Open Access. Powered by Scholars. Published by Universities.®
- Institution
-
- University of South Carolina (11)
- California Polytechnic State University, San Luis Obispo (9)
- Department of Primary Industries and Regional Development, Western Australia (9)
- Central Washington University (7)
- University of Dar es Salaam (6)
-
- Michigan Technological University (5)
- Association of Arab Universities (2)
- Linfield University (2)
- Louisiana State University (2)
- The University of Akron (2)
- University of Arkansas, Fayetteville (2)
- University of Louisville (2)
- University of Texas at Tyler (2)
- American University in Cairo (1)
- LSU New Orleans (1)
- Munster Technological University (1)
- Syracuse University (1)
- Universitas Indonesia (1)
- University of Alkafeel (1)
- University of Central Florida (1)
- University of Kentucky (1)
- University of Nebraska - Lincoln (1)
- University of Nevada, Las Vegas (1)
- University of New Mexico (1)
- University of Texas at Arlington (1)
- West Virginia University (1)
- Keyword
-
- Tractors (9)
- Performance (4)
- SOFC (4)
- Testing (4)
- Western Australia (4)
-
- Performance testing (3)
- Solid oxide fuel cells (3)
- Vehicle (3)
- Anode (2)
- Design (2)
- Electronic conductivity (2)
- Engineering (2)
- FEA (2)
- Fluid Power (2)
- Hydraulics (2)
- Microstructure (2)
- Oxygen reduction reaction (ORR) (2)
- Power (2)
- Redox stability (2)
- Solar (2)
- Stairs (2)
- Wind Turbine (2)
- 3D-Printing (1)
- A-site cation (1)
- ANSYS (1)
- ANTI VIRUSES (1)
- Abaqus (1)
- Accelerometer (1)
- Actuator (1)
- Adapt (1)
- Publication Year
- Publication
-
- Faculty Publications (13)
- Journal of the Department of Agriculture, Western Australia, Series 4 (9)
- All Undergraduate Projects (6)
- Tanzania Journal of Engineering and Technology (TJET) (6)
- Dissertations, Master's Theses and Master's Reports (5)
-
- Mechanical Engineering (5)
- Master's Theses (4)
- Electronic Theses and Dissertations (2)
- Graduate Theses and Dissertations (2)
- Mechanical Engineering Theses (2)
- Senior Theses (2)
- Williams Honors College, Honors Research Projects (2)
- 2025 Spring Honors Capstone Projects - Archive (1)
- Al-Bahir (1)
- All Master's Theses (1)
- Department of Mechanical and Materials Engineering: Dissertations, Theses, and Student Research (1)
- Future Engineering Journal (1)
- Graduate Theses, Dissertations, and Problem Reports (ETD) (1)
- Honors Undergraduate Theses (1)
- Journal of Engineering Research (1)
- Journal of Materials Exploration and Findings (1)
- LSU New Orleans Theses and Dissertations (1)
- Mechanical Engineering ETDs (1)
- Renée Crown University Honors Thesis Projects - All (1)
- Theses (1)
- Theses and Dissertations (1)
- Theses and Dissertations--Mechanical and Aerospace Engineering (1)
- UNLV Theses, Dissertations, Professional Papers, and Capstones (1)
- Publication Type
Articles 61 - 74 of 74
Full-Text Articles in Energy Systems
Socio-Economic Impacts Of Computer Viruses In Tanzania, M Victor
Socio-Economic Impacts Of Computer Viruses In Tanzania, M Victor
Tanzania Journal of Engineering and Technology (TJET)
This paper reports on a research project conducted with an objective of identifying and assessing various approaches used by different computer users (Management, System Administrators and end users) in Tanzania to combat computer viruses (CVs), and to assess users' awareness level on CVs. Specifically, the study aimed at assessing the awareness level on CVs to the Tanzanian business community; analyze the socio -economic impact caused by CVs in Tanzania and; assess existing methods, capacity and limitations on controlling CVs in Tanzania. Data was collected using both questionnaires and interview from financial institutions such as NBC and BOT, and telecommunications sector …
Review Of The Product Development Process And Information Flow In The Manufacturing Industry: Problems And A Possible Wav Forward, E Opiyo
Tanzania Journal of Engineering and Technology (TJET)
No abstract provided.
Effect Of Residual Thermal Stresses On Fracture Behavior And Mechanical Properties Of Al Sub 2 O Sub 3/Ni Cermets, Guo Jin Li, Da Ming Chen, Xiao Xian Huang, Jing Kun Guo
Effect Of Residual Thermal Stresses On Fracture Behavior And Mechanical Properties Of Al Sub 2 O Sub 3/Ni Cermets, Guo Jin Li, Da Ming Chen, Xiao Xian Huang, Jing Kun Guo
Faculty Publications
Effect of residual thermal stresses on fracture behavior and mechanical properties of Al2O3/Ni cermets was qualitatively explained by using theory on residual thermal stresses. When Ni particles are located within Al2O3 grains or Ni content is relatively low, tensile stresses are exerted at Al2O3-Al2O3 grain boundary. While fracturing, intergranular fracture is easily produced. When Ni particles are dispersed at Al2O3 grain boundary or Ni content is relatively high, compressive stresses are exerted at Al2O3-Al2O3grain boundary. …
Application Of Vibrational Techniques In Determination Of Dynamic Properties Of Agricultural Products-State Of The Arton Of Vibrational Techniques In Determination Of Dynamic Properties Of Agricultural Products-State Of The Art, Silas Kajuna
Tanzania Journal of Engineering and Technology (TJET)
Vibration is one of the techniques employed in the determination of dynamic properties of fruits and vegetables. It entails generation of a mechanical or acoustic vibrational signal which is propagated through the flesh of the agricultural material. A transducer is either attached or held close to the specimen to monitor the propagation of the signal through the specimen. The manner in which the signal is transmitted through the material is analyzed, and the dynamic properties of the specimen which relate to its firmness or its internal being are derived. The technique has been around for the past 30 years or …
Australian Tractor Test Report No. 41 : The Massey-Ferguson 135, G H. Vasey, F. T. Baillie
Australian Tractor Test Report No. 41 : The Massey-Ferguson 135, G H. Vasey, F. T. Baillie
Journal of the Department of Agriculture, Western Australia, Series 4
THE Massey-Ferguson MF-135 is a general purpose tractor of 31 drawbar horsepower. It has 14.9 x 24 pneumatic tyres, and a three-speed gear box with a ratio change which, in the standard model, gives six forward and two reverse gears.
The model tested was also fitted with the optional "Multipower" facility, which gives an "on-the-go" shift to a higher speed for each gear, thus providing 12 forward and four reverse gears.
Australian Tractor Tests : International A554d : Report On Test No. 36 (Farmers' Edition), G H. Vasey, W. F. Baillie
Australian Tractor Tests : International A554d : Report On Test No. 36 (Farmers' Edition), G H. Vasey, W. F. Baillie
Journal of the Department of Agriculture, Western Australia, Series 4
THIS Report is taken from the full Technical Report No. 36; results are shown here in briefer form: fuller explanations are added.
Values quoted may be rounded out to two instead of three significant figures; to this extent the values may differ slightly but not significantly from those shown in the Technical Report.
Australian Tractor Tests : Fordson Farm Major : Report On Test No. 33, G H. Vasey, W. F. Baillie
Australian Tractor Tests : Fordson Farm Major : Report On Test No. 33, G H. Vasey, W. F. Baillie
Journal of the Department of Agriculture, Western Australia, Series 4
THIS Report is taken from the full Technical Report No. 33 of this test; test results are shown here in briefer form: fuller explanations are added.
Values quoted may be rounded out to two instead of three significant figures; to this extent the values may differ slightly but not significantly from those shown in the Technical Report.
Graphs of belt test performance, shown in the Technical Report, are not shown here.
Australian Tractor Tests : Report On Test No. 32, G H. Vasey, W. F. Baillie
Australian Tractor Tests : Report On Test No. 32, G H. Vasey, W. F. Baillie
Journal of the Department of Agriculture, Western Australia, Series 4
THIS Report is taken from the full Technical Report No. 32 of this test: test results are shown here in briefer form: fuller explanations are added. Values quoted may be rounded out to two instead of three significant figures:
Australian Tractor Tests : Report On Test No. 34 : Fordson Power Major, G H. Vasey, W. F. Baillie
Australian Tractor Tests : Report On Test No. 34 : Fordson Power Major, G H. Vasey, W. F. Baillie
Journal of the Department of Agriculture, Western Australia, Series 4
THIS Report is taken from the full Technical Report No. 34 of this test; test results are shown here in briefer form: fuller explanations are added.
Values quoted may be rounded out to two instead of three significant figures; to this extent the values may differ slightly but not significantly from those shown in the Technical Report
Some values are taken from graphs shown in the Technical Report, which are not shown here.
Australian Tractor Tests : Zetor 50 Super : Report On Test No.35, G H. Vasey
Australian Tractor Tests : Zetor 50 Super : Report On Test No.35, G H. Vasey
Journal of the Department of Agriculture, Western Australia, Series 4
T H I S Report is taken from the full Technical Report No. 35; results are shown here in briefer form: fuller explanations are added. Values quoted may be rounded out to two instead of three significant figures.
Australian Spark Arrester Tests. Test No. Spa-5 : Caterpillar 3b-2655, W. F. Baillie, G. H. Vasey
Australian Spark Arrester Tests. Test No. Spa-5 : Caterpillar 3b-2655, W. F. Baillie, G. H. Vasey
Journal of the Department of Agriculture, Western Australia, Series 4
FORMAL tests on spark arresters are conducted by The Tractor Testing Committee* at the Testing Station, Werribee, on behalf of those companies concerned with tractors, engines or spark arresters who wish to have these equipments tested.
The arrester is tested on the engine for which it is specially designed or if this is not convenient (as in this instance) it is tested on an engine having the characteristics and power for which the spark arrester is intended.
Tractor Testing In Australia. Part 2, G H. Vasey, W. F. Baillie
Tractor Testing In Australia. Part 2, G H. Vasey, W. F. Baillie
Journal of the Department of Agriculture, Western Australia, Series 4
AUSTRALIAN test procedures, though differing: in some details, and in some ways going further and telling more about the tractor, conform in essentials to overseas standards.
The tests are in four main parts—
(a) the physical properties of the tractor;
(b) the power of the engine, and its stationary outlets—the belt and the p.t.o;
(c) the power on the drawbar when working on a formalised test surface or track;
(d) the reliability of the tractor when running under test, and its condition after the test.
Australian Tractor Tests : No. 31, G. H. Vasey, W. F. Baillie
Australian Tractor Tests : No. 31, G. H. Vasey, W. F. Baillie
Journal of the Department of Agriculture, Western Australia, Series 4
THIS Report is taken from the full Technical Report No. 31 of this test; test results are shown here in briefer form: fuller explanations are added. Values quoted may be rounded out to two instead of three significant figures; to this extent the values may differ slightly but not significantly from those shown in the Technical Report. Graphs of belt test performance, shown in the Technical Report, are not shown here.
The Design Of A Solar Powered Air Conditioning System For An Albuquerque Office Building, Kuo S. Lee
The Design Of A Solar Powered Air Conditioning System For An Albuquerque Office Building, Kuo S. Lee
Mechanical Engineering ETDs
The purpose of this investigation is to predict the performance of a solar powered jet refrigeration system for summer air conditioning, to measure the performance of the solar heat collector at the Bridgers and Paxton building in Albuquerque, and to design a Freon-12 ejector and generator for collection to that collector.