Mining Engineering Commons^™

Evaluation Of Overpressure Wave Transition By Airblast Overpressure And Shock Wave Attenuation Analysis Using A Small Black Powder Charge, William R. Weitzel

Theses and Dissertations--Mining Engineering

Eight flush mount pressure sensors were used in a series of 3 test sequences to measure air overpressure produced by a firecracker. Overpressure was recorded at a range of 1 inch to 21 inches away from detonation, and charge weight was determined to be 0.1mg of black powder. Air overpressure prediction equations were developed from test series then compared to collected data for subsequent tests. Overpressure wave velocity was measured using wave arrival time and distance between sensors. This wave velocity was compared to calculated wave velocity using overpressure and ideal gas law. Overpressure and wave velocity are directly related …

Predicting The Dynamic Behavior Of Coal Mine Tailings Using State-Of-Practice Geotechnical Field Methods, Ali Salehian

Theses and Dissertations--Civil Engineering

This study is focused on developing a method to predict the dynamic behavior of mine tailings dams under earthquake loading. Tailings dams are a by-product of coal mining and processing activities. Mine tailings impoundments are prone to instability and failure under seismic loading as a result of the mechanical behavior of the tailings. Due to the existence of potential seismic sources in close proximity to the coal mining regions in the United States, it is necessary to assess the post-earthquake stability of these tailings dams.

To develop the aforementioned methodology, 34 cyclic triaxial tests along with vane shear tests were …

Development Of 15 Psi Safe Haven Polycarbonate Walls For Use In Underground Coal Mines, Rex Allen Meyr Jr.

Theses and Dissertations--Mining Engineering

Following three major mining accidents in 2006, the MINER Act of 2006 was enacted by MSHA and required every underground coal mine to install refuge alternatives to help prevent future fatalities of trapped miners in the event of a disaster. The following research was performed in response to NIOSH’s call for the investigation into new refuge alternatives. A 15 psi safe haven polycarbonate wall for use in underground coal mines was designed and modeled using finite element modeling in ANSYS Explicit Dynamics. The successful design was tested multiple times in both half-scale and small scale using a high explosive shock …

Experimental Comparison Study Of The Response Of Polycarbonate And Laminated Glass Blast Resistant Glazing Systems To Blast Loading, Joshua Calnan

Theses and Dissertations--Mining Engineering

This thesis recounts the experimental study of the dynamic response of polycarbonate blast resistant glazing systems to explosive loading through the use of triaxial load cells, pressure sensors, and a laser displacement gauge. This instrumentation captured the response of the glazing systems to blast loading over three phases of testing. The first phase of testing characterizes the load distribution around the perimeter and the second phase examines the repeatability of the results. The final phase of testing pushes the samples to failure. The results are then compared to HazL, a commonly used blast resistant glazing system analysis software tool. The …

Modeling Of An Air-Based Density Separator, Tathagata Ghosh

Theses and Dissertations--Mining Engineering

There is a lack of fundamental studies by means of state of the art numerical and scale modeling techniques scrutinizing the theoretical and technical aspect of air table separators as well as means to comprehend and improve the efficiency of the process. The dissertation details the development of a workable empirical model, a numerical model and a scale model to demonstrate the use of a laboratory air table unit.

The modern air-based density separator achieves effective density-based separation for particle sizes greater than 6 mm. Parametric studies with the laboratory scale unit using low rank coal have demonstrated the applicability …

A Framework For Understanding The Public's Perspectives Of Mining Applied To The Kentucky Coal Industry, Joshua M. Hoffman

Theses and Dissertations--Mining Engineering

People’s perceptions of mining are heavily based on the media they consume and the messages therein. News outlets ordinarily report on mining only when there is an accident or environmental concern. When messages that the public is exposed to are negative, it is no wonder that there are negative perceptions about mining.

Current public relations campaigns on the behalf of specific companies or select sectors do exist; however, this is often a reactionary move in response to recent shifts in the socio-political environment. The details of these campaigns are often tied up in proprietary information or withheld by public relations …

Characterizing The Variability In Respirable Dust Exposure Using Johnson Transformation And Re-Examining 2010 Proposed Changes To The U.S. Underground Coal Mine Dust Standard, Al I. Khan

Theses and Dissertations--Mining Engineering

Coal workers’ pneumoconiosis (CWP), commonly referred to as black lung, is a chronic lung disease that results from the inhalation and deposition of coal dust in the lungs. While this disease continues to afflict coal miners, its prevalence has steadily declined over three decades since 1970. Based on a voluntary X-ray surveillance program, conducted by the National Institute for Occupational Safety and Health (NIOSH), this downward trend, however, ended in 2000 and has actually begun to rise. The Mine Safety and Health Administration (MSHA) instituted a Comprehensive Initiative to “End Black Lung” to combat the reported upturn in black …

Cavitation Nanobubble Enhanced Flotation Process For More Efficient Coal Recovery, Ahmed S. Sayed Ahmed

Theses and Dissertations--Mining Engineering

Froth flotation is a widely used, cost effective particle separation process. However, its high performance is limited to a narrow particle size range, e.g., between 50 µm and 600 µm for coal and between 10 µm and 100 µm for minerals. Outside this range, the efficiency of froth flotation decreases significantly, especially for difficult-to-float particles of weak hydrophobicity (e.g., oxidized coal).

Nanobubbles integrated into a specially designed column flotation expanded the particle size range for efficient froth flotation as a result of increased probabilities of particle- bubble collision and attachment and reduced probability of detachment.

The major advantages of nanobubble …

Froth Flotation Performance Enhancement By Feed Cavitation And Magnetic Plastic Particle Addition, Mehmet Saracoglu

Theses and Dissertations--Mining Engineering

Froth flotation is the most commonly used process to recover and upgrade the portion of the coal preparation plant feed that has a particle size smaller than 150 microns. Problems that occur when employing froth flotation in the coal industry include i) coal surfaces that are weakly-to-moderately hydrophobic, and ii) flotation systems that are overloaded and limited by insufficient retention time.

Research was performed to evaluate techniques that could be implemented to improve flotation performance under the aforementioned scenarios. Pre-aeration of flotation feed using a cavitation system was extensively evaluated in laboratory and full-scale test programs. The benefits of adding …

Enhanced Phosphate Flotation Using Novel Depressants, Lingyu Zhang

Theses and Dissertations--Mining Engineering

Froth flotation is the most efficient method for phosphate separation, which is a physic-chemical separation process based on the difference of surface properties between the valuable minerals and unwanted gangue minerals. However, the presence of clay slimes in the slurry after grinding consumes a large amount of reagents, decreases the collision probability between bubbles and minerals, prevents phosphate particle attachment to air bubbles, and thus considerably reduces flotation recovery and concentrate grade. Georgia Pacific Chemical, LLC has recently developed novel depressants, i.e., clay binders, which are a series of low molecular weight specialty polymers to help improve phosphate flotation performance …

Investigating Planer Propagation Of A Shockwave In A Shock Tunnel, John Rathbun, Dave Mclane

Kaleidoscope

No abstract provided.

Geometric Variables Shock-Tunnel Configurations And Their Effects On Pressure-Time Waveforms, Chase W. Guengerich, Mark A. Faulhaber

Kaleidoscope

No abstract provided.

Collectors For Enabling Flotation Of Oxidized Coal, Raghav M. Dube

Theses and Dissertations--Mining Engineering

The coalburg seam coal is an example of difficult to float bituminous coal. Laboratory tests conducted on coalburg flotation feed sample revealed recovery values around 28% with 15% product ash when using fuel oil as collector under natural pH conditions. A detailed study showed that increasing pH from natural value of 5.6 to 7.5 provided a significant improvement in recovery of approximately 32 absolute percentage points. The improvement is believed to be result of the release of humic acids from the surface and the dispersion of clay particles thereby leaving a more hydrophobic surface.

Based on the tests conducted with …

Automated System To Improve Levelness Of Reconstructed Soil, Venkata Srikiran Bodapati, Larry G. Wells

Biosystems and Agricultural Engineering Faculty Publications

Extraction of coal, ores, and minerals from the earth by surface mining has occurred for many years and has always presented a significant challenge with regard to restoration of productive soil to mined areas. Federal and state regulations require that land should be returned to pre-mine productivity or reclaimed as per specific standards following mining. Excessive compaction of reconstructed soil caused by traffic of heavy earth moving equipment has been an enduring challenge regarding successful restoration of soil. A mechanical system was previously designed and developed to reconstruct soil to a depth of 1.22 m (48 in.) while completely avoiding …

Development Of Strategies To Minimize The Release Of Trace Elements From Coal Waste Sources, Mohammad Rezaee

Theses and Dissertations--Mining Engineering

To assess strategies aimed at minimizing the release of trace elements and the impact of disposal of coal waste materials on the environment, two long-term leaching experiments of up to five months duration were performed using waste materials from two plants cleaning high and low sulfur bituminous coal. The tests evaluated the mobility of major trace elements under different disposal scenarios: (i) a static leaching test designed to simulate the quiescent conditions encountered by coal waste material stored under water in a stable impoundment, and (ii) a dynamic test to simulate waste materials exposed to the atmosphere, either in variable …

Shock-Tunnel Waveform Analysis, Dave Mclane, John Rathbun

Kaleidoscope

No abstract provided.

Evaluation Of A Mechanical System For Reconstructing Soil On Surface Mined Land, John P. Fulton, Larry G. Wells

Biosystems and Agricultural Engineering Faculty Publications

The existence of excessive soil compaction has hindered the surface mining industry from returning land to pre−mining productivity after reclamation, especially on prime farmland soils. Heavy earthmoving equipment used during reclamation tends to generate root−limiting bulk densities that adversely affect plant growth thereby decreasing yields. Therefore, the purpose of this study was to evaluate a mechanism, called the ‘Soil Regenerator,’ which reconstructs soil media at minimum bulk density during surface mine reclamation. The prototype soil forming mechanism was mounted on the front of a conventional bulldozer. Soil was placed in long narrow windrows by a scraper or bulldozer. As the …

A Mechanical System For Soil Reconstruction, John Patrick Fulton, Larry G. Wells, Timothy D. Smith

Biosystems and Agricultural Engineering Faculty Publications

One of the most perplexing problems associated with reclaiming surface–mined lands is excessive compaction of soil due to the heavy earthmoving equipment used during the reclamation process. Over the years, some innovative material handling schemes have been devised to limit vehicle traffic during reclamation on reconstructed soil. However, final grading operations can often create root–limiting bulk densities, which affect plant growth and yield. The purpose of this article is to describe a mechanism designed at the University of Kentucky whereby mine soil can be reconstructed without introducing compaction caused by surface traffic in order for the soil to sustain desirable …

Infiltration Through Reconstructed Surface Mined Spoils And Soils, A. D. Ward, Larry G. Wells, R. E. Phillips

Biosystems and Agricultural Engineering Faculty Publications

An extensive series of tests involving reconstructed profiles of spoil and topsoil material from a Western Kentucky surface mine site was conducted with a laboratory infiltrometer system. Infiltration through the reconstructed spoil profiles was very slow despite the coarse nature of the material. Low infiltration rates could be attributed to the material having a well-graded texture and to the high densities of the profiles. Infiltration through topsoil horizons was controlled, for the most part, by conditions at the surface. Following wetting, infiltration rates were primarily controlled by the hydraulic characteristics of the less permeable sub horizon of the spoil material. …