

Physics

Bulk heterojunction organic photovoltaics utilize the electrical characteristics of semi-conductive polymers. These solution processable materials are beneficial because of their low material cost, light weight, and simple fabrication requirements. Our devices employ multiple photoactive polymers, P3HT and PCPDTBT, to absorb photons over a wide spectral range. We optimized various device characteristics including thickness and thermal anneal usage to reach a power conversion efficiency of 3.0% in AM1.5 sunlight. Device performance degrades over time due to atmospheric water and oxygen, prompting us to investigate device packaging to extend cell lifetime for additional testing.

Magnetic Ordering And Structural Phase Transition In Strained Ultrathin Srruo3/Srtio3 Superlattice, Mingquiang Gu, Xiaoshan Wu, Guoping Zhang

Symposium 2012

No abstract provided.

Use Of Quantum Mechanical Calculations To Investigate Small Silicon Carbide Clusters, Jean W. Henry

Theses and Dissertations

Density Functional Theory (DFT) method was employed to model silicon carbide small clusters. Comparing the DFT calculation results with experimental results that observed by using photoelectron spectroscopy (PES), DFT predicts the same structures that experiment observed. For electron affinity, DFT results are in good agreement with experimental results, the root mean square negative offset 0.1 eV found using medium size of basis set (cc-pVDZ+) calculation. DFT results for vibrational frequencies are in good agreement with experiment results; the root mean square error is 72.5 cm^-1 wave number. 16 ground state structures of Si_mC_n (m ≤ 4, …

Laser Pump And Probe Excited State Absorption Measurements, Shawpin Jong

Electrical & Computer Engineering Theses & Dissertations

A pump and probe technique was used to investigate triplet-triplet excited state absorption in solutions of the scintillators 2,5 diphenyloxazole (PPO) and 2,1 naphthyl,5 phenylzole (a-NPO) in several solvents.

KrF excimer radiation (248 nm) was used to pump the samples under investigation as well as a tunable dye laser which was used as the probe. Time-resolution was obtained by changing the optical path difference between the pump and probe beams.

Transient excited state absorption was measured in a wide spectral region between 330 nm and 600 nm, showing a peak at 400 nm for PPO solutions, and two …

Picosecond Laser Pulse Irradiation Of Crystalline Silicon, K. L. Merkle, H. Baumgart, R.H. Uebbing, F. Phillipp

Electrical & Computer Engineering Faculty Publications

Morphology changes introduced by picosecond laser pulses at λ = 532 nm and 355 nm in (111) and (100) silicon samples are studied by means of optical and high-voltage electron microscopy. Depending on energy fluence, orientation and wavelength, amorphous or highly defective regions may be created. From an analysis of damage thresholds and damage depth distributions it is concluded that melting and energy confinement precedes the formation of the structural changes.