Polymer Chemistry Commons^™

Degumming Of Hemp Fibers Using Combined Microwave Energy And Deep Eutectic Solvent, Bulbul Ahmed

LSU Master's Theses

Hemp is considered as one of the sustainable agricultural fiber materials. Degumming or surface modification of hemp bast is needed to produce single fibers for ensuing textile and industrial applications. The traditional degumming process necessitates a high amount of alkali, which causes detrimental environmental pollution. This study offers a new method to degum hemp fibers with reduced use of harmful alkali and precious water resources. In this work, hemp bast fibers were degummed by using combined microwave energy and deep eutectic solvent (DES). The properties of hemp fibers manufactured by this method were investigated and compared with the traditional alkali …

A Conductivity Analysis Of A Newly Synthesized Poly(Ethylene Glycol) Methyl Ether Hydroxide Electrolyte, Sarah Marie Peterson

Honors Theses

This thesis investigates the synthesis and conductive properties of a Poly (ethylene glycol) methyl ether-based polymer electrolyte. The goal of the synthesis is to enhance the hydroxide ion conduction properties of the polymer with its cationic groups attached. The MePEG backbone contained seven ethylene glycol groups and was modified to substitute the hydroxide group in the MePEG with trimethylamine. In addition, the bromide added in the synthesis was exchanged for hydroxide ions to allow for the transportation of hydroxide ions in polymeric electrolytes that can be used in Anion Exchange Membrane Fuel Cells. The newly synthesized polymer was compared to …

Valorization Of Xylan In Agroforestry Waste Streams, Harrison Appiah

Graduate Theses, Dissertations, and Problem Reports

Valorization of Xylan in Agroforestry Waste Streams.

Harrison Appiah

Microwave-assisted deep eutectic solvent and gamma-valerolactone metallic chloride catalyzed conversion of xylan to furfural were investigated using a 2x3 factorial experimental design at two levels of percent microwave power, reaction time, and catalyst concentration. The levels of each factor studied were (20%, 60% microwave power, 2, 4 minutes, and 10, 20mg) respectively. The effect of three metallic chloride catalysts (LiCl, FeCl3.6H20, CuCl2) on the conversion of xylan to furfural was also investigated. The gamma-valerolactone-ferric chloride sent system exhibited the highest mean yield of furfural (56.50%). The next highest furfural yield of …