Mining Engineering Commons^™

Physical Property Measurement Of Surfactant Coupled With Nanoparticles For Enhanced Oil Recovery, Phoo Pwint Nandar

Chulalongkorn University Theses and Dissertations (Chula ETD)

The residual oil remained in the reservoir after the primary recovery and water flooding can either be produced by increasing the mobility of the oil or by altering the reservoir rock wetting behavior and diminishing the oil water interfacial tension. The surfactant flooding is one of the chemical enhanced oil recovery methods. At the optimal concentration, the surfactant flooding can provide the low interfacial tension favoring to the enhanced oil recovery. In contrast, the loss of the surfactant at the solid-liquid interface due to an adsorption lessens the amount of the surfactant required for oil displacement during the flooding. Therefore, …

Effect Of Salinity Contrast Between Formation Water And Injected Low Salinity Water On Low Salinity Waterflooding In Shaly-Sandstone Formation, Sarun Phuenghansaporn

Chulalongkorn University Theses and Dissertations (Chula ETD)

Low salinity waterflooding is an improving oil recovery technique that is highly mentioned nowadays as it is cost-efficient and environmentally friendly. The technique involves injecting water with lower salinity compared to formation salinity to shift the surface equilibrium toward the liberation of oil from the rock surface. Nevertheless, successful of this technique depends on many parameters especially the presence of clays. Several types of clays can be found in oil reservoirs, and they may react to different cations in inject low salinity in different ways, resulting in different magnitudes of oil recovery. Moreover, the contrast of salinity between formation water …

Pore Pressure Prediction Using Combination Drilling Efficiency And Hydro-Mechanical Specific Energy Methods, Munawir Arge Pratama Otolomo

Chulalongkorn University Theses and Dissertations (Chula ETD)

Several methods of pore pressure prediction using drilling parameters were introduced and improved to meet the challenges of accurate prediction at a relatively low cost. Knowledge of pore pressure is essential for safe well planning, cost-effective drilling, and operational decision-making. Conventional methods in pore pressure prediction using drilling parameters have limitations on its application of making the normal compaction trendline that is only applicable in clean shale intervals. In this work, the concept of drilling efficiency (DE) and hydro-mechanical specific energy (HMSE) for predicting formation pore pressure is proposed. This method, termed DE-HMSE, is based on the theory that the …

Depression Of Pyrite In Polymetallic Sulfide Flotation Using Chitosan-Grafted-Polyacrylamide Polymers, Keitumetse Cathrine Monyake

Doctoral Dissertations

“In this work, Chitosan-grafted-Polyacrylamides (Chi-g-PAMs) were studied, for the first time, as selective depressants of pyrite in the flotation of base metal sulfides. Fundamental studies of the adsorption behavior of Chi-g-PAM on model sulfide minerals indicated that Chi-g-PAM was more selective to pyrite’s surfaces as compared to base metal sulfides. Results suggested that the adsorption of Chi-g-PAM at pyrite-water interface was a chemisorption in nature which involved the amine, amide, and hydroxyl groups of Chi-g-PAM. Batch flotation studies of complex sulfide ore of Mississippi Valley Type (MVT) showed that Chi-g-PAM outperformed other pyrite’s depressants at producing less pyrite-diluted concentrates. Statistical …

Development Of An Entry-Scale Modeling Methodology To Provide Ground Reaction Curves For Longwall Gateroad Support Evaluation, Haochen Zhao

Graduate Theses, Dissertations, and Problem Reports (ETD)

Longwall gateroad entries are generally subjected to severe mining-induced stress changes and deformations; they are prone to large roof falls, floor heaves, and rib sloughing. The standing support system in underground mines needs to be carefully designed to compensate for the mining-induced deformation of the surrounding rock mass and consecutively protect the integrity of gateroad entries. Local geology, together with mining-induced stress redistribution, influences the ground response and plays a major role in the performance of a standing support design. In the US, Support Technology Optimization Program (STOP) and its Ground Reaction Curve (GRC) design criteria have been applied to …

Integrated Large Discontinuity Factor, Lamodel And Stability Mapping Approach For Stone Mine Pillar Stability, Mustafa Baris Ates

Graduate Theses, Dissertations, and Problem Reports (ETD)

The objective of this research is to develop a software tool that integrates the large discontinuity factor (LDF) and the Boundary Element Method software (BEM), LaModel, to allow stone mine operators to assess the impact of the large discontinuities on local pillar stability. National Institute for Occupational Safety and Health (NIOSH) published design guidelines for underground stone mines to guide the industry in designing pillar and roof support. These guidelines emphasize the impact of large, angular discontinuities on pillar strength. Esterhuizen et al. (2011) derived the large discontinuity factor (LDF) to account for the impact of discontinuities on pillar stability …

Investigation Of Geomechanical Behavior Of Laminated Rock Mass Through Experimental And Numerical Approach, Qingwen Shi

Graduate Theses, Dissertations, and Problem Reports (ETD)

Roof failure in the Appalachian underground coal fields occurs often in laminated shale. Laminated shale roof in coal mines fails in unique ways, such as cutter failure or delamination failure. Extensive studies have investigated the influential factors that cause laminated roof failure, which include in-situ stress, entry layout, roof span, and roof support. However, cutter failure continues to occur frequently and erratically. This is due to the lack of in-depth understanding of the inherent properties of the laminations, such as bedding plane strength, matrix strength, and bedding plane spacing, which in turn influence the geomechanical behavior of the laminated rock. …

Noise Exposure Trends Among Violating Coal Mines, 2000 To 2021, Hanna Grace Davis

Graduate Theses, Dissertations, and Problem Reports (ETD)

Noise-induced hearing loss has continued to be a significant issue within the mining industry, even after the passing of the MSHA’s improved noise standard in 2000. NIOSH has recognized that the noise standard enacted by both MSHA and OSHA does not properly protect workers with the 5 dBA exchange rate (i.e., the increase in noise level leading to a doubling of energy) and the lack of emphasizing the use of engineering controls over administrative controls and overreliance on hearing protection device usage. The primary objective of this study is to investigate statistical sound relationships between MSHA noise-related violations and samples …

Calcite Depression In Bastnaesite-Calcite Flotation System Using Organic Acids, Emmy Muhoza

Graduate Theses, Dissertations, and Problem Reports (ETD)

Bastnaesite is the primary source of light REEs, namely cerium (Ce), lanthanum (La), praseodymium (Pr), neodymium (Nd), to name a few. Bastnaesite is typically concentrated using the froth flotation beneficiation method. Flotation of bastnaesite suffers from high reagent consumption due to the similar surface characteristics of bastnaesite and associated gangue minerals, including calcite. Additionally, complex stages of high-temperature conditioning are often required to suppress the detrimental impact of dissolved calcium ions on the flotation of bastnaesite. This research seeks to investigate the capabilities of organic acids in the bastnaesite-calcite flotation systems to selectively depress calcite minerals and effectively chelate calcium …

Experimental And Theoretical Investigation On The Initiation Mechanism Of Low-Rank Coal's Self-Heating Process, Yinan Zhang

Graduate Theses, Dissertations, and Problem Reports (ETD)

Coal spontaneous combustion remains a safety concern during coal mining, transportation, and storage and requires further investigation to develop effective prevention and control strategies. While various intrinsic and extrinsic conditions may influence coal self-heating, low-rank coals are more prone to spontaneous combustion, especially in humid climates. Therefore, quantifying the effect of extrinsic moisture on the self-heating of low-rank coals is critical for understanding the high propensity of low-rank coals for spontaneous combustion. Many studies have qualitatively evaluated the role of extrinsic moisture on the coal self-heating. Despite this, few studies have quantified the contribution of extrinsic moisture on wetting and …

Static Liquefaction In Tailing Dams, Jose Raul Zela Concha

Graduate Theses, Dissertations, and Problem Reports (ETD)

The Fundao tailing dam in Brazil failed on November 5, 2015 causing loss in life, property and severe damage to the environment. The waste flow traveled at 11m/s and approximately 32 million m³ tailings was released into the downstream area. Investigations by regulators concluded that a series of poor designs and construction of the tailing were the causes of the failure. Further investigations also showed that surface failure occurred in the mid height of the slope with a safety factor of 0.52. Both investigations concluded that static liquefaction induced the failure of tailings dam. However, geology variation in the …

Size Effect And Anisotropy On The Strength Of Shale Under Compressive Stress Conditions, Yun Zhao

Graduate Theses, Dissertations, and Problem Reports (ETD)

The underground coal mines in the Appalachian region report the highest rate of roof falls in the United States. The immediate roof of these mines is mostly composed of shale. The in-situ strength of shale is necessary for designing roof support to prevent roof falls. Estimating the in-situ strength of shale requires the knowledge of both size effect and anisotropy. This research used literature review, theoretical analysis, numerical modeling, and laboratory experiment to systematically investigate the size effect and anisotropy of shale strength under compressive strength conditions.

Literature review involved a comprehensive summary of previous research on the size effect …