Energy Systems Commons^™

Modeling And Design Algorithms For Electromagnetic Pumps, Daniel P. Cook

Reactor Campaign (TRP)

Electromagnetic (EM) induction pumps are used in a number of nuclear energy related applications, such as circulation of molten lead-bismuth eutectic alloys in neutron targets, and circulation of liquid sodium metal in Gen IV Sodium-cooled Fast Reactors (SFR). Because EM pumps have no moving parts which can fail, they are considerably more reliable than conventional mechanical pumps for molten metal usage, and thus EM pumps are favored over mechanical pumps even though their pumping efficiency is lower and their initial cost is higher when compared to mechanical pumps of similar flow rates.

The research objectives of this task are:

• A …

Thermal Transient Flow Rate Sensor For High Temperature Liquid Metal Cooled Nuclear Reactor, Yingtao Jiang

Reactor Campaign (TRP)

In nuclear power plants and accelerator driven system (ADS) for nuclear waste treatment, it is important to monitor the coolant flow rate in the reactor core and pipe-line. In such a strong irradiation, high pressure and temperature environment, no accurate local flow measurement technique is readily available. Electromagnetic (EM) flow meter is popular in low temperature application as it is a non-intrusive technology. However, additional voltage will be produced due to temperature, flow, pressure, the chemical properties of the liquid metal and surface condition of the steel walls. In addition, the non-definite wetting behavior of liquid lead-bismuth to the electrically …

Windmill Documentary, Timothy David Stoltenburg

Honors Capstones

Capstone submitted as a graduation requirement for the BSU Honors Program.

Energy Efficient Process Heating: Managing Air Flow, Kevin Carpenter, J. Kelly Kissock

Mechanical and Aerospace Engineering Faculty Publications

Much energy is lost through excess air flow in and out of process heating equipment. Energy saving opportunities from managing air flow include minimizing combustion air, preheating combustion air, minimizing ventilation air, and reconfiguring openings to reduce leakage.

This paper identifies these opportunities and presents methods to quantify potential energy savings from implementing these energy-savings measures. Case study examples are used to demonstrate the methods and the potential energy savings.The method for calculating savings from minimizing combustion air accounts for improvement in efficiency from increased combustion temperature and decreased combustion gas mass flow rate.

The method for calculating savings from …

Magnetohydrodynamic Simulation Of Electromagnetic Pump In Tc-1, Lillian J. Ratliff

Reactor Campaign (TRP)

The pilot molten lead-bismuth target circuit (TC-1) in university of Nevada Las Vegas (UNLV) was designed for beam power of 1 MW accelerator driven system (ADS). The TC-1 is a liquid lead-bismuth eutectic (LBE) circulation loop. Circulation of the liquid alloy is driven by an annular linear induction pump (ALIP). Experimental measurements of system parameters have yielded a surprisingly low pump efficiency of less than 1%. A numerical study of the pump efficiency is being conducted to determine which operational parameters are responsible for this low efficiency and to give insight into future EM pump design. The numerical study will …

Quantifying Savings From Improved Boiler Operation, Kevin Carpenter, J. Kelly Kissock

Mechanical and Aerospace Engineering Faculty Publications

On/off operation and excess combustion air reduce boiler energy efficiency. This paper presents methods to quantify energy savings from switching to modulation control mode and reducing excess air in natural gas fired boilers.

The methods include calculation of combustion temperature, calculation of the relationship between internal convection coefficient and gas flow rate, and calculation of overall heat transfer assuming a parallel-flow heat exchanger model. The method for estimating savings from changing from on/off to modulation control accounts for purge and drift losses through the boiler and the improved heat transfer within the boiler due to the reduced combustion gas flow …

Optimisation Of Heat Transfer And Fluid Flow In The Cooling Of Building Integrated Photovoltaic Facades., Eoin Patrick Hodge

Theses

The aim of this research was to explore the effects of mature and developing technologies from aeronautical industries such as impingement and film cooling, and electronic cooling techniques, in the setting up of different laminar and turbulent flow regimes on PV cooling duct heat transfer rates, with air flow as that brought about with natural buoyancy effects in a vertical building facade. The problem of efficiency losses in PV panels, due to overheating, is one of the factors restricting the development and use of this renewable power source. PV panels can experience very high temperatures, due to the heat input …

Estimating Energy Savings In Compressed Air Systems, Chris Schmidt, J. Kelly Kissock

Mechanical and Aerospace Engineering Faculty Publications

Compressed air is typically one of the most expensive utilities in an industrial facility. As a result, potential savings opportunities are aggressively sought out and identified. Once identified, projected energy savings must be calculated in order to justify the cost of implementing the savings opportunity. It is important to calculate projected energy and cost savings as accurately as possible. Unfortunately, savings are frequently overestimated because the methods used to estimate savings neglect to consider important factors such as compressor control and type, storage, and multiple compressor operation.

In this paper, a methodology is presented for modeling air compressor performance and …

Using Satellite Imagery To Evaluate The Impact Of Urban Forest On Summertime Residential Electricity Consumption In Terre Haute, Indiana, Usa, James R. Boulton

All-Inclusive List of Electronic Theses and Dissertations

Urban areas are horne to a large portion of the population of the United States and also a significant portion ofthe nation's forest resource. This urban forest contributes to the richness of the urban lifestyle in many ways, including aesthetic improvements, cleaning and protecting air, land, and water resources, and reducing the urban heat island effect. This thesis studies the degree to which energy reduction attributable to the urban forest can be determined using remotely sensed data. Results showed a slight inverse relationship between urban forest density and energy usage, meaning that as the density of trees increases there is …

Report Of The State Nuclear Safety Advisor Submitted To The Governor And 120th Legislature As Of January 15, 2001, Paula M. Craighead

Maine Collection

Report of the State Nuclear Safety Advisor submitted to the Governor and 120th Legislature As of January 15, 2001

Paula M. Craighead, State Nuclear Safety Advisor, Executive Department, Maine State Planning Office, Augusta, Maine, 2001.

Contents: Introduction and Executive Summary / I. Maine Yankee Decommissioning / II. Portsmouth Naval Shipyard (PNS) / III. Low-Level Radioactive Waste (LLRW) / IV. High Level Radioactive Waste / V. Transport Routes and Safety Response / VI. Shipments / VII. Status of Federal and State Legal and Administrative Proceedings / References and Resources / Glossary

Chp And Energy Conservation, Jim Mcgovern

Articles

The principles of the use of 'combined heat and power' (CHP) for the achievement of fuel energy conservation, minimisation of environmental impact and economic advantage are explained. A distinction is made between the two types of outputs: heat and work. It is argued that an efficiency value that is defined as the sum of the heat and work outputs divided by the energy of the fuel used is not very meaningful. An alternative, rational, efficiency is explained. It is concluded that CHP is an option to be considered where both heating and power are required, but is not a general …

Coke Oven Emissions: A Case Study Of Technology-Based Regulation, John D. Graham, David R. Holtgrave

RISK: Health, Safety & Environment (1990-2002)

After examining and analyzing the experience with coke ovens, the authors conclude that attempts to force technology beyond its demonstrated competence can be both expensive and ineffective in controlling hazards. They also suggest implications for pending proposals to further control air pollution.

Feasibility Study Of Maine's Small Hydropower Potential, James D. Sysko

Maine Collection

Feasibility Study of Maine's Small Hydropower Potential

Prepared by James D. Sysko, Small Hydro East, for the Maine State Planning Office, Maine Office of Energy Resources, January 1989.

"This study focuses on finding potential hydropower sites of approximately 50 kw to 1000 kw in capacity."

The Effects Of A Mandatory Early Shutdown Of Maine Yankee, Maine State Planning Office

Maine Collection

The Effects of a Mandatory Early Shutdown of Maine Yankee

Maine State Planning Office - Richard Silkman, Director (September 1987).

Contents: Introduction / Legal Issues / Economic Issues / Health and Environmental Issues / Conclusions / Appendices

Maine Yankee Shutdown Assessment: A Report To Governor Joseph E. Brennan, Maine State Planning Office

Maine Collection

Maine Yankee Shutdown Assessment: A Report to Governor Joseph E. Brennan

Maine State Planning Office, Maine Office of Energy Resources, Maine Public Advocate

Executive Department - May 1986

Contents: Legal Process / Decommissioning Constraints and Costs / Public and Economic Costs and Benefits / Apprendices

Development Of An Integrated Program Of Water Reuse In A Pulp And Paper Mill, Zafar M. Chaudhri

Masters Theses

No abstract provided.

The Economics Of Solar Water Heaters : A Guide For Evaluating The Cost-Effectiveness Of Active Solar Water Heating Systems In Maine, Maine Office Of Energy Resources

Maine Collection

The Economics of Solar Water Heaters : A Guide for Evaluating the Cost-Effectiveness of Active Solar Water Heating Systems in Maine

State of Maine, Executive Department, Office of Energy Resources,

Augusta, Maine (July, 1979).

Contents: Section I: Introduction / Section II: Economic Method: The Life Cycle Cost Analysis / Section III: Factors Affecting the Decision to Buy / Section IV: Explanation of the Tables / Table I - Table IIIA

An Annotated Bibliography Of Ocs Documents In Maine, Maine State Planning Office

Maine Collection

An Annotated Bibliography of OCS Documents in Maine

Outer Continental Shelf Memorandum 1

Compiled by Edward H. Shenton & Charles S. Colgan

Maine Coastal Program, Maine State Planning Office, Augusta, Maine, 1977.

Contents: 1. Introduction / 2. OCS - General / 3. OCS - Federal Regulations / 4. Economic Aspects / 5. Environmental Studies / 6. Oil Spills - Effects and Studies / 7. Onshore Effects / 8. The North Sea Experience / 9. Legal Aspects / 10. Petroleum Drilling Technology