Tectonics and Structure Commons^™

Kinematics And Timing Of The Miocene-Quaternary Deformation In Nellis Dunes Recreational Area, Nevada, Shaimaa Abdelhaleem

UNLV Theses, Dissertations, Professional Papers, and Capstones

The kinematics and origin of transfer, accommodation and strike-slip zones is of paramount significance in understanding continental extension. The Las Vegas Valley Shear Zone (LVVSZ) is a NW-striking right-lateral fault system in the central Basin and Range province. Despite its prominence among the structures of the region and its role in the regional tectonic development, little is understood about its eastern portion. The inadequately constrained trace of the LVVSZ along its eastern part contributes largely to the ambiguity of the time activity and role of the LVVSZ. The eastern part of LVVSZ lies in Nellis Dunes Recreational Area (NDRA), north …

Strain Energy Release From The 2011 9.0 Mw Tōhoku Earthquake, Japan, Kenneth M. Cruikshank, Curt D. Peterson

Geology Faculty Publications and Presentations

The purpose of this paper is to compare the strain energy released due to elastic rebound of the crust from the tragic 2011 9.0 Mw Tōhoku earthquake in Japan with the observed radiated seismic energy. The strain energy was calculated by analyzing coseismic displacements of 1024 GPS stations of the Japanese GEONET network. The value of energy released from the analysis is 1.75 × 1017 J, which is of the same order of magnitude as the USGS-observed radiated seismic energy of 1.9 × 1017 Nm (J). The strain energy method is independent of seismic methods for determining the energy released …

Final Report: Task 22 — Extreme Ground Motion Studies, John G. Anderson, James N. Brune, Jaak J.K. Daemen, Matthew Purvance

Publications (YM)

TASK 22 consisted of two separate investigations into extreme ground motions due to seismic events, Subtask 1 and Subtask 2. Subtask 1 included field studies of geological formations that should put an upper bound on extreme ground motions that have happened at the site of the formations. The locations are critically selected to provide the most effective constraints possible on the validity of the probabilistic seismic hazard analysis for Yucca Mountain. Subtask 2 surveyed recorded ground motions from around the world, with the aim to draw general conclusions from these as to the conditions where extreme ground motions are observed. …

Imaging The Southern Trace Of The Black Hills Fault, Clark County, Nevada, Shelley A. Zaragoza

UNLV Theses, Dissertations, Professional Papers, and Capstones

The Black Hills fault (BHF) is a SE-dipping normal fault forming the northwestern structural boundary of the Eldorado basin, ∼20 km southeast of Las Vegas, Nevada (Langenheim and Schmidt, 1996). The fault offsets Holocene strata and is thus considered to be active (Fossett, 2005). Therefore, the BHF poses a significant seismic hazard to the greater Las Vegas area.

Fossett (2005) estimated that the BHF is capable of producing a M _W 6.4 to 6.8 earthquake. However, this suggests a subsurface rupture length greater than the scarp length (Fossett, 2005). To test this hypothesis, remote sensing, geologic mapping, and high-resolution seismic …

Geodetic Monitoring Of The Yucca Mountain Region Using Continuous Gps Measurements, Geoff Blewitt, Jonathan Price, Nevada Geodetic Laboratory, Nevada Bureau Of Mines & Geology

Publications (YM)

What Task 3 is About:

Monitor current crustal deformation at YM
– In the broader tectonic context of the NA-Pacific plate boundary
– In the regional context of the East California Shear Zone (ECSZ)
– In the geological context of specific fault activity
– Vertical motion associated with geophysical fluids

Using geodetic methods
– GPS – mature, proven
track the 3-D point-positions of 47 stations with < 1 mm precision
– InSAR – new, experimental
regional map of displacement along the line-of-sight (accuracy??)
proven capability: (1) co-seismic deformation; (2) local instabilities

Longbase Laser Strainmeter Measurements At Yucca Mountain, James N. Brune

Publications (YM)

Why Operate a Strainmeter?

To monitor strain over a broader bandwidth and with much higher sensitivity than GPS (or other instruments):
– Measure strain from seismic, earth-tide, temperature and air pressure inputs--gives local rock properties, and changes in them.
– Independently constrains GPS results.

To directly measure in the Yucca Mountain Block:
– Sensitive to potential very local tectonic events, (including any triggered slip), or volcanic events.

To establish a baseline for future strain changes:
– E.g., events developing from loading and heating of the repository

Paleoseismology Of The Black Hills Fault, Southern Nevada, And Implications For Regional Tectonics, Eric Fossett

UNLV Theses, Dissertations, Professional Papers, and Capstones

The Black Hills fault (BHF) is a Holocene fault located in Eldorado Valley, approximately 7 km from Boulder City, southern Nevada. The importance of this study is to determine the seismic hazards the BHF poses to Boulder City and the greater Las Vegas metropolitan area and to determine the mechanisms driving the young deformation in the Lake Mead region. The BHF is a multistranded fault that had five surface rupturing paleoearthquake events in the past approximately 25 ka. Paleoseismic fault offsets indicate that the BHF is capable of generating a Mw = 6.4-6.9 earthquake. Slip rates calculated for the BHF …

Tectonic Denudation Of Mesozoic Contractile Structures By A Low-Angle Normal Fault And Associated Faults, Southern White Pine Range, Nevada, Holly Langrock

UNLV Theses, Dissertations, Professional Papers, and Capstones

The Blackrock Canyon area in the southern White Pine Range, Nevada mostly consists of the highly extended upper plate of a low-angle normal fault, the Blackrock fault. The post-31.3 Ma Blackrock fault places upper Paleozoic sedimentary rocks and overlying Tertiary volcanic rocks of the Garret Ranch Group in its hangingwall against a 50 degrees E-dipping homocline of Cambrian through Mississippian rocks in its footwall. The 15 to 30 degrees W-dipping Blackrock fault is non-planar and consists of two fault segments and a pronounced corrugation, the Bull Spring corrugation. These geometric irregularities suggest the slip direction on the fault was east-southeast …

Structural Analysis Of The Hurricane Fault In The Transition Zone Between The Basin And Range Province And The Colorado Plateau, Washington County, Utah, Meg E. Schramm

UNLV Theses, Dissertations, Professional Papers, and Capstones

This study defines fault segments and segment boundaries along the Hurricane fault in southwestern Utah and determines the geometric and kinematic relationship to other regional structures. Fault segment identification is critical for understanding fault processes and seismic risk; segment length is the maximum earthquake rupture length along a fault. Segment boundaries may act as barriers to earthquake propagation.

Normal fault segmentation only recently has received attention and has never been studied along the Hurricane fault. The fault changes strike along its length, and is thus a segmented fault. This study documents one nonconservative segment boundary and two fault segments, the …

The Geology And Structural Significance Of The Arch Mountain Area, Northern Black Mountains, Mohave County, Arizona, Edward Eschner

UNLV Theses, Dissertations, Professional Papers, and Capstones

The Arch Mountain area of northwestern Mohave County, Arizona, is typified by rocks that range from Precambrian to Quatemary in age. Arch mountain is a north-trending horst bounded on the west by the Petroglyph Wash graben and on the east by the Virgin Basin. A low-angle normal fault, herein named the Arch Mountain detachment fault, is exposed for 6 km along strike just below the ridge crest of Arch Mountain, and it is typified by a 2-20 cm thick zone of hematite-impregnated breccia and cataclasite. The detachment fault places an upper plate of Precambrian gneiss, Paleozoic quartzite, shale and dolomite, …