Pharmacology, Toxicology and Environmental Health Commons^™

On-Site Comparison Of The Osha 47, Asset Ez4-Nco, Iso-Chek, Dan, And Cip10 Methods For Measuring Methylene Diphenyl Diisocyanate (Mdi) At An Oriented-Strand Board (Osb) Factory, Simon Aubin, El Mekki Hamdi, Audrey Joly, Philippe Sarazin, Jacques Lesage, Livain Breau, Mark Spence, Sébastien Gagné

Études primaires

Diisocyanates are occupational contaminants and known sensitizers causing irritation (skin and respiratory tract) as well as occupational asthma. Because of their physicochemical properties (semi-volatile and high reactivity) and low occupational limits, diisocyanate exposure evaluation is still a challenge nowadays for industrial hygienists and laboratories. The objective of this study was to compare the methylene diphenyl diisocyanate (MDI) concentrations measured by five methods using different collection or derivatization approaches in an oriented-strand board (OSB) factory. The methods used were: OSHA 47 (filter, 1-(2-pyridyl)piperazine) (OSHA), Asset EZ4-NCO (denuder and filter, dibutylamine) (Asset), Iso-Chek (double-filter, 9-(N-methylaminomethyl) anthracene and 1,2-methoxyphenylpiperazine), DAN (filter, 1,8-diaminonaphthalene), and …

Performance Of Mechanical Filters Used In General Ventilation Against Nanoparticles, Clothilde Brochot, Pooya Abdolghader, Fariborz Haghighat, Ali Bahloul

Études primaires

With an equal mass, nanoparticles (NP) have a higher toxicity than particles with the same chemical composition but with larger surface area. However, the toxicological knowledge concerning NP is still insufficient to establish limit values of exposure. To seek the lowest exposure level, filtration is a simple and effective way to capture particles, including NP. According to ANSI/ASHRAE 52.2 standard, ventilation filters efficiency is tested for particles ranging from 0.3 to 10.0 μm. Performances of entire filters for NP are still very limited and particle size of 300 nm (0.3 μm) is commonly used as the most penetrating particle size …

Amélioration De La Justesse Des Modèles D’Hygiène Du Travail Utilisés Pour Estimer Des Expositions Professionnelles À Des Vapeurs De Solvants, Spéro Abattan, Stéphane Hallé, Daniel Drolet, Ali Bahloul, Patrick Eddy Ryan, Wejden Chouchene, Carlos Castro Ruiz, Jérôme Lavoué, Maximilien Debia

Rapports de recherche scientifique

Chaque année, des travailleurs québécois subissent des effets sur leur santé après avoir été exposés à des substances chimiques, notamment à des solvants. La modélisation des expositions professionnelles occupe une place importante dans la prévention des risques. Cette recherche vise à étudier différents aspects de la modélisation pour estimer des expositions professionnelles à des vapeurs de solvants dans le but d’en améliorer la justesse de prédiction. Le travail de recherche a été effectué en deux volets. Grâce à la mise en œuvre de tests à petite échelle (volet I) et à échelle humaine (volet II), les travaux présentés dans cette …

Réduire L’Exposition Des Travailleurs Aux Gaz, Odeurs, Poussières Et Agents Pathogènes Humains Présents Dans Les Bâtiments Porcins, Matthieu Girard, Caroline Duchaine, Stéphane Godbout, Ariane Lévesque, Valérie Létourneau, Stéphane P. Lemay

Rapports de recherche scientifique

Les éleveurs de porcs du Québec sont quotidiennement exposés à d’importantes quantités de gaz, d’odeurs, de poussières et de bioaérosols. Par conséquent, ils sont à risque de développer des problèmes respiratoires (ex. asthme) ainsi que des maladies infectieuses telles qu’une méningite à Streptococcus suis. Le risque de développer un problème de santé est lié au nombre d’heures passées à l’intérieur des bâtiments d’élevage ainsi qu’aux concentrations des différents contaminants. De plus, les travailleurs peuvent être en contact avec des bactéries résistantes aux antibiotiques soit des bactéries sélectionnées par l’emploi d’agents antimicrobiens utilisés lors de l’engraissement des animaux. Finalement, de …

Halogenated Flame Retardants And Organophosphate Esters In The Air Of Electronic Waste Recycling Facilities: Evidence Of High Concentrations And Multiple Exposures, Sabrina Gravel, Jérôme Lavoué, Bouchra Bakhiyi, Miriam L. Diamond, Liisa M. Jantunen, Jacques Lavoie, Brigitte Roberge, Marc-André Verner, Joseph Zayed, France Labrèche

Études primaires

Background

In response to a worldwide increase in production of electronic waste, the e-recycling industry is rapidly rowing. E-recycling workers are exposed to many potentially toxic contaminants, among which flame retardants (FRs), mainly suspected of being endocrine disruptors, are thought to be the most prevalent.

Objective

To conduct an exposure assessment of four chemical groups of FRs in Canadian e-recycling facilities, and to identify the main cofactors of exposure.

Methods

Personal air samples were collected over a workday for 85 workers in six e-recycling facilities, grouped into three facility sizes, and for 15 workers in control commercial waste facilities. Total …

Exposure To Polybrominated Diphenyl Ethers (Pbdes) In American And Canadian Workers: Biomonitoring Data From Two National Surveys, Sabrina Gravel, Jérôme Lavoué, France Labrèche

Études primaires

Polybrominated diphenyl ethers (PBDEs) are flame retardants commonly found in many household and industrial products. They can be detected in the serum of the general population, and in even higher concentrations in workers of certain industries, due to an additional occupational exposure. The purpose of this analysis is to determine background exposure levels of PBDEs in the general working population, using national surveys where working status was self-reported. Participants aged 20–65 were selected from the 2003–2004 U.S. National Health and Nutrition Examination Survey (n = 1141) and the 2007–2009 Canadian Health Measures Survey (n = 1337). Only four congeners were …

Activation Des Éosinophiles Humains Par Des Nanoparticules, Denis Girard, Maxime Marion-Murphy

Rapports de recherche scientifique

L’économie du Canada, comme celle de bien d’autres pays industrialisés, bénéficie du développement des nanotechnologies dont le fort potentiel peut être exploité dans plusieurs secteurs industriels. Un nombre croissant d’entreprises québécoises de production de nanoparticules (NP) est d’ailleurs déjà implanté et tout porte à croire que d’autres emboîteront le pas dans les années à venir. Ce faisant, non seulement le nombre de travailleurs œuvrant dans la fabrication et la synthèse des NP augmentera sensiblement, mais également le nombre de ceux qui seront appelés à en manipuler et à en transformer dans les domaines des nanotechnologies en général. Une des conséquences …

Identification Of Methylene Diphenyl Diisocyanate Thermal Degradation Products In A Generation Chamber By Liquid Chromatography Coupled With Tandem Mass Spectrometry, Sébastien Gagné, Yves Cloutier

Études primaires

Isocyanate thermal degradation characterization by liquid chromatography coupled with electrospray tandem mass spectrometry has been performed to elucidate the methylene diphenyl diisocyanate (MDI) thermal degradation structure emitted in a generation chamber using a temperature between 50°C and 180°C to produce MDI vapors. [M+H]⁺ ions containing an isocyanate functional group were studied by tandem mass spectrometry. The [M+H]⁺ ion analyses based on the combination of full scans and precursor ion scans were useful for identifying all structures. The compounds emitted were identified and validated as a mixture of compounds containing amine and isocyanate functions. Residual MDI, methylene diphenyl amino-isocyanate, …

Implementation And Evaluation Of An Analytical Method For A Novel Derivatizing Agent To Measure 4,4'-Methylene Diphenyl Diisocyanate Atmospheres, Silvia Puscasu, Simon Aubin, Mark Spence, Sébastien Gagné

Études primaires

Accurate measurement of 4,4'-methylene diphenyl diisocyanate (MDI) atmospheres is a challenge since the molecule is both chemically reactive and likely to be present in aerosol form when heated and sprayed because of its low vapor pressure. Meeting this challenge requires optimizing both the sampling device used and the derivatization agent employed to stabilize the isocyanate functional group. This study describes the use of a novel derivatization reagent for isocyanate sampling to address the challenge of MDI aerosol exposure sampling. Like most conventional derivatizing agents for isocyanates, 1,8-diaminonapthalene (DAN) reacts with isocyanate functional groups to form a urea. However, unlike other …

Cip10 Optimization For 4,4-Methylene Diphenyl Diisocyanate Aerosol Sampling And Field Comparison With Impinger Method, Silvia Puscasu, Simon Aubin, Yves Cloutier, Philippe Sarazin, Huu Van Tra, Sébastien Gagné

Études primaires

4,4-methylene diphenyl diisocyanate (MDI) aerosol exposure evaluation in spray foam insulation application is known as being a challenge because the spray foam application actually involves a fast-curing process. Available techniques are either not user-friendly or are inaccurate or not validated for this application. To address these issues, a new approach using a CIP10M was developed to appropriately collect MDI aerosol in spray foam insulation while being suitable for personal sampling. The CIP10M is a commercially available personal aerosol sampler that has been validated for the collection of microbial spores into a liquid medium. Tributylphosphate with 1-(2-methoxyphenyl)piperazine (MOPIP) was introduced into …

Comparison Between The Asset Ez4 Nco And Impinger Sampling Devices For Aerosol Sampling Of 4,4′-Methylene Diphenyl Diisocyanate In Spray Foam Application, Silvia Puscasu, Simon Aubin, Yves Cloutier, Philippe Sarazin, Huu Van Tra, Sébastien Gagné

Études primaires

4,4′-methylene diphenyl diisocyanate (MDI) aerosol exposure evaluation in spray foam insulation application is known to be a challenge. Current available techniques are either not user-friendly or are inaccurate or are not validated for this application. A new sampler has recently been developed to address the user-friendliness issues with other samplers: the ASSET EZ4-NCO, but the use of this sampler in spray foam insulation applications has not been demonstrated or validated. Because of this, the current work was undertaken to provide a comparison of the ASSET sampler with an impinger method, considered to be the best available method in the context …

Acquisition De Modèles Pour L’Étude De L’Absorption Percutanée Des Substances Chimiques : Cellules De Diffusion À Flux Continu, Claude Viau, Suzanne Leroux, Ross Thuot, Sophie Lim

Rapports de recherche scientifique

Dans les milieux de travail où des substances chimiques sont utilisées, celles-ci peuvent se retrouver dans l’air. Les employés peuvent donc y être exposés par le fait de la respiration. C’est d’ailleurs pour ça que le règlement sur la santé et la sécurité du travail donne des valeurs limites d’exposition dans l’air pour près de 700 substances chimiques. Mais il est aussi possible d’être exposé par le contact des substances avec la peau. Quand on veut savoir à quel point un travailleur peut absorber des substances dans son organisme de cette manière, on doit savoir trois choses principales :

• la …