Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Manufacturing
A High-Pressure Shear Testing Approach To Measure Flow Stresses Near A Friction Stir Welding Tool, David Prymak, Michael Miles, Tracy W. Nelson, Fredrick Michael
A High-Pressure Shear Testing Approach To Measure Flow Stresses Near A Friction Stir Welding Tool, David Prymak, Michael Miles, Tracy W. Nelson, Fredrick Michael
Faculty Publications
A new approach for measuring flow stresses near a spinning friction stir welding (FSW) tool is evaluated on AA 6061-T6 plate. The test consists of plunging a cylindrical tool with a flat face into the plate at different rotational speeds, using a variety of constant vertical loads. A viscosity-based model of the shear layer created under the tool is employed to estimate local flow stresses. The flow stresses measured by this approach exhibited an inverse relationship with temperature and a positive dependence on the pressure imposed by the spinning flat-faced tool. Compared to hot compression and hot torsion results, estimated …
Vacuum Infusion Of Composites: Durability Of Hybrid Large Area Additive Tooling For Vacuum Infusion Of Composites, Nathan Northrup, Jason Weaver, Andy R. George
Vacuum Infusion Of Composites: Durability Of Hybrid Large Area Additive Tooling For Vacuum Infusion Of Composites, Nathan Northrup, Jason Weaver, Andy R. George
Faculty Publications
The durability of a hybrid large area additively manufactured fiberglass ABS mold for vacuum infusion of composites was evaluated. The validation was done by designing and fabricating a mold for a custom test artifact and analyzing the surface geometry over the course of multiple infusions until tool failure. After printing and machining, the mold required a sealer to maintain vacuum integrity. The mold was able to produce 10 parts successfully before the sealed tool surface began to tangibly roughen, resulting in increased difficulty of demolding and a rougher surface finish. After the 14th infusion, the part required destructive force to …