Physics Commons^™

Synthesis And Characterization Of Renewable Heterogeneous Catalyst Zno Supported Biogenic Silica From Pineapple Leaves Ash For Sustainable Biodiesel Conversion, Nadila Pratiwi, Suriati Eka Putri, Yulia Shinta, Arya Ibnu Batara, Diana Eka Pratiwi, Abd Rahman, Nur Ahmad, Heryanto Heryanto

Karbala International Journal of Modern Science

This study reports on the first case of the low-cost and environmentally friendly ZnO/SiO2 heterogeneous catalyst from pineapple leaves ash (PLA). Catalyst shows excellent performance in catalyzing the transesterification of waste cooking oil (WCO) with methanol for biodiesel conversion. This study focuses on assessing the influence of Zn content on physicochemical characteristics, using XRD, FTIR, SEM, and N2 adsorption-desorption methods. In addition, three different Zn content levels (20, 25, and 30 %wt) were applied. The results showed that all ZnO/SiO2 samples exhibited characteristics suitable for use as catalyst with an average crystallite size of 31.83-34.15 nm, and a surface area …

High-Power Laser Cooling And Temperature-Dependent Fluorescence Studies Of Ytterbium Doped Silica, Brian Topper

Optical Science and Engineering ETDs

Experimental observation of optical refrigeration using ytterbium doped silica glass in recent years has created a new solution for heat mitigation in high-power laser systems, nonlinear fiber experiments, integrated photonics, and precision metrology. Current efforts of different groups focus on compositional optimization, fiber fabrication, and investigating how much silica can be cooled with a laser. At the start of this work, the best effort in laser cooling ytterbium doped silica saw cooling by 6 K from room temperature. This dissertation follows the experimental efforts that culminated in the increase of this initial record by one order of magnitude. Comprehensive spectroscopic …

Design And Application Of A 3d Photocatalyst Material For Water Purification, Simon Paul Fowler

Dissertations and Theses

This dissertation presents a method for enhancement of the efficiency and scalability of photocatalytic water purification systems, along with an experimental validation of the concept. A 3-dimensional photocatalyst structure, made from a TiO₂-SiO₂ composite, has been designed and fabricated for use in a custom designed LED-source illumination chamber of rotational symmetry that corresponds with the symmetry of the photocatalyst material. The design of the photocatalyst material has two defining characteristics: geometrical form and material composition. The design of the material was developed through the creation of a theoretical model for consideration of the system's photonic efficiency. Fabrication …

To Prepare Silica Soda Borate Glass From Biomass Ash And Study Its Optical Properties, Seema Ubale, Shraddha Bansod

The 8th International Conference on Physical and Numerical Simulation of Materials Processing

No abstract provided.

Ultrafast Laser-Induced Damage And The Influence Of Spectral Effects, Jeremy Gulley

Jeremy R. Gulley

Numerous studies have investigated the prerequisite role of photoionization in ultrafast laser-induced damage (LID) of bulk dielectrics. This study examines the role of spectral width and instantaneous laser frequency in LID using a frequency dependent multiphoton ionization (MPI) model and numerical simulation of initially 800 nm laser pulses propagating through fused silica. Assuming a band gap of 9 eV, MPI by an 800 nm field is a six-photon process, but when the instantaneous wavelength is greater than 827 nm an additional photon is required for photoionization, reducing the probability of the event by many orders of magnitude. Simulation results suggest …

Modeling Free-Carrier Absorption And Avalanching By Ultrashort Laser Pulses, Jeremy R. Gulley

Faculty and Research Publications

In the past decade it was demonstrated experimentally that negatively-chirped laser pulses can lower the surface LIDT for wide band-gap materials by decreasing the number of photons required for photoionization on the leading edge of the pulse. Similarly, simulations have shown that positively-chirped pulses resulting from selffocusing and self-phase modulation in bulk dielectrics can alter the onset of laser-induced material modifications by increasing the number of photons required for photoionization on the leading edge of the pulse. However, the role of multi-chromatic effects in free-carrier absorption and avalanching has yet to be addressed. In this work a frequency-selective model of …

Modeling Free-Carrier Absorption And Avalanching By Ultrashort Laser Pulses, Jeremy Gulley

Jeremy R. Gulley

In the past decade it was demonstrated experimentally that negatively-chirped laser pulses can lower the surface LIDT for wide band-gap materials by decreasing the number of photons required for photoionization on the leading edge of the pulse. Similarly, simulations have shown that positively-chirped pulses resulting from selffocusing and self-phase modulation in bulk dielectrics can alter the onset of laser-induced material modifications by increasing the number of photons required for photoionization on the leading edge of the pulse. However, the role of multi-chromatic effects in free-carrier absorption and avalanching has yet to be addressed. In this work a frequency-selective model of …

Frequency Dependence In The Initiation Of Laser-Induced Damage, Jeremy Gulley

Jeremy R. Gulley

Numerous studies have investigated the role of photoionization in ultrafast laser-induced damage of bulk dielectrics. This study examines the role of spectral width and instantaneous laser frequency in laser-induced damage using a frequency dependent multiphoton ionization model and numerical simulation of an 800 nm laser pulse propagating through fused silica. When the individual photon wavelengths are greater than 827 nm, an additional photon is required for photoionization, reducing the probability of the event by many orders of magnitude. Simulation results suggest that this frequency dependence may significantly affect the processes of laser-induced damage and filamentation.

Silicon-Sensitized Erbium Excitation In Silicon-Rich Silica For Integrated Photonics, Oleksandr Savchyn

Electronic Theses and Dissertations

It is widely accepted that the continued increase of processor performance requires at least partial replacement of electronic interconnects with their photonic counterparts. The implementation of optical interconnects requires the realization of a silicon-based light source, which is challenging task due to the low emission efficiency of silicon. One of the main approaches to address this challenge is the use of doping of silicon based matrices with optical centers, including erbium ions. Erbium ions incorporated in various hosts assume the trivalent state (Er3+) and demonstrate a transition at 1.54 μm, coinciding with optical transmission windows in both silicon and silica. …

Simulation And Analysis Of Ultrafast Laser Pulse Induced Plasma Generation In Dielectric Materials, Jeremy Gulley, Sebastian Winkler, William Dennis

Jeremy R. Gulley

Recent experiments on optical damage by ultrashort laser pulses have demonstrated that the temporal pulseshape can dramatically influence plasma generation in fused silica and sapphire. In this work a modified 3+1D nonlinear Schroedinger equation for the pulse propagation coupled to a rate equation for the plasma density in the dielectric material is used to simulate pulse propagation and plasma formation in a range of dielectric materials. We use these simulations to analyze the influence of pulse-width, pulse-shape and beam geometry on the formation of the electron plasma and hence damage in the bulk material. In particular, when possible, we simulate …

Effect Of Germanium Doping On Erbium Sensitization In The Erbium Doped Silicon Rich Silica Material System, Forrest Ruhge

Electronic Theses and Dissertations

The continued size reduction in electronic integrated circuits has lead to a demand for on-chip high-bandwidth and low loss communication channels. Optical interconnects are considered an essential addition to the silicon electronics platform. A major challenge in the field of integrated Si photonics is the development of cost effective silicon compatible light sources. This thesis investigates the sensitization of group IV doped silica films emitting at 1.535μm for applications as silicon compatible light sources. Thin erbium-doped silica films containing excess silicon and germanium were deposited using a multi-gun sputter system. The composition of the deposited materials was verified by Rutherford …

Ionic Polishing Of Fused Silica And Glass, Raymond Wilson

Raymond Wilson