Geophysics and Seismology Commons^™

Role Of Forward Model In Surface-Wave Studies To Delineate A Buried High-Velocity Layer, Xiaohui Jin, Barbara Luke, Carlos Calderon-Macias

Civil and Environmental Engineering and Construction Faculty Research

Procedures are tested and compared for processing Rayleigh surface wave data to obtain one-dimensional shear wave velocity profiles for a hypothetical site that contains a buried high-velocity layer (HVL). The main purpose of such an investigation would be to discriminate and characterize the HVL. When target dispersion curves are derived from synthetic time histories, for the most part, the HVL is better identified when profiles are inverted using only the fundamental mode of Rayleigh wave propagation, rather than a more compatible but more complex forward model. The outcomes imply that in practice, a simple forward model might be more successful …

Interpreting Surface-Wave Data For A Site With Shallow Bedrock, Daniel W. Casto, Barbara Luke, Carlos Calderon-Macias, Ronald Kaufmann

Civil and Environmental Engineering and Construction Faculty Research

The inversion of dispersive Rayleigh-wave data has been shown to be successful in providing reliable estimated shear-wave velocities within unconsolidated materials in the near surface. However, in a case where the multi-channel analysis of surface waves method was applied to a site consisting of clay residuum overlying basalt bedrock, inversion for the fundamental-mode Rayleigh wave resulted in shear-wave velocities within the rock that are less than half of expected values. Forward modeling reveals that the fundamental-mode dispersion curve is hardly sensitive to bedrock velocity perturbations over a practical range of wavelengths, leading to poorly constrained solutions. Standard surface-wave methods can …

2nd Annual Undergraduate Research Conference Abstract Book, University Of Missouri--Rolla

Undergraduate Research Conference at Missouri S&T

No abstract provided.

Scientific And Engineering Studies Of Systems, Structures, And Components Important To Safety For A Potential Repository At Yucca Mountain, Nevada, Ian Buckle, E. Manos Maragakis

Publications (YM)

TASK 26: Upgrade of Earthquake Simulation Facilities in the Large-Scale Structures Laboratory at University of Nevada Reno The objective of this Task was to purchase, install and commission the equipment necessary to upgrade two existing shake tables in the Structures Laboratory at UNR, from uniaxial to biaxial motion. It was recognized that a parallel effort, funded by NSF and HUD, to add a third biaxial table with identical properties to the upgraded existing tables, would be undertaken at the same time.

The Study Of Wave-Blocking And Current Effects On Nonlinear Interactions Of Shallow-Water Waves Using Advanced Boussinesq Models, Qin Chen

Civil & Environmental Engineering Theses & Dissertations

The first part of this work focuses on the derivation of enhanced Boussinesq-type equations for the combined motion of waves and currents in shallow water areas.

The strategy proposed in this work is to couple two known methods which are the sponge layer concept suitable for short waves and Sommerfeld radiation condition for currents. This coupling method provides satisfactory non-reflective boundaries for the simulation of fully coupled wave/current motion as demonstrated by the numerical experiments. We verify the model against the well known solutions based on the existing theories and good agreement has been observed. The numerical results confirm the …

The Geology Of Maine's Coastline : A Handbook For Resource Planners, Developers, And Managers, Maine State Planning Office

Maine Collection

The Geology of Maine's Coastline : A Handbook for Resource Planners, Developers, and Managers

Executive Department, Maine State Planning Office, Augusta, Maine, June 1983.

Contents: List of Figures / Introduction: The Geological Connection / Chapter 1: Using the Marine Environments Maps / Chapter 2: Perspectives of the Maine Coast / Chapter 3: The Building Blocks of Maine's Coast / Chapter 4: The Disappearing Shoreline / Where to Go for Help / Some Planning Considerations for Development in Coastal Geologic Environments / Land Use Laws of Special Interest to Individual Coastal Property Owners

Effects Of Oxygen Content Of Admitted Gases In Sulfide Flotation, Brian J. Boyle

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Methods Of Studying The Effects Of Frothers, Frank L. Bazzanella

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Studies In Modulation Of Interfacial Reactions For Certain Sulphide Minerals, Robert Owen Beyaert

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Habit Modification Of Naclo3 With Nai, William A. Coghlan

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Production Of Standard-Grade Ferromanganese In An Electric Arc Furnace, Force F. Baney Jr.

Bachelors Theses and Reports, 1928 - 1970

The investigations conducted in this project were essentially concerned with the effects of various compositions of two different slag systems upon the increased recovery of manganese in a standard-grade ferromanganese.

Investigation Of The Ternary System Silver-Aluminum-Indium (Ag-Al-In), Elvin H. Beardslee

Bachelors Theses and Reports, 1928 - 1970

This thesis paper contains material pertaining to & preliminary investigation of the ternary system Ag-Al-In. Procedures in this preliminary investigation are discussed in detail.

Preliminary Examination Of The Aluminum Corner Of The Ternary System Aluminum-Silver-Indium (A1-Ag-In), Jerome J. Blake

Bachelors Theses and Reports, 1928 - 1970

In this paper the author attempts to lay the groundwork for future work on the Al-Ag-In system.

Increased Corrosion Of A 304 Stainless Steel Upon Bending, William C. Tiddy

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Identification Of Nonmetallic Inclusions In Armco Ingot Iron With Polarized Light, Frank E. Panisko

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

The Hydrometallurgy Of Uranium, John E. Cesarani

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Crystal Habit Modification Of Sodium Chlorate, Michael R. Keegan

Bachelors Theses and Reports, 1928 - 1970

All single crystals have a particular habit or morphology. The crystal habit refers to the relative degree of development of crystallographic planes into surfaces which make up the external appearance of the single crystal.

In this paper, NaClO3 is used as a parent crystal. Its simple cubic habit is modified to tetrahedral by the use of impurities of SO4=, S2O3=, Cr2O7=, and NO3-. The degree of habit change is studied as a function of impurity concentration and temperature. The problem and phenomena are explained in terms of surface chemistry and thermodynamics.

Physico-Chemical Principles Of Sixteenth Century Metallurgy, Robert E. Johnson

Bachelors Theses and Reports, 1928 - 1970

Following a review of sixteenth century metallurgical literature and a discussion of Gibbs free energy, this thesis discusses thermodynamic considerations of galena (PbS) reduction by iron from a lead assay of this period. The importance of fluxes in this assay is emphasized. The discussion covers both equilibrium and non-equilibrium conditions at 1100 degrees Celsius. Possible substitutes for iron are also covered.

Information from twenty-one small controlled lead assays is correlated with the thermodynamic discussion to determine the purpose of each constituent in the assay.

The Beneficiation Of Titaniferous-Magnetite Sands, Ronald Lloyd Nordwick

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation of beneficiation methods is to develop and study possible economic methods for recovering an iron-titanium concentrate of sufficient purity to meet metallurgical requirements for subsequent direct reduction to pig iron and a high titanium slag.

Stress-Corrosion Cracking Of Brass, Paul A. Fossey

Bachelors Theses and Reports, 1928 - 1970

the mechanism of stress-corrosion cracking of brass has been sought for many years. Investigators have proposed many mechanisms, but each of these mechanisms has always had several drawbacks. This paper presents an account of experimental work done in the laboratory on this subject and compares it to the work of previous investigations. It evaluates the mechanisms presented by investigators and shows the failures of these mechanisms. A theory of Nitrogen Embrittlement is presented and an evaluation of this theory with experimental work follows.

Experimental Arc Furnace Smelting Of Titaniferous Iron Sands From The Northern Oregon Coast, Allan P. Herring

Bachelors Theses and Reports, 1928 - 1970

This investigation is an attempt to experimentally smelt titaniferous iron sands from the Northern Oregon Coast in a laboratory arc furnace.

The Effect Of Ph Upon Chelation Reactions In Montmorillonite Clays, Joseph Michael Keane

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to investigate several chelation reactions and determine the effect of variable pH upon these reactions.

An Investigation Of The Sintering Of Iron-Wire Compacts, George L. Vivian

Bachelors Theses and Reports, 1928 - 1970

A study of the sintering of iron has been made by observing the rate of bonding of iron wires wound on iron spools. The specimens were sintered at a constant temperature of 850c in vacuum furnaces capable of producing pressures of 10-5 to 10-4 mm of mercury, and the growth of the bond between wires was observed as a function of time.

It has been concluded that the volume-diffusion mechanism is strongly operating in the sintering of iron at 850c, but in an evacuated system, the evaporation-condensation mechanism also contributes to the sintering process.

The Identification Of Montana Clays By X-Ray Analysis, David Stephen Malyevac

Bachelors Theses and Reports, 1928 - 1970

The purpose of this study is to identify the various Montana clay minerals by means of X-ray diffraction. The ultimate aim of this investigation is to identify the different clay mixtures through an analysis of their respective diffraction patterns, and diffraction patterns obtained after various chemical and thermal treatments.

The Design And Construction Of An Electrolytic Cell For Aluminum Reduction, Thomas H. Melrose

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation was to design and construct a laboratory size electrolytic cell in which to reduce alumina, using the same basic materials that are used in a commercial size cell. The cell was designed to have a capacity of approxi­mately 100 grams of metallic aluminum produced every 8 hours. The cell was constructed so it could be operated continuously.

Investigation Of Inclusions In Armco Ingot Iron, Edwin J. Duncan

Bachelors Theses and Reports, 1928 - 1970

Various chemical and electrolytic separation methods were investigated in an attempt to separate the in­clusions in Armco ingot iron. Residues obtained were X-rayed for identification purposes. The microstruc­tures of this iron were studied with the object of de­termining the relative sizes, locations, and possible compositions of the inclusions.

Effect Of Recovery On The Recrystallized Grain-Size Of High Purity Aluminum, Rodney L. Helterline

Bachelors Theses and Reports, 1928 - 1970

When a cold-worked metal is annealed, it’s physical properties hange as a result of a new grain structure. The annealing treatment is divided into three stages according to the changes that occur in the distorted metal: (1) recovery, (2) recrystallization, and (3) grain growth.

Polarography Of Indium, John Jackson

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to study the various aspects of the polarography of indium. The eventual goal would be to develop a method of analyzing indium in unknowns. The investigation is approached by studying the indium ions in various electrolytes and in various concentrations.

Geology Of The Ragged Point Oil Field Musselshell County, Montana, David M. Amos

Bachelors Theses and Reports, 1928 - 1970

The Ragged Point oil field is located in Northwest Musselshell County, in the Lake Basin field of central Mon­tana, and on the western border of the Great Plains region. The surface topography is that of a plain marked by erosion and moderate folding. The stratigraphy of central Montana shows periodic marine invasions from the Cordilleran trough, with normal marine limestones interbedded with sandstone sand shales. These sediments are over 12,000 feet thick, with the Creta­ceous Eagle and Colorado formations exposed at the surface on the Ragged Point anticline. Undifferentiated Cambrian lime­stones and shales are the oldest rocks encountered in drilling.

The Application Of Electric Energy To The Metallurgy Plants In Montana, Edwin J. Duncan

Bachelors Theses and Reports, 1928 - 1970

Since the year 1800, metallurgy has been affiliated with electricity. In fact, the two industries have grown side by side, being naturally dependent upon each other and having a parallel growth.