Computer-Aided Engineering and Design Commons^™

Computer-Aided Analysis And Design Of Rectangular Buried Tank Walls And Its Safety Factor Evaluation Based On Yield Line Analysis, Rakiya J. Fatoohi

Civil & Environmental Engineering Theses & Dissertations

This thesis presents the results of a study that determines the true safety factor of underground square reinforced concrete tank walls.

The walls are analyzed and designed by elastic method. The amount and distribution of the reinforcement was determined by use of the alternate design method (working stress) in compliance with all ACI code requirements. The wall's ultimate moment was computed by use of yield line theory assuming non-isotropic reinforcement. The ultimate value of the earth pressure was computed and compared with the elastic analysis and design values to give the true safety factor.

The results of this study indicate …

Structural Sensitivity Analysis On A Parallel Computer, Niu Kian Teck

Civil & Environmental Engineering Theses & Dissertations

Substructuring formulation using adjoint variable approach has been developed for design sensitivity analysis and optimization of large scale structures. In this study, the procedure for statics and sensitivity analysis are re-examined to propose a programming scheme which can be implemented either in a sequential or parallel environment. The computational times of the substructuring formulation using a single processor versus multi-processors are compared to see the effectiveness of the formulation in the concurrent computing environment.

The Cost Effectiveness Of System Response Between Mainframe And Micro Cadam, Dan Rae Teel

Graduate Research Papers

The purpose of this study is to show the cost effectiveness of system response between Mainframe and Micro CADAM.

Issues In The Design And Implementation Of Expert Systems, Clive L. Dym

All HMC Faculty Publications and Research

This article discusses the issues that arise in the design and implementation of expert systems. These issues include: task selection; the stages of development of expert system projects; knowledge acquisition; languages and tools; development and run-time environments; and organizational and institutional issues. The article closes with some speculation about the future development of expert systems.